参数资料
型号: ADM489ARZ-REEL
厂商: Analog Devices Inc
文件页数: 4/16页
文件大小: 0K
描述: IC TXRX RS-485 DIFF LP 14SOIC
标准包装: 2,500
类型: 收发器
驱动器/接收器数: 1/1
规程: RS422,RS485
电源电压: 4.5 V ~ 5.5 V
安装类型: 表面贴装
封装/外壳: 14-SOIC(0.154",3.90mm 宽)
供应商设备封装: 14-SOICN
包装: 带卷 (TR)
ADM488/ADM489
Rev. D | Page 12 of 16
300ms
16ms
V
t
V
0.2/0.4ms
t
5ns
50ns
00
07
9-
02
5
Figure 25. IEC1000-4-4 Fast Transient Waveform
Table 8 shows the peak voltages for each of the environments.
Table 8. Peak Voltages
Level
VPEAK (kV) PSU
VPEAK (kV) I/O
1
0.5
0.25
2
1
0.5
3
2
1
4
2
A simplified circuit diagram of the actual EFT generator is
shown in Figure 26.
These transients are coupled onto the signal lines using an EFT
coupling clamp. The clamp is 1 m long and completely sur-
rounds the cable, providing maximum coupling capacitance
(50 pF to 200 pF typical) between the clamp and the cable. High
energy transients are capacitively coupled onto the signal lines.
Fast rise times (5 ns), as specified by the standard, result in very
effective coupling. This test is very severe because high voltages
are coupled onto the signal lines. The repetitive transients often
cause problems, while single pulses do not. Destructive latch-up
can be induced due to the high energy content of the transients.
Note that this stress is applied while the interface products are
powered up and transmitting data. The EFT test applies hun-
dreds of pulses with higher energy than ESD. Worst-case
transient current on an I/O line can be as high as 40 A.
RC
CC
ZS
L
RM CD
HIGH
VOLTAGE
SOURCE
50
OUTPUT
00
07
9-
0
26
Figure 26. EFT Generator
Test results are classified according to the following:
Normal performance within specification limits.
Temporary degradation or loss of performance that is self-
recoverable.
Temporary degradation or loss of function or performance
that requires operator intervention or system reset.
Degradation or loss of function that is not recoverable due
to damage.
The ADM488/ADM489 have been tested under worst-case
conditions using unshielded cables, and meet Classification 2 at
Severity Level 4. Data transmission during the transient
condition is corrupted, but it can be resumed immediately
following the EFT event without user intervention.
RADIATED IMMUNITY (IEC1000-4-3)
IEC1000-4-3 (previously IEC801-3) describes the measurement
method and defines the levels of immunity to radiated electro-
magnetic fields. It was originally intended to simulate the
electromagnetic fields generated by portable radio transceivers
or any other device that generates continuous wave-radiated
electromagnetic energy. Its scope has been broadened to include
spurious EM energy, which can be radiated from fluorescent
lights, thyristor drives, inductive loads, and so on.
Testing for immunity involves irradiating the device with an
EM field. Test methods include the use of anechoic chamber,
stripline cell, TEM cell, and GTEM cell. These consist of two
parallel plates with an electric field developed between them.
The device under test is placed between the plates and exposed
to the electric field. The three severity levels have field strengths
ranging from 1 V/m to 10 V/m. Results are classified as follows:
Normal operation.
Temporary degradation or loss of function that is self-
recoverable when the interfering signal is removed.
Temporary degradation or loss of function that requires
operator intervention or system reset when the interfering
signal is removed.
Degradation or loss of function that is not recoverable due
to damage.
相关PDF资料
PDF描述
13282-18SG-331 CONN PLUG 18POS CABLE SKT
VE-BNZ-MV-F1 CONVERTER MOD DC/DC 2V 60W
AD7828BR IC ADC 8BIT 8CH HS 28-SOIC
AD7492BRUZ-5 IC ADC 12BIT REF/CLOCK 24TSSOP
ADM3311EACPZ-REEL IC TXRX RS-232 3:5 2.7V 32LFCSP
相关代理商/技术参数
参数描述
ADM489ARZ-REEL7 功能描述:IC TXRX RS-485 DIFF LP 14SOIC RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:- 标准包装:121 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS422,RS485 电源电压:3 V ~ 3.6 V 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-DFN(3x3) 包装:管件
ADM51 功能描述:电路内置调试器 In-Circuit Debugger w/Chameleon RoHS:否 制造商:Microchip Technology 产品:In-Circuit Debugger Kits 工具用于评估:PIC MCUs, dsPIC DSCs 用于:07-00024, AC164113 核心:dsPIC, PIC 接口类型:USB 工作电源电压:3 V to 5 V
ADM-51 制造商:TDK 功能描述:
ADM5120 制造商:未知厂家 制造商全称:未知厂家 功能描述:HOME GATEWAY CONTROLLER
ADM5120ABT2NP 制造商:Infineon Technologies AG 功能描述:ROUTER / AP