- 您现在的位置：买卖IC网 > PDF目录375258 > ADM3232EARNZ (ANALOG DEVICES INC) Single Supply RS232C Line Driver/Receiver(?????μ?o?RS232C ?o?????????¨???2???2??????) PDF资料下载
参数资料
| 型号： | ADM3232EARNZ |
| 厂商： | ANALOG DEVICES INC |
| 元件分类： | 通用总线功能 |
| 英文描述： | Single Supply RS232C Line Driver/Receiver(?????μ?o?RS232C ?o?????????¨???2???2??????) |
| 中文描述： | DUAL LINE TRANSCEIVER, PDSO16 |
| 封装： | ROHS COMPLIANT, MS-012AC, SOIC-16 |
| 文件页数： | 8/12页 |
| 文件大小： | 220K |
| 代理商： | ADM3232EARNZ |
ADM3232E
THEORY OF OPERATION
The ADM3232E is a single-channel RS-232 line driver/receiver.
Step-up voltage converters, coupled with level-shifting transmitters
and receivers, allow RS-232 levels to be developed while operating
from a single 3.3 V supply.
CMOS technology is used to keep the power dissipation to an
absolute minimum, allowing maximum battery life in portable
applications.
CIRCUIT DESCRIPTION
The internal circuitry consists of the following main sections:
A charge pump voltage converter
A 3.3 V logic to RS-232 transmitter
An RS-232 to 3.3 V logic receiver
Charge Pump DC-DC Voltage Converter
The charge pump voltage converter consists of a 200 kHz
oscillator and a switching matrix. The converter generates a
±6.6 V supply from the input 3.3 V level. This is done in two
stages by using a switched capacitor technique as shown in
Figure 10. First, the 3.3 V input supply is doubled to 6.6 V by
using Capacitor C1 as the charge storage element. The +6.6 V
level is then inverted to generate 6.6 V, using C2 as the storage
element. C3 is shown connected between V+ and V
CC
, but it is
equally effective if connected between V+ and GND.
Capacitor C3 and Capacitor C4 are used to reduce the output
ripple. Their values are not critical and can be increased, if desired.
Capacitor C3 is shown connected between V+ and V
CC
. It is also
acceptable to connect this capacitor between V+ and GND.
If desired, larger capacitors (up to 10 μF) can be used for
Capacitor C1 to Capacitor C4.
Rev. 0 | Page 8 of 12
C1+
C1–
C2+
C2–
V
CC
V+
V–
T1
IN
T1
OUT
T2
IN
T2
OUT
R1
OUT
R1
IN
R2
OUT
R2
IN
TTL/CMOS
INPUTS
RS-232
OUTPUTS
TTL/CMOS
OUTPUTS
RS-232
INPUTS*
T1
T2
R1
R2
+
+
+
0.1μF
10V
0.1μF
10V
GND
ADM3232E
C3
0.1μF
6.3V
+3.3V INPUT
+3.3V TO +6.6V
VOLTAGE
DOUBLER
+6.6V TO –6.6V
VOLTAGE
INVERTER
C5
0.1μF
+
C4
0.1μF
10V
+
*INTERNAL 5k
PULL-DOWN RESISTOR
ON EACH RS-232 INPUT.
Figure 10. Typical Operating Circuit
5k
5k
0
C1
+
C3
+
S3
S4
S1
S2
INTERNAL
OSCILLATOR
V
CC
GND
V
CC
V+ = 2V
CC
0
Figure 11. Charge Pump Voltage Doubler
C2
+
C4
+
S3
S4
S1
S2
INTERNAL
OSCILLATOR
V+
GND
V– = –(V+)
GND
FROM
VOLTAGE
DOUBLER
0
Figure 12. Charge Pump Voltage Inverter
Transmitter (Driver) Section
The drivers convert 3.3 V logic input levels into RS-232 output
levels. With V
CC
= 3.3 V and driving an RS-232 load, the output
voltage swing is typically ±6 V.
Receiver Section
The receivers are inverting level-shifters that accept RS-232 input
levels and translate them into 3 V logic output levels. The inputs
have internal 5 kΩ pull-down resistors to ground and are also
protected against overvoltages up to ±30 V. Unconnected inputs
are pulled to 0 V by the internal 5 kΩ pull-down resistor. This
results in a Logic 1 output level for unconnected inputs or for
inputs connected to GND.
The receivers have Schmitt trigger inputs with a hysteresis level
of 0.4 V. This ensures error-free reception for both noisy inputs
and for inputs with slow transition times.
ESD Protection on RS-232 and TTL/CMOS I/O Pins
All RS-232 (T_
OUT
and R_
IN
) and TTL/CMOS (T_
IN
and R_
OUT
)
inputs and outputs are protected against electrostatic discharges
(up to ±15 kV). This ensures compliance with IEC 1000-4-2
requirements.
HIGH BAUD RATE
The ADM3232E features high slew rates, permitting data trans-
mission at rates well in excess of the EIA-232E specifications.
RS-232 voltage levels are maintained at data rates up to 460 kbps,
even under worst-case loading conditions. This allows high
speed data links between two terminals and is suitable for the
new generation ISDN modem standards that require data rates
of 230 kbps. The slew rate is internally controlled to less than
30 V/μs to minimize EMI interference.
相关PDF资料 |
PDF描述 |
|---|---|
| ADM3232EARNZ-REEL7 | Single Supply RS232C Line Driver/Receiver(?????μ?o?RS232C ?o?????????¨???2???2??????) |
| ADM3232EARUZ | Single Supply RS232C Line Driver/Receiver(?????μ?o?RS232C ?o?????????¨???2???2??????) |
| ADM3232EARUZ-REEL7 | Single Supply RS232C Line Driver/Receiver(?????μ?o?RS232C ?o?????????¨???2???2??????) |
| ADM3483E | 3.3 V, 【15 kV ESD-Protected, Half- and Full-Duplex, RS-485/RS-422 Transceivers |
| ADM3483EARZ | 3.3 V, 【15 kV ESD-Protected, Half- and Full-Duplex, RS-485/RS-422 Transceivers |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADM3232EARNZ | 制造商:Analog Devices 功能描述:IC RS232 TRANSCEIVER 460KBPS 5.5V SOIC16 |
| ADM3232EARNZ-REEL7 | 功能描述:IC RCVR/LINEDRIVER RS232 16-SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:121 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS422，RS485 电源电压:3 V ~ 3.6 V 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-DFN（3x3） 包装:管件 |
| ADM3232EARUZ | 功能描述:IC RCVR/LINE DRVR RS232 16-TSSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 产品培训模块:RS-232 & USB Transceiver 标准包装:2,000 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SSOP（0.209"，5.30mm 宽） 供应商设备封装:16-SSOP 包装:带卷 (TR) 其它名称:296-19849-2 |
| ADM3232EARUZ | 制造商:Analog Devices 功能描述:IC, RS-232 TXRX, 460KBPS, 5.5V, TSSOP-16 |
| ADM3232EARUZ-REEL7 | 功能描述:IC RCVR/LINEDRIVER RS232 16TSSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:121 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS422，RS485 电源电压:3 V ~ 3.6 V 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-DFN（3x3） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。