- 您现在的位置：买卖IC网 > PDF目录5925 > ADA4817-1ARDZ-RL (Analog Devices Inc)IC OPAMP VF 410MHZ LN 40MA 8SOIC PDF资料下载
参数资料
| 型号： | ADA4817-1ARDZ-RL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 8/28页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP VF 410MHZ LN 40MA 8SOIC |
| 标准包装： | 2,500 |
| 系列： | FastFET™ |
| 放大器类型： | 电压反馈 |
| 电路数： | 1 |
| 转换速率： | 870 V/µs |
| 增益带宽积： | 410MHz |
| -3db带宽： | 1.05GHz |
| 电流 - 输入偏压： | 2pA |
| 电压 - 输入偏移： | 400µV |
| 电流 - 电源： | 19mA |
| 电流 - 输出 / 通道： | 40mA |
| 电压 - 电源，单路/双路(±)： | 5 V ~ 10 V，±2.5 V ~ 5 V |
| 工作温度： | -40°C ~ 105°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm Width）裸露焊盘 |
| 供应商设备封装： | 8-SOIC-EP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
ADA4817-1/ADA4817-2
Data Sheet
Rev. B | Page 16 of 28
Table 8. Power-Down Voltage Control
PD Pin
±5 V
+3 V, 2 V
Not active
>4 V
>2 V
Active
<2 V
<0 V
CAPACITIVE FEEDBACK
Due to package variations and pin-to-pin parasitics between the
single and the dual models, the ADA4817-2 has a little more
peaking then the ADA4817-1, especially at a gain of 2. The best
way to tame the peaking is to place a feedback capacitor across
the feedback resistor. Figure 46 shows the small signal frequency
response of the ADA4817-2 at a gain of 2 vs. CF. At first, no CF
was used to show the peaking, but then two other values of
0.5 pF and 1 pF were used to show how to reduce the peaking or
even eliminate it. As shown in Figure 46, if the power consumption
is a factor in the system, then using a larger feedback capacitor
is acceptable as long as a feedback capacitor is used across it to
control the peaking. However, if power consumption is not an
issue, then a lower value feedback resistor, such as 200 , would
not require any additional feedback capacitance to maintain
flatness and lower peaking.
9
6
3
0
–3
–6
–9
1M
10M
100M
1G
10G
C
LOS
E
D
-LOOP
GA
IN
(
dB
)
FREQUENCY (Hz)
07756-
049
RF = 348Ω
G = 2
VS = 10V
VOUT = 100mV p-p
RL = 100Ω
CF = 1pF
CF = 0.5pF
NO CF
Figure 46. Small Signal Frequency Response vs. Feedback Capacitor
(ADA4817-2)
HIGHER FREQUENCY ATTENUATION
There is another package variation problem between the SOIC
and the LFCSP package. The SOIC package shows approximately
1 dB to 1.5 dB of additional peaking at a gain of 1. This is due to
the parasitic in the SOIC package, which is not recommended
for very high frequency parts that exceed 1 GHz. A good approach
to reducing the peaking is to place a resistor, RS, in series with
the noninverting input. This creates a first-order pole formed
by RS and CIN, the common-mode input capacitance.
Figure 47 shows the higher frequency attenuation, which
reduces the peaking but also reduces the 3 dB bandwidth.
–9
–6
–3
0
3
6
1M
10M
100M
1G
10G
C
LOS
E
D
-LOOP
GA
IN
(
dB
)
FREQUENCY (Hz)
RS = 100
RS = 75
RS = 50
RS = 0
07756-
247
RL = 100Ω
VS = ±5V
VOUT = 0.1V p-p
G = 1
Figure 47. Small Signal Frequency Response for Various RS (SOIC)
As shown in Figure 47, the peaking dropped by almost 2 dB
when RS = 0 to RS = 100 , and in return, the 3 dB bandwidth
dropped from 1 GHz to 700 MHz. To maintain the 3 dB
bandwidth and to reduce peaking, an RLC circuit is recommended
L
10nH
R
120
C
2pF
07756-
248
Figure 48. RLC Circuit
The R in parallel to the series LC forms a notch that can be
shaped to compensate for the peaking produced by the amplifier.
The result is a smooth 1 GHz 3 dB bandwidth, 250 MHz 0.1 dB
flatness, and less than 1 dB of peaking. This circuit should be
placed in the path of the noninverting input when the ADA4817-x
is used at a gain of 1. The RLC values may need tweaking
depending on the source impedance and the flatness and band-
width required. Figure 49 shows the frequency response after the
RLC circuit is in place.
–9
–6
–3
0
3
6
1M
10M
100M
1G
10G
C
LOS
E
D
-LOOP
GA
IN
(
dB
)
FREQUENCY (Hz)
RLC
NO RLC
07756-
249
RL = 100Ω
VS = 10V
VOUT = 100mV p-p
G = 1
Figure 49. Frequency Response with RLC Circuit
相关PDF资料 |
PDF描述 |
|---|---|
| 3413.0123.22 | FUSE 4A 32V FAST 1206 SMD |
| OP284FSZ-REEL | IC OPAMP GP R-R 4.25MHZ LN 8SOIC |
| ADA4084-2ARZ-R7 | IC OPAMP GP RRIO 10MHZ DL 8SOIC |
| 3413.0119.22 | FUSE 2A 32V FAST 1206 SMD |
| LT1396CDD#PBF | IC AMP CURRNT FEEDBCK DUAL 8DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADA4817-2 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Noise, 1 GHz FastFET Op Amps |
| ADA4817-2ACP-EBZ | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Noise, 1 GHz FastFET Op Amps |
| ADA4817-2ACPZ-R2 | 制造商:Analog Devices 功能描述:OP Amp Dual Volt Fdbk 制造商:Analog Devices 功能描述:OP AMP DUAL VOLT FDBK 5V/10V 16LFCSP EP - Tape and Reel 制造商:Analog Devices 功能描述:OP-AMP FET DUAL 1GHZ 16LFCSP 制造商:Analog Devices 功能描述:OP-AMP, FET, DUAL, 1GHZ, 16LFCSP 制造商:Analog Devices 功能描述:OP-AMP, FET, DUAL, 1GHZ, 16LFCSP; Op Amp Type:Low Noise; No. of Amplifiers:2; Slew Rate:870V/s; Supply Voltage Range:5V to 10V; Amplifier Case Style:LFCSP; No. of Pins:16; Bandwidth:1.05GHz; Operating Temperature Min:-40C; ;RoHS Compliant: Yes |
| ADA4817-2ACPZ-R2 | 制造商:Analog Devices 功能描述:Operational Amplifier IC |
| ADA4817-2ACPZ-R7 | 功能描述:IC OPAMP VF 410MHZ DUAL 16LFCSP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:FastFET™ 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源，单路/双路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
发布紧急采购，3分钟左右您将得到回复。