参数资料
| 型号： | AD8626ARMZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 5/20页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP JFET 5MHZ DUAL LP 8MSOP |
| 标准包装： | 50 |
| 放大器类型： | J-FET |
| 电路数： | 2 |
| 输出类型： | 满摆幅 |
| 转换速率： | 5 V/µs |
| 增益带宽积： | 5MHz |
| 电流 - 输入偏压： | 0.25pA |
| 电压 - 输入偏移： | 350µV |
| 电流 - 电源： | 710µA |
| 电流 - 输出 / 通道： | 15mA |
| 电压 - 电源，单路/双路(±)： | 5 V ~ 26 V，±2.5 V ~ 13 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-MSOP |
| 包装： | 管件 |
Data Sheet
AD8625/AD8626/AD8627
Rev. F | Page 13 of 20
APPLICATIONS INFORMATION
The AD862x is one of the smallest and most economical
JFETs offered. It has true single-supply capability and has
an input voltage range that extends below the negative rail,
allowing the part to accommodate input signals below ground.
The rail-to-rail output of the AD862x provides the maximum
dynamic range in many applications. To provide a low offset,
low noise, high impedance input stage, the AD862x uses
n-channel JFETs. The input common-mode voltage extends
from 0.2 V below –VS to 2 V below +VS. Driving the input of
the amplifier, configured in the unity gain buffer, closer than
2 V to the positive rail causes an increase in common-mode
voltage error, as illustrated in Figure 15, and a loss of amplifier
bandwidth. This loss of bandwidth causes the rounding of the
output waveforms shown in Figure 39 and Figure 40, which
have inputs that are 1 V and 0 V from +VS, respectively.
The AD862x does not experience phase reversal with input
signals close to the positive rail, as shown in Figure 29. For
input voltages greater than +VSY, a resistor in series with the
AD862x’s noninverting input prevents phase reversal at the
expense of greater input voltage noise. This current-limiting
resistor should also be used if there is a possibility of the input
voltage exceeding the positive supply by more than 300 mV, or
if an input voltage is applied to the AD862x when ±VSY = 0.
Either of these conditions damages the amplifier if the
condition exists for more than 10 seconds. A 10 k resistor
allows the amplifier to withstand up to 10 V of continuous
overvoltage, while increasing the input voltage noise by a
negligible amount.
TIME (2
s/DIV)
03023-038
VOLTAGE
(2V/DIV)
INPUT
OUTPUT
VSY = 5V
4V
0V
Figure 39. Unity Gain Follower Response to 0 V to 4 V Step
TIME (2
s/DIV)
03023-039
VOLTAGE
(2V/DIV)
INPUT
OUTPUT
VSY = 5V
4V
0V
5V
0V
Figure 40. Unity Gain Follower Response to 0 V to 5 V Step
相关PDF资料 |
PDF描述 |
|---|---|
| 95066-216HLF | CONN BERGSTIK II DR STRAIGHT RET |
| TSW-112-08-T-S | CONN HEADER 12POS .100" SNGL TIN |
| 2036-47-A | GAS DISCHARGE TUBE MINI 3 POLE |
| LTC2053IDD | IC AMP INST 0-DRFT R-R I/O 8-DFN |
| 2-320665-1 | CONN SPADE TONGUE 22-16AWG #6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8626ARMZ-R2 | 功能描述:IC OPAMP JFET 5MHZ DUAL LP 8MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:1 输出类型:满摆幅 转换速率:0.11 V/µs 增益带宽积:350kHz -3db带宽:- 电流 - 输入偏压:4nA 电压 - 输入偏移:20µV 电流 - 电源:260µA 电流 - 输出 / 通道:20mA 电压 - 电源，单路/双路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SO 包装:带卷 (TR) |
| AD8626ARMZ-REEL | 功能描述:IC OPAMP JFET 5MHZ DUAL LP 8MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:100 系列:- 放大器类型:通用 电路数:1 输出类型:- 转换速率:0.2 V/µs 增益带宽积:- -3db带宽:- 电流 - 输入偏压:100pA 电压 - 输入偏移:30µV 电流 - 电源:380µA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):±2 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SO 包装:管件 |
| AD8626AR-REEL | 制造商:Analog Devices 功能描述:OP Amp Dual GP R-R O/P |
| AD8626ARREEL7 | 制造商:ANALOG DEVICES INC 功能描述: |
| AD8626AR-REEL7 | 制造商:Analog Devices 功能描述:OP Amp Dual GP R-R O/P 制造商:Analog Devices 功能描述:OP Amp Dual GP R-R O/P ±13V/26V 8-Pin SOIC N T/R |
发布紧急采购，3分钟左右您将得到回复。