- 您现在的位置：买卖IC网 > PDF目录13231 > ADP130AUJZ-0.8-R7 (Analog Devices Inc)IC REG LDO 0.8V .35A TSOT-23-5 PDF资料下载
参数资料
| 型号： | ADP130AUJZ-0.8-R7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 14/20页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 0.8V .35A TSOT-23-5 |
| 标准包装： | 1 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 0.8V |
| 输入电压： | 1.2 V ~ 3.6 V |
| 稳压器数量： | 1 |
| 电流 - 输出： | 350mA（最小值） |
| 电流 - 限制（最小）： | 400mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-5 细型，TSOT-23-5 |
| 供应商设备封装： | TSOT-23-5 |
| 包装： | 标准包装 |
| 其它名称： | ADP130AUJZ-0.8-R7DKR |
ADP130
Use Equation 1 to determine the worst-case capacitance,
accounting for capacitor variation over temperature, compo-
nent tolerance, and voltage.
Data Sheet
As shown in Figure 37, the EN pin has built-in hysteresis. This
prevents on/off oscillations that can occur due to noise on the
EN pin as it passes through the threshold points.
C EFF = C OUT × (1 ? TEMPCO ) × (1 ? TOL )
(1)
The EN pin active and inactive thresholds are derived from the
where:
C EFF is the effective capacitance at the operating voltage.
TEMPCO is the worst-case capacitor temperature coefficient.
TOL is the worst-case component tolerance.
In this example, TEMPCO over ?40°C to +85°C is assumed to be
15% for an X5R dielectric. TOL is assumed to be 10%, and C OUT
V IN voltage. Therefore, these thresholds vary with changing input
voltage. Figure 38 shows typical EN active and inactive thresholds
when the V BIAS voltage varies from 2.3 V to 5.5 V.
1.10
1.05
1.00
0.95
Substituting these values in Equation 1 yields the following:
C EFF = 0.94 μF × (1 ? 0.15) × (1 ? 0.1) = 0.719 μF
Therefore, the capacitor chosen in this example meets the
minimum capacitance requirement of the LDO over tempera-
ture and tolerance at the chosen output voltage.
To guarantee the performance of the ADP130, it is imperative
0.90
0.85
0.80
0.75
0.70
0.65
EN ACTIVE
EN INACTIVE
that the effects of dc bias, temperature, and tolerances on the
behavior of the capacitors be evaluated for each application.
0.60
2.3
2.7
3.1
3.5
3.9
V BIAS (V)
4.3
4.7
5.1
5.5
UNDERVOLTAGE LOCKOUT
The ADP130 has an internal undervoltage lockout circuit that
disables all inputs and the output when the input voltage is less
than approximately 2.1 V. This ensures that the ADP130 inputs
and the output behave in a predictable manner during power-up.
ENABLE FEATURE
The ADP130 uses the EN pin to enable and disable the VOUT
Figure 38. Typical EN Pin Thresholds vs. Input
The ADP130 uses an internal soft start to limit the inrush current
when the output is enabled. The start-up time for the 0.8 V option
is approximately 180 μs from the time at which the EN active
threshold is crossed to when the output reaches 90% of its final
value. The start-up time depends somewhat on the output voltage
setting and increases slightly as the output voltage increases.
when a rising voltage on EN crosses the active threshold, VOUT
turns on. When a falling voltage on EN crosses the inactive
threshold, VOUT turns off.
V OUT = 1.8V
C IN = C OUT = 1μF
V OUT
500mV/DIV
5.0
4.5
4.0
3.5
3.0
2.5
2.0
1.5
1.0
0.5
ENABLE
3.0V
1.8V
1.2V
0.8V
V BIAS = 2.3V
V IN = 3.6V
I LOAD = 10mA
EN
500mV/DIV
0
0
100
200
300
400
500
600
700
800
900 1000
TIME (μs)
2
1
Figure 39. Typical Start-Up Time for Various Output Voltages
CH1 500mV
CH2 500mV
M10ms
A CH2
640mV
T 30%
Figure 37. Typical EN Pin Operation
Rev. C | Page 14 of 20
相关PDF资料 |
PDF描述 |
|---|---|
| ACM24DRYS | CONN EDGECARD 48POS DIP .156 SLD |
| RCM25DRSN | CONN EDGECARD 50POS DIP .156 SLD |
| VE-J7V-CY-S | CONVERTER MOD DC/DC 5.8V 50W |
| VI-2WX-EX-F2 | CONVERTER MOD DC/DC 5.2V 75W |
| VI-B6W-EV-F3 | CONVERTER MOD DC/DC 5.5V 150W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADP130AUJZ-1.2-R7 | 功能描述:IC REG LDO 1.2V .35A TSOT-23-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降（标准）:0.12V @ 150mA 稳压器数量:1 电流 - 输出:150mA（最小值） 电流 - 限制（最小）:220mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR) 其它名称:ADP160AUJZ-3.0-R7TR |
| ADP130AUJZ-1.5-R7 | 功能描述:IC REG LDO 1.5V .35A TSOT-23-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降（标准）:0.12V @ 150mA 稳压器数量:1 电流 - 输出:150mA（最小值） 电流 - 限制（最小）:220mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR) 其它名称:ADP160AUJZ-3.0-R7TR |
| ADP130AUJZ-1.8-R7 | 功能描述:IC REG LDO 1.8V .35A TSOT-23-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:3,000 系列:- 稳压器拓扑结构:正，固定式 输出电压:3V 输入电压:最高 5.5V 电压 - 压降（标准）:0.12V @ 150mA 稳压器数量:1 电流 - 输出:150mA（最小值） 电流 - 限制（最小）:220mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 供应商设备封装:TSOT-23-5 包装:带卷 (TR) 其它名称:ADP160AUJZ-3.0-R7TR |
| ADP130AUJZ-2.5-R7 | 功能描述:IC REG LDO 2.5V .35A TSOT-23-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 其它有关文件:LD39015JXX12 View All Specifications 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:1.2V 输入电压:1.5 V ~ 5.5 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:150mA 电流 - 限制（最小）:- 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:4-WFBGA，FCBGA 供应商设备封装:4-覆晶（1.07x1.07） 包装:Digi-Reel® 其它名称:497-11958-6 |
| ADP130-BL1-EVZ | 制造商:Analog Devices 功能描述:BLANK ADISIMPOWER EVAL ADP130 - Boxed Product (Development Kits) |
发布紧急采购，3分钟左右您将得到回复。