参数资料
| 型号： | AD8657ARMZ-R7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 11/24页 |
| 文件大小： | 0K |
| 描述： | IC OP AMP RRIO 200KHZ 8MSOP |
| 标准包装： | 1,000 |
| 放大器类型： | 通用 |
| 电路数： | 2 |
| 输出类型： | 满摆幅 |
| 转换速率： | 0.07 V/µs |
| 增益带宽积： | 200kHz |
| 电流 - 输入偏压： | 5pA |
| 电压 - 输入偏移： | 350µV |
| 电流 - 电源： | 18µA |
| 电流 - 输出 / 通道： | 12mA |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 18 V，±1.35 V ~ 9 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-MSOP |
| 包装： | 带卷 (TR) |
AD8657
Rev. A | Page 19 of 24
COMPARATOR OPERATION
Op amps are designed to operate in a closed-loop configuration
with feedback from its output to its inverting input. Figure 67
shows the AD8657 configured as a voltage follower with an input
voltage that is always kept at midpoint of the power supplies.
The same configuration is applied to the unused channel. A1 and
A2 indicate the placement of ammeters to measure supply current.
ISY+ refers to the current flowing from the upper supply rail to
the op amp, and ISY refers to the current flowing from the op
amp to the lower supply rail. As shown in Figure 68, as expected,
in normal operating condition, the total current flowing into the
op amp is equivalent to the total current flowing out of the op amp,
where, ISY+ = ISY = 36 μA for the dual AD8657 at VSY = 18 V.
AD8657
1/2
A1
100k
100k
ISY+
+VSY
VOUT
–VSY
ISY–
A2
08804-
066
Figure 67. Voltage Follower
0
5
10
15
20
25
30
35
40
0
2
4
6
8
10
12
14
16
18
I SY
P
E
R
DUA
L
A
MPL
IF
IER
(
A
)
VSY (V)
ISY–
ISY+
08804-
067
Figure 68. Supply Current vs. Supply Voltage (Voltage Follower)
In contrast to op amps, comparators are designed to work in an
open-loop configuration and to drive logic circuits. Although
op amps are different from comparators, occasionally an unused
section of a dual op amp is used as a comparator to save board
space and cost; however, this is not recommended.
Figure 69 and Figure 70 show the AD8657 configured as a com-
parator, with 100 k resistors in series with the input pins. Any
unused channels are configured as buffers with the input voltage
kept at the midpoint of the power supplies. The AD8657 has input
devices that are protected from large differential input voltages
by Diode D1 and Diode D2 (refer to Figure 63). These diodes
consist of substrate PNP bipolar transistors, and conduct whenever
the differential input voltage exceeds approximately 600 mV; how-
ever, these diodes also allow a current path from the input to the
lower supply rail, thus resulting in an increase in the total supply
current of the system. As shown in Figure 71, both configurations
yield the same result. At 18 V of power supply, ISY+ remains at
36 μA per dual amplifier, but ISY increases to 140 μA in magni-
tude per dual amplifier.
AD8657
1/2
A1
100k
100k
ISY+
+VSY
VOUT
–VSY
ISY–
A2
08804-
068
Figure 69. Comparator A
AD8657
1/2
A1
100k
100k
ISY+
+VSY
VOUT
–VSY
ISY–
A2
08804-
069
Figure 70. Comparator B
0
20
40
60
80
100
120
140
160
0
2
4
6
8
10
12
14
16
18
I SY
p
E
R
DUA
L
A
MPL
IF
IER
(
A
)
VSY (V)
ISY–
ISY+
08804-
070
Figure 71. Supply Current vs. Supply Voltage (AD8657 as a Comparator)
Note that 100 k resistors are used in series with the input of
the op amp. If smaller resistor values are used, the supply current of
the system increases much more. For more details on op amps as
comparators, refer to the AN-849 Application Note Using Op
Amps as Comparators.
相关PDF资料 |
PDF描述 |
|---|---|
| AD8659ARZ-R7 | IC OPAMP RRIO 18V CMOS 14SOIC |
| AD8662ARMZ | IC OPAMP GP R-R CMOS 4MHZ 8MSOP |
| AD8663ACPZ-R2 | IC OPAMP GP R-R CMOS LN 8LFCSP |
| AD8666ARZ | IC OPAMP GP R-R 4MHZ DUAL 8SOIC |
| AD8667ARZ-REEL7 | IC OPAMP GP R-R CMOS DUAL 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8657ARMZ-RL | 功能描述:IC OP AMP RRIO 200KHZ 8MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:1 输出类型:满摆幅 转换速率:0.11 V/µs 增益带宽积:350kHz -3db带宽:- 电流 - 输入偏压:4nA 电压 - 输入偏移:20µV 电流 - 电源:260µA 电流 - 输出 / 通道:20mA 电压 - 电源，单路/双路(±):2.7 V ~ 36 V，±1.35 V ~ 18 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SO 包装:带卷 (TR) |
| AD8659ACPZ-R7 | 功能描述:IC OPAMP RRIO 18V CMOS 16LFCSP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1,000 系列:- 放大器类型:电压反馈 电路数:4 输出类型:满摆幅 转换速率:33 V/µs 增益带宽积:20MHz -3db带宽:30MHz 电流 - 输入偏压:2nA 电压 - 输入偏移:3000µV 电流 - 电源:2.5mA 电流 - 输出 / 通道:30mA 电压 - 电源，单路/双路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:带卷 (TR) |
| AD8659ACPZ-RL | 功能描述:IC OPAMP RRIO 18V CMOS 16LFCSP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1,000 系列:- 放大器类型:电压反馈 电路数:4 输出类型:满摆幅 转换速率:33 V/µs 增益带宽积:20MHz -3db带宽:30MHz 电流 - 输入偏压:2nA 电压 - 输入偏移:3000µV 电流 - 电源:2.5mA 电流 - 输出 / 通道:30mA 电压 - 电源，单路/双路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:带卷 (TR) |
| AD8659ARZ | 功能描述:IC OPAMP RRIO 18V CMOS 14SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.028 V/µs 增益带宽积:105kHz -3db带宽:- 电流 - 输入偏压:3nA 电压 - 输入偏移:100µV 电流 - 电源:3.3µA 电流 - 输出 / 通道:12mA 电压 - 电源，单路/双路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:剪切带 (CT) 其它名称:OP481GRUZ-REELCT |
| AD8659ARZ_PROMO | 制造商:Analog Devices 功能描述:OP AMP QUAD 18V RRIO 230KH |
发布紧急采购，3分钟左右您将得到回复。