参数资料
| 型号： | AD8609ARUZ-REEL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 4/16页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP GP R-R CMOS 14TSSOP |
| 标准包装： | 2,500 |
| 放大器类型： | 通用 |
| 电路数： | 4 |
| 输出类型： | 满摆幅 |
| 转换速率： | 0.1 V/µs |
| 增益带宽积： | 400kHz |
| 电流 - 输入偏压： | 0.2pA |
| 电压 - 输入偏移： | 12µV |
| 电流 - 电源： | 40µA |
| 电流 - 输出 / 通道： | 70mA |
| 电压 - 电源，单路/双路(±)： | 1.8 V ~ 5 V，±0.9 V ~ 2.5 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 14-TSSOP |
| 包装： | 带卷 (TR) |
AD8603/AD8607/AD8609
Rev. C | Page 12 of 16
APPLICATIONS
NO PHASE REVERSAL
The AD8603/AD8607/AD8609 do not exhibit phase inversion
even when the input voltage exceeds the maximum input
common-mode voltage. Phase reversal can cause permanent
damage to the amplifier, resulting in system lockups. The
AD8603/AD8607/AD8609 can handle voltages of up to 1 V
over the supply.
V
O
LT
A
G
E
(
1V/
D
IV)
TIME (4s/DIV)
VS = ±2.5V
VIN = 6V p-p
AV = 1
RL = 10k
VIN
VOUT
04
35
6-
0
41
Figure 41. No Phase Response
INPUT OVERVOLTAGE PROTECTION
If a voltage 1 V higher than the supplies is applied at either
input, the use of a limiting series resistor is recommended. If
both inputs are used, each one should be protected with a
series resistor.
To ensure good protection, the current should be limited to a
maximum of 5 mA. The value of the limiting resistor can be
determined from the following equation:
(VIN VS)/(RS + 200 Ω) ≤ 5 mA
DRIVING CAPACITIVE LOADS
The AD8603/AD8607/AD8609 are capable of driving large
capacitive loads without oscillating. Figure 42 shows the output
of the AD8603/AD8607/AD8609 in response to a 100 mV input
signal, with a 2 nF capacitive load.
Although it is configured in positive unity gain (the worst case),
the AD8603 shows less than 20% overshoot. Simple additional
circuitry can eliminate ringing and overshoot.
One technique is the snubber network, which consists of a
series RC and a resistive load (see Figure 43). With the snubber
in place, the AD8603/AD8607/AD8609 are capable of driving
capacitive loads of 2 nF with no ringing and less than 3%
overshoot.
The use of the snubber circuit is usually recommended for unity
gain configurations. Higher gain configurations help improve
the stability of the circuit. Figure 44 shows the same output
response with the snubber in place.
VS = ±0.9V
VIN = 100mV
CL = 2nF
RL = 10k
0
43
56
-04
2
Figure 42. Output Response to a 2 nF Capacitive Load, Without Snubber
04
35
6-
04
3
CS
47pF
VCC
VEE
RS
150
200mV
CL
V+
V–
–
+
Figure 43. Snubber Network
VSY = ±0.9V
VIN = 100mV
CL = 2nF
RL = 10k
RS = 150
CS = 470pF
0
435
6-
0
44
Figure 44. Output Response to a 2 nF Capacitive Load with Snubber
Optimum values for RS and CS are determined empirically;
Table 5 lists a few starting values.
Table 5. Optimum Values for the Snubber Network
CL (pF)
RS (Ω)
CS (pF)
100 to ~500
500
680
1500
100
330
1600 to ~2000
400
100
相关PDF资料 |
PDF描述 |
|---|---|
| AD628ARMZ-RL | IC AMP PGA DIFF PREC 8MSOP |
| NPPN122AFCN-RC | CONN RECEPT 2MM DUAL STR 24POS |
| AD628ARZ-RL | IC AMP PGA DIFF PREC 8SOIC |
| 37203-62A3-003PL | CONN SOCKET 2MM 3POS VERT PCB |
| EL5224IREZ-T7 | IC BUFFER LP 8-CH 12MHZ 24HTSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8609ARUZ-REEL1 | 制造商:AD 制造商全称:Analog Devices 功能描述:Precision Micropower, Low Noise CMOS, Rail-to-Rail Input/Output Operational Amplifiers |
| AD8609ARZ | 功能描述:IC OPAMP GP R-R CMOS QUAD 14SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:MicroAmplifier™ 放大器类型:通用 电路数:4 输出类型:- 转换速率:3.5 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:5pA 电压 - 输入偏移:1500µV 电流 - 电源:220µA 电流 - 输出 / 通道:60mA 电压 - 电源，单路/双路(±):4.5 V ~ 36 V，±2.25 V ~ 18 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:剪切带 (CT) 其它名称:296-29363-1 |
| AD8609ARZ | 制造商:Analog Devices 功能描述:OP AMP QUAD PRECISION RRI/O 8609 |
| AD8609ARZ1 | 制造商:AD 制造商全称:Analog Devices 功能描述:Precision Micropower, Low Noise CMOS, Rail-to-Rail Input/Output Operational Amplifiers |
| AD8609ARZ-REEL | 功能描述:IC OPAMP GP R-R CMOS QUAD 14SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:通用 电路数:2 输出类型:满摆幅 转换速率:1.8 V/µs 增益带宽积:6.5MHz -3db带宽:4.5MHz 电流 - 输入偏压:5nA 电压 - 输入偏移:100µV 电流 - 电源:65µA 电流 - 输出 / 通道:35mA 电压 - 电源，单路/双路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽） 供应商设备封装:10-MSOP 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。