- 您现在的位置：买卖IC网 > PDF目录20640 > ADE7751ARSZ (Analog Devices Inc)IC ENERGY METERING 1PHASE 24SSOP PDF资料下载
参数资料
| 型号： | ADE7751ARSZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 12/16页 |
| 文件大小： | 0K |
| 描述： | IC ENERGY METERING 1PHASE 24SSOP |
| 标准包装： | 59 |
| 输入阻抗： | 390 千欧 |
| 测量误差： | 0.1% |
| 电压 - 高输入/输出： | 2.4V |
| 电压 - 低输入/输出： | 0.8V |
| 电流 - 电源： | 3mA |
| 电源电压： | 4.75 V ~ 5.25 V |
| 测量仪表类型： | 单相 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 24-SSOP |
| 包装： | 管件 |
| 配用： | EVAL-ADE7751ZEB-ND - BOARD EVALUATION FOR ADE7751 |
ADE7751
Figure 7 shows two typical connections for Channel V2. The first
option uses a PT (potential transformer) to provide complete isola-
tion from the mains voltage. In the second option, the ADE7751
is biased around the neutral wire and a resistor divider is used to
provide a voltage signal that is proportional to the line voltage.
Adjusting the ratio of Ra and Rb is also a convenient way of
carrying out a gain calibration on the meter.
HPF and Offset Effects
Figure 9 shows the effect of offsets on the real power calculation. As
shown in Figure 9, an offset on Channel 1 and Channel 2 will
contribute a dc component after multiplication. Since this dc
component is extracted by the LPF and used to generate the real
power information, the offsets will have contributed a constant
error to the real power calculation. This problem is easily avoided by
enabling the HPF (i.e., pin AC/ DC is set logic high) in Channel 1.
CT
660mV
Rf
Cf
V2P
V2N
By removing the offset from at least one channel, no error component
can be generated at dc by the multiplication. Error terms at cos( ω t)
are removed by the LPF and the digital-to-frequency conversion—
Rf
see Digital-to-Frequency Conversion section.
PHASE NEUTRAL
AGND
Cf
( V cos( ω t ) + V OS ) × ( I × cos( ω t ) + I OS ) =
Ra
Cf
V × I
2
+ V OS × I OS + V OS × I × cos( ω t )
Rb
VR
660mV
V2P
+ V × I OS × cos( ω t ) +
V × I
2
× cos( 2 ω t )
Rf
V2N
PHASE NEUTRAL
NOTE
Ra
Rf;
Cf
Rb + VR = R f
DC COMPONENT (INCLUDING ERROR TERM)
Figure 7. Typical Connections for Channel 2
V OS
I OS
IS EXTRACTED BY THE LPF FOR REAL
POWER CALCULATION
POWER SUPPLY MONITOR
The ADE7751 contains an on-chip power supply monitor. The
V
2
I
analog supply (AV DD ) is continuously monitored by the ADE7751.
If the supply is less than 4 V ± 5%, the ADE7751 will be reset.
This is useful to ensure correct device start up at power-up and
power-down. The power supply monitor has built-in hysteresis
0
I OS
V OS
V
I
2
and filtering. This gives a high degree of immunity to false
triggering due to noisy supplies.
As can be seen in Figure 8, the trigger level is nominally set at 4 V.
The tolerance on this trigger level is about ± 5%. The power supply
and decoupling for the part should be such that the ripple at AV DD
does not exceed 5 V ± 5% as specified for normal operation.
AV DD
5V
4V
FREQUENCY – RAD/S
Figure 9. Effect of Channel Offsets on the
Real Power Calculation
The HPF in Channel 1 has an associated phase response that is
compensated for on-chip. The phase compensation is activated
when the HPF is enabled and is disabled when the HPF is not
activated. Figures 10 and 11 show the phase error between chan-
nels with the compensation network activated. The ADE7751
is phase compensated up to 1 kHz as shown. This will ensure
correct active harmonic power calculation even at low-power factors.
0.30
0.25
0V
TIME
0.20
INTERNAL
RESET
RESET
ACTIVE
RESET
0.15
0.10
0.05
Figure 8. On-Chip Power Supply Monitor
0
–0.05
–0.10
0
100
200
300
400 500 600 700
800
900 1000
FREQUENCY – Hz
Figure 10. Phase Error Between Channels (0 Hz to 1 kHz)
–12 –
REV. 0
相关PDF资料 |
PDF描述 |
|---|---|
| RCC07DRYI-S13 | CONN EDGECARD 14POS .100 EXTEND |
| MURHB840CTT4G | DIODE ULTRA FAST 400V 4A D2PAK |
| ADE7761BARSZ | IC ENERGY METERING 1PHASE 20SSOP |
| RSC65DREN | CONN EDGECARD 130POS .100 EYELET |
| MCP3905L-I/SS | IC POWER METERING-1 PHASE 24SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADE7751ARSZRL | 功能描述:IC ENERGY METERING 1PHASE 24SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 能量测量 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:* |
| ADE7752 | 制造商:AD 制造商全称:Analog Devices 功能描述:Three Phase Energy Metering IC with Pulse Output |
| ADE7752A | 制造商:AD 制造商全称:Analog Devices 功能描述:Polyphase Energy Metering IC with Pulse Output |
| ADE7752AAR | 制造商:Analog Devices 功能描述:IC ENERGY METER |
| ADE7752AAR-RL | 制造商:AD 制造商全称:Analog Devices 功能描述:Polyphase Energy Metering IC with Pulse Output |
发布紧急采购，3分钟左右您将得到回复。