- 您现在的位置：买卖IC网 > PDF目录2063 > ADA4412-3ARQZ-R7 (Analog Devices Inc)IC FILTER VID RGB/HD/SD 20QSOP PDF资料下载
参数资料
| 型号： | ADA4412-3ARQZ-R7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 3/16页 |
| 文件大小： | 0K |
| 描述： | IC FILTER VID RGB/HD/SD 20QSOP |
| 标准包装： | 1,000 |
| 类型： | 视频滤波器 |
| 应用： | 机顶盒，视频播放器 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-SSOP（0.154"，3.90mm 宽） |
| 供应商设备封装： | 20-QSOP |
| 包装： | 带卷 (TR) |
ADA4412-3
Rev. 0 | Page 11 of 16
05
528
-01
8
DUAL SUPPLY
0.1
μF
LEVEL1
9.53k
Ω
1k
Ω
9.53k
Ω
+5V
–5V
0.1
μF
LEVEL2
9.53k
Ω
1k
Ω
9.53k
Ω
+5V
–5V
SINGLE SUPPLY
0.1
μF
LEVEL1
1k
Ω
9.09k
Ω
+5V
0.1
μF
LEVEL2
1k
Ω
9.09k
Ω
+5V
Figure 16. Generating Fully Adjustable Output Offsets
055
28-
01
9
0.1
μF
LEVEL1
634
Ω
10k
Ω
+5V
DNP
LEVEL2
0
Ω
DNP
+5V
Figure 17. Flexible Circuits to Set the LEVEL1 and LEVEL2 Inputs to
Obtain a 600 mV Output Offset on a Single Supply
INPUT AND OUTPUT COUPLING
Inputs to the ADA4412-3 are normally dc-coupled. Ac coupling
the inputs is not recommended; however, if ac coupling is
necessary, suitable circuitry must be provided following the ac
coupling element to provide proper dc level and bias currents at
the ADA4412-3 input stages. The ADA4412-3 outputs can be
either ac- or dc-coupled.
When driving single ac-coupled loads in standard 75 Ω video
distribution systems, 220 μF coupling capacitors are
recommended for use on all but the chrominance signal output.
Since the chrominance signal is a narrow-band modulated
carrier, it has no low frequency content and can therefore be
coupled with a 0.1 μF capacitor.
There are two ac coupling options when driving two loads from
one output. One simply uses the same value capacitor on the
second load, while the other is to use a common coupling
capacitor that is at least twice the value used for the single load
When driving two parallel 150 Ω loads (75 Ω effective load),
the 3 dB bandwidth of the filters typically varies from that of
the filters with a single 150 Ω load. For the 9 MHz and 18 MHz
filters, the typical variation is within ±1.0%; for the 36 MHz
filters, the typical variation is within ±2.5%.
05
52
8-
02
0
75
Ω
ADA4412-3
75
Ω
220
μF
220
μF
75
Ω
75
Ω
75
Ω
CABLE
75
Ω
CABLE
Figure 18. Driving Two AC-Coupled Loads with Two Coupling Capacitors
05
528
-0
21
75
Ω
75
Ω
75
Ω
75
Ω
470
μF
75
Ω
CABLE
75
Ω
CABLE
ADA4412-3
Figure 19. Driving Two AC-Coupled Loads with One Common Coupling Capacitor
PRINTED CIRCUIT BOARD LAYOUT
As with all high speed applications, attention to printed
circuit board layout is of paramount importance. Standard high
speed layout practices should be adhered to when designing
with the ADA4412-3. A solid ground plane is recommended,
and surface-mount, ceramic power supply decoupling
capacitors should be placed as close as possible to the supply
pins. All of the ADA4412-3 GND pins should be connected to
the ground plane with traces that are as short as possible.
Controlled impedance traces of the shortest length possible
should be used to connect to the signal I/O pins and should not
pass over any voids in the ground plane. A 75 Ω impedance
level is typically used in video applications. All signal outputs of
the ADA4412-3 should include series termination resistors
when driving transmission lines.
When the ADA4412-3 receives its inputs from a device
with current outputs, the required load resistor value for
the output current is often different from the characteristic
impedance of the signal traces. In this case, if the interconnec-
tions are sufficiently short (<< 0.1 wavelength), the trace does
not have to be terminated in its characteristic impedance.
Traces of 75 Ω can be used in this instance, provided their
lengths are an inch or two at the most. This is easily achieved
because the ADA4412-3 and the device feeding it are usually
adjacent to each other, and connections can be made that are
less than one inch in length.
VIDEO ENCODER RECONSTRUCTION FILTER
The ADA4412-3 is easily applied as a reconstruction filter at the
DAC outputs of a video encoder. Figure 20 illustrates how to use
the ADA4412-3 in this type of application with an ADV7322 video
encoder in a single-supply application with ac-coupled outputs.
相关PDF资料 |
PDF描述 |
|---|---|
| ADA4417-3ARMZ | IC VIDEO FILTER TRPL HD 10-MSOP |
| ADA4420-6ARQZ-R7 | IC FILTER VIDEO 6CH HD/SD 16QSOP |
| ADA4430-1YKSZ-RL | IC FILTER VIDEO ULTRA LP SC70-6 |
| ADA4431-1YCPZ-R2 | IC SD VIDEO FILTER ULP 16LFCSP |
| ADA4432-1BRJZ-R7 | IC SD VIDEO FILTER AMP SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADA4412-3ARQZ-RL | 功能描述:IC FILTER VID RGB/HD/SD 20QSOP RoHS:是 类别:集成电路 (IC) >> 线性 - 视频处理 系列:- 产品变化通告:Product Discontinuation 07/Mar/2011 标准包装:3,000 系列:OMNITUNE™ 类型:调谐器 应用:移动电话，手机，视频显示器 安装类型:表面贴装 封装/外壳:65-WFBGA 供应商设备封装:PG-WFSGA-65 包装:带卷 (TR) 其它名称:SP000365064 |
| ADA4417-3 | 制造商:AD 制造商全称:Analog Devices 功能描述:Integrated Triple Video Filter for High Definition Video |
| ADA4417-3ARMZ | 功能描述:IC VIDEO FILTER TRPL HD 10-MSOP RoHS:是 类别:集成电路 (IC) >> 线性 - 视频处理 系列:- 产品变化通告:Product Discontinuation 07/Mar/2011 标准包装:3,000 系列:OMNITUNE™ 类型:调谐器 应用:移动电话，手机，视频显示器 安装类型:表面贴装 封装/外壳:65-WFBGA 供应商设备封装:PG-WFSGA-65 包装:带卷 (TR) 其它名称:SP000365064 |
| ADA4417-3ARMZ-R7 | 功能描述:IC VIDEO FILTER TRPL HD 10-MSOP RoHS:是 类别:集成电路 (IC) >> 线性 - 视频处理 系列:- 产品变化通告:Product Discontinuation 07/Mar/2011 标准包装:3,000 系列:OMNITUNE™ 类型:调谐器 应用:移动电话，手机，视频显示器 安装类型:表面贴装 封装/外壳:65-WFBGA 供应商设备封装:PG-WFSGA-65 包装:带卷 (TR) 其它名称:SP000365064 |
| ADA4417-3ARMZ-RL | 功能描述:IC VIDEO FILTER TRPL HD 10-MSOP RoHS:是 类别:集成电路 (IC) >> 线性 - 视频处理 系列:- 产品变化通告:Product Discontinuation 07/Mar/2011 标准包装:3,000 系列:OMNITUNE™ 类型:调谐器 应用:移动电话，手机，视频显示器 安装类型:表面贴装 封装/外壳:65-WFBGA 供应商设备封装:PG-WFSGA-65 包装:带卷 (TR) 其它名称:SP000365064 |
发布紧急采购，3分钟左右您将得到回复。