- 您现在的位置：买卖IC网 > PDF目录4751 > ADP1752ACPZ-1.2-R7 (Analog Devices Inc)IC REG LDO 1.2V .8A 16LFCSP PDF资料下载
参数资料
| 型号： | ADP1752ACPZ-1.2-R7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 4/20页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 1.2V .8A 16LFCSP |
| 标准包装： | 1 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 1.2V |
| 输入电压： | 1.6 V ~ 3.6 V |
| 稳压器数量： | 1 |
| 电流 - 输出： | 800mA（最小值） |
| 电流 - 限制（最小）： | 1A |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-VQFN 裸露焊盘，CSP |
| 供应商设备封装： | 16-LFCSP-VQ EP（4x4） |
| 包装： | 标准包装 |
| 其它名称： | ADP1752ACPZ-1.2-R7DKR |
ADP1752/ADP1753
Data Sheet
Parameter
OUTPUT NOISE
Symbol
OUT NOISE
Test Conditions/Comments
10 Hz to 100 kHz, V OUT = 0.75 V
Min
Typ
23
Max
Unit
μV rms
10 Hz to 100 kHz, V OUT = 2.5 V
65
μV rms
POWER SUPPLY REJECTION RATIO
PSRR
V IN = V OUT + 1 V, I OUT = 10 mA
1 kHz, V OUT = 0.75 V
1 kHz, V OUT = 2.5 V
10 kHz, V OUT = 0.75 V
10 kHz, V OUT = 2.5 V
100 kHz, V OUT = 0.75 V
100 kHz, V OUT = 2.5 V
65
56
65
56
54
51
dB
dB
dB
dB
dB
dB
1
2
3
4
5
6
Minimum output load current is 500 μA.
Accuracy when VOUT is connected directly to ADJ. When VOUT voltage is set by external feedback resistors, absolute accuracy in adjust mode depends on the
tolerances of resistors used.
Based on an end-point calculation using 10 mA and 0.8 A loads. See Figure 6 for typical load regulation performance.
Dropout voltage is defined as the input to output voltage differential when the input voltage is set to the nominal output voltage. This applies only to output voltages
above 1.6 V.
Start-up time is defined as the time between the rising edge of EN to V OUT being at 95% of its nominal value.
Current-limit threshold is defined as the current at which the output voltage drops to 90% of the specified typical value. For example, the current limit for a 1.0 V
output voltage is defined as the current that causes the output voltage to drop to 90% of 1.0 V, or 0.9 V.
INPUT AND OUTPUT CAPACITOR, RECOMMENDED SPECIFICATIONS
Table 2.
Parameter
MINIMUM INPUT AND OUTPUT CAPACITANCE 1
CAPACITOR ESR
Symbol
C MIN
R ESR
Test Conditions/Comments
T A = ?40°C to +125°C
T A = ?40°C to +125°C
Min
3.3
0.001
Typ
Max
0.1
Unit
μF
?
1
The minimum input and output capacitance should be greater than 3.3 μF over the full range of operating conditions. The full range of operating conditions in the
application must be considered during device selection to ensure that the minimum capacitance specification is met. X7R and X5R type capacitors are recommended;
Y5V and Z5U capacitors are not recommended for use with this LDO.
Rev. F | Page 4 of 20
相关PDF资料 |
PDF描述 |
|---|---|
| ASM10DRKF-S13 | CONN EDGECARD 20POS .156 EXTEND |
| ADP1752ACPZ-2.5-R7 | IC REG LDO 2.5V .8A 16LFCSP |
| ADP1752ACPZ-1.0-R7 | IC REG LDO 1V .8A 16LFCSP |
| RSM22DTBS | CONN EDGECARD 44POS R/A .156 SLD |
| ADP1752ACPZ-1.1-R7 | IC REG LDO 1.1V .8A 16LFCSP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADP1752ACPZ-2.5-R7 | 功能描述:IC REG LDO 2.5V .8A 16LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:0.1V @ 200mA 稳压器数量:2 电流 - 输出:300mA 电流 - 限制（最小）:350mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-UFQFN 供应商设备封装:8-MLPQ-UT（1.5x1.5） 包装:剪切带 (CT) 产品目录页面:1358 (CN2011-ZH PDF) 其它名称:SC560HULCT |
| ADP1752-BL1-EVZ | 制造商:Analog Devices 功能描述:BLANK ADISIMPOWER EVAL ADP1752 - Boxed Product (Development Kits) |
| ADP1753ACPZ-R7 | 功能描述:IC REG LDO ADJ .8A 16LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:75 系列:- 稳压器拓扑结构:正，可调式 输出电压:1.2 V ~ 37 V 输入电压:4.2 V ~ 40 V 电压 - 压降（标准）:- 稳压器数量:1 电流 - 输出:500mA 电流 - 限制（最小）:500mA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:TO-252-3，DPak（2 引线+接片），SC-63 供应商设备封装:TO-252-3 包装:管件 产品目录页面:1286 (CN2011-ZH PDF) 其它名称:*LM317AMDT/NOPBLM317AMDT |
| ADP1753-BL1-EVZ | 制造商:Analog Devices 功能描述:BLANK ADISIMPOWER EVAL ADP1753 - Boxed Product (Development Kits) |
| ADP1753-EVALZ | 制造商:AD 制造商全称:Analog Devices 功能描述:0.8 A, Low VIN, Low Dropout Linear Regulator |
发布紧急采购，3分钟左右您将得到回复。