- 您现在的位置：买卖IC网 > PDF目录14214 > ADP2102YCPZ-1-R7 (Analog Devices Inc)IC REG BUCK SYNC ADJ 0.6A 8LFCSP PDF资料下载
参数资料
| 型号： | ADP2102YCPZ-1-R7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 14/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 0.6A 8LFCSP |
| 产品培训模块： | ADP2102 DSP Battery Life Applications |
| 标准包装： | 1 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 1.2 V |
| 输入电压： | 2.7 V ~ 5.5 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 3MHz |
| 电流 - 输出： | 600mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-VFDFN 裸露焊盘，CSP |
| 包装： | 标准包装 |
| 供应商设备封装： | 8-LFCSP-VD（3x3） |
| 配用： | ADP2102-4-EVALZ-ND - BOARD EVAL 2.5V-3.3V ADJ OUTPUT ADP2102-3-EVALZ-ND - BOARD EVAL 1.5V-1.875V ADJ OUTPT ADP2102-2-EVALZ-ND - BOARD EVAL 1.2V-1.5V ADJ OUTPUT ADP2102-1-EVALZ-ND - BOARD EVAL 0.8V-1.2V ADJ OUTPUT ADP2102-1.8-EVALZ-ND - BOARD EVAL FOR ADP2102-1.8 ADP2102-1.875EVALZ-ND - BOARD EVAL FOR ADP2102-1.875 ADP2102-1.5-EVALZ-ND - BOARD EVAL FOR ADP2102-1.5 ADP2102-1.375EVALZ-ND - BOARD EVAL FOR ADP2102-1.375 ADP2102-1.25-EVALZ-ND - BOARD EVAL FOR ADP2102-1.25 ADP2102-1.0-EVALZ-ND - BOARD EVAL FOR ADP2102-1.0 更多... |
| 其它名称： | ADP2102YCPZ-1-R7DKR |
ADP2102
As a result of this auto mode control technique, losses are
minimized at light loads, improving system efficiency.
The PSM reverse current comparator controls the entry and exit
into forced continuous conduction mode. Some minor jitter is
normal during transition from DCM to CCM with loads at
approximately 100 mA typical, and it has no adverse impact on
regulation.
SYNCHRONOUS RECTIFICATION
When the load current is further increased such that the lower
peak is above the current limit threshold, the off time is lengthened
to allow the current to decrease to this threshold before the next
on-time begins.
Both V OUT and the switching frequency are reduced as the circuit
operates in constant current mode. The load current (I OCL ) under
these conditions is equal to the current limit threshold plus half
In addition to the P-channel MOSFET switch, the ADP2102
includes an integrated N-channel MOSFET synchronous recti-
fier. The synchronous rectifier improves efficiency, especially
at low output voltages, and reduces cost and board space by
eliminating the need for an external rectifier.
I OCL = I VALLEY + Δ I L /2
DC CURRENT LIMIT = MAX LOAD
(5)
CURRENT LIMIT
The current limit circuit employs a valley current sensing scheme.
Current limit detection occurs during the off time through
sensing of the voltage drop across the on resistance of the
synchronous rectifier switch. The detection threshold is 1 A
typical.
INDUCTOR
CURRENT
I OCL
VALLEY CURRENT LIMIT
Figure 44. Valley Current Limit
TIME
Δ I
operation and during current limit. The output current, I OUT ,
The ripple current is calculated using Equation 6.
is the average of the inductor ripple current waveform. The
low-to-medium load current waveform illustrates the continuous
conduction mode operation with peak and valley inductor
Δ I L =
V OUT × ( V IN ? V OUT )
V IN × f SW × L
(6)
currents below the current limit threshold. When the load
current is increased, the ripple waveform maintains the same
amplitude and frequency because the current falls below the
current limit threshold at the valley of the ripple waveform.
As the current falls below the threshold during the normal off-
The ADP2102 also provides a negative current limit to prevent
an excessive reverse inductor current when the switching section
sinks current from the load in forced continuous conduction
mode. Under negative current limit conditions, both the high-
side and low-side switches are disabled.
time of each cycle, the start of each on-time is not delayed, and
the circuit output voltage is regulated at the correct value.
I PEAK
I OCL
CURRENT LIMIT
THRESHOLD
I VALLEY
INDUCTOR
CURRENT
I OUT
Δ I
MEDIUM LOAD
CURRENT
HIGH LOAD
CURRENT
CURRENT LIMIT
NORMAL OPERATION
Figure 45. Inductor Current—Current Limit Operation
Rev. B | Page 14 of 24
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6865UK43D2S+T | IC MPU SUPERVISOR SOT23-5 |
| AMM03DRAN | CONN EDGECARD 6POS .156 R/A |
| ADP2102YCPZ-2-R7 | IC REG BUCK SYNC ADJ 0.6A 8LFCSP |
| MAX6865UK43D2L+T | IC MPU SUPERVISOR SOT23-5 |
| CGS503U050W5L | CAP ALUM 50000UF 50V SCREW |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADP2102YCPZ-2-R7 | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:500 系列:- 类型:切换式电容器（充电泵），反相 输出类型:固定 输出数:1 输出电压:-3V 输入电压:2.3 V ~ 5.5 V PWM 型:Burst Mode? 频率 - 开关:900kHz 电流 - 输出:100mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 细型，TSOT-23-6 包装:带卷 (TR) 供应商设备封装:TSOT-23-6 其它名称:LTC1983ES6-3#TRMTR |
| ADP2102YCPZ-3 | 制造商:Analog Devices 功能描述:V REG 3V 3MHZ SMD LFCSP-8 2102 |
| ADP2102YCPZ-3-R7 | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 类型:升压（升压） 输出类型:两者兼有 输出数:1 输出电压:5V，2 V ~ 16.5 V 输入电压:2 V ~ 16.5 V PWM 型:- 频率 - 开关:45kHz 电流 - 输出:50mA 同步整流器:无 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 供应商设备封装:8-PDIP |
| ADP2102YCPZ-4-R7 | 功能描述:IC REG BUCK SYNC ADJ 0.6A 8LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 类型:升压（升压） 输出类型:两者兼有 输出数:1 输出电压:5V，2 V ~ 16.5 V 输入电压:2 V ~ 16.5 V PWM 型:- 频率 - 开关:45kHz 电流 - 输出:50mA 同步整流器:无 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 供应商设备封装:8-PDIP |
| ADP2105 | 制造商:AD 制造商全称:Analog Devices 功能描述:1 Amp/1.5 Amp/2 Amp Synchronous, Step-Down DC-to-DC Converters |
发布紧急采购，3分钟左右您将得到回复。