参数资料
| 型号： | AD8610AR |
| 厂商： | Analog Devices Inc |
| 文件页数： | 7/24页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP JFET 25MHZ PREC 8SOIC |
| 设计资源： | Precision, AC Reference Signal Attenuator Using AD5546/56 Multiplying DAC (CN0025) |
| 标准包装： | 98 |
| 放大器类型： | J-FET |
| 电路数： | 1 |
| 转换速率： | 60 V/µs |
| 增益带宽积： | 25MHz |
| 电流 - 输入偏压： | 3pA |
| 电压 - 输入偏移： | 85µV |
| 电流 - 电源： | 3mA |
| 电流 - 输出 / 通道： | 45mA |
| 电压 - 电源，单路/双路(±)： | ±5 V ~ 13 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SO |
| 包装： | 管件 |
AD8610/AD8620
Rev. F | Page 15 of 24
Slew Rate (Unity Gain Inverting vs. Noninverting)
Amplifiers generally have a faster slew rate in an inverting unity
gain configuration due to the absence of the differential input
of the AD8610/AD8620 configured in a unity gain of –1 compared
to the OPA627. The AD8610/AD8620 slew rate is more symme-
trical, and both the positive and negative transitions are much
cleaner than in the OPA627.
02
73
0-
0
49
V
O
L
T
A
G
E
(
5V/
D
IV)
TIME (400ns/DIV)
VS = ±13V
RL = 2k
G= –1
SR = 54V/s
Figure 49. +Slew Rate of AD8610/AD8620 in Unity Gain of –1
02
73
0-
0
50
VO
L
T
A
G
E
(
5V/
D
IV)
TIME (400ns/DIV)
VS = ±13V
RL = 2k
G= –1
SR = 42.1V/s
Figure 50. +Slew Rate of OPA627 in Unity Gain of –1
02
730
-05
1
VO
L
T
A
G
E
(
5V/
D
IV
)
TIME (400ns/DIV)
VS = ±13V
RL = 2k
G= –1
SR = 54V/s
Figure 51. –Slew Rate of AD8610/AD8620 in Unity Gain of –1
02
73
0-
0
52
VO
L
T
A
G
E
(
5V/
D
IV)
TIME (400ns/DIV)
VS = ±13V
RL = 2k
G= –1
SR = 56V/s
Figure 52. –Slew Rate of OPA627 in Unity Gain of –1
The AD8610/AD8620 have a very fast slew rate of 60 V/μs even
when configured in a noninverting gain of +1. This is the toughest
condition to impose on any amplifier because the input common-
mode capacitance of the amplifier generally makes its SR appear
worse. The slew rate of an amplifier varies according to the voltage
difference between its two inputs. To observe the maximum SR,
a voltage difference of about 2 V between the inputs must be
ensured. This is required for virtually any JFET op amp so that
one side of the op amp input circuit is completely off, thus maxi-
mizing the current available to charge and discharge the internal
compensation capacitance. Lower differential drive voltages
produce lower slew rate readings. A JFET input op amp with a
slew rate of 60 V/μs at unity gain with VIN = 10 V may slew at
20 V/μs if it is operated at a gain of +100 with VIN = 100 mV.
相关PDF资料 |
PDF描述 |
|---|---|
| MCP6244-E/P | IC OPAMP 1.8V QUAD R-R 14DIP |
| 7047.1350 | FUSE 30A 250VAC 10X38 SLOW |
| 0090.0010 | FUSE FAST 10A 250V MIDGET |
| LT1359IS#PBF | IC OP-AMP HISPD 25MHZ QD 16SOIC |
| 95228-301LF | CONN HEADER 34POS .100" STR GOLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8610ARM | 制造商:AD 制造商全称:Analog Devices 功能描述:Precision Very Low Noise Low Input Bias Current Wide Bandwidth JFET Operational Amplifiers |
| AD8610ARM-R2 | 制造商:Analog Devices 功能描述:OP Amp Single GP ±13V 8-Pin MSOP T/R |
| AD8610ARM-REEL | 功能描述:IC OPAMP JFET 25MHZ PREC 8MSOP RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:1 输出类型:满摆幅 转换速率:0.11 V/µs 增益带宽积:350kHz -3db带宽:- 电流 - 输入偏压:4nA 电压 - 输入偏移:20µV 电流 - 电源:260µA 电流 - 输出 / 通道:20mA 电压 - 电源，单路/双路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SO 包装:带卷 (TR) |
| AD8610ARM-REEL9 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| AD8610ARMZ | 制造商:Analog Devices 功能描述:OP AMP JFET PREC LN WB 8MSOP 制造商:Analog Devices 功能描述:OP AMP, JFET, PREC, LN, WB, 8MSOP 制造商:Analog Devices 功能描述:OP AMP, JFET, PREC, LN, WB, 8MSOP; Op Amp Type:Low Noise; No. of Amplifiers:1; Slew Rate:50V/s; Supply Voltage Range: 5V to 13V; Amplifier Case Style:MSOP; No. of Pins:8; Bandwidth:25MHz; Operating Temperature Min:-40C; ;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。