- 您现在的位置：买卖IC网 > PDF目录19382 > ADSP-21363YSWZ-2AA (Analog Devices Inc)IC DSP 32BIT 200MHZ EPAD 144LQFP PDF资料下载
参数资料
| 型号： | ADSP-21363YSWZ-2AA |
| 厂商： | Analog Devices Inc |
| 文件页数： | 8/60页 |
| 文件大小： | 0K |
| 描述： | IC DSP 32BIT 200MHZ EPAD 144LQFP |
| 产品培训模块： | SHARC Processor Overview |
| 标准包装： | 1 |
| 系列： | SHARC® |
| 类型： | 浮点 |
| 接口： | DAI，SPI |
| 时钟速率： | 200MHz |
| 非易失内存： | ROM（512 kB） |
| 芯片上RAM： | 384kB |
| 电压 - 输入/输出： | 3.30V |
| 电压 - 核心： | 1.00V |
| 工作温度： | -40°C ~ 105°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 144-LQFP 裸露焊盘 |
| 供应商设备封装： | 144-LQFP（20x20） |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页
ADSP-21362/ADSP-21363/ADSP-21364/ADSP-21365/ADSP-21366
audio channels in I2S, left-justified sample pair, or right-justi-
fied mode. One frame sync cycle indicates one 64-bit left/right
pair, but data is sent to the FIFO as 32-bit words (that is, one-
half of a frame at a time). The processor supports 24- and 32-bit
I 2 S, 24- and 32-bit left-justified, and 24-, 20-, 18- and 16-bit
right-justified formats.
Precision Clock Generator (PCG)
The precision clock generators (PCG) consist of two units, each
of which generates a pair of signals (clock and frame sync)
derived from a clock input signal. The units, A and B, are identi-
cal in functionality and operate independently of each other.
The two signals generated by each unit are normally used as a
serial bit clock/frame sync pair.
SYSTEM DESIGN
The following sections provide an introduction to system design
options and power supply issues.
Program Booting
The internal memory of the processor boots at system power-up
from an 8-bit EPROM via the parallel port, an SPI master, an
SPI slave, or an internal boot. Booting is determined by the boot
configuration (BOOT_CFG1–0) pins in Table 5 . Selection of the
boot source is controlled via the SPI as either a master or slave
device, or it can immediately begin executing from ROM.
Table 5. Boot Mode Selection
Peripheral Timers
The following three general-purpose timers can generate peri-
odic interrupts and be independently set to operate in one of
three modes:
? Pulse waveform generation mode
BOOT_CFG1–0
00
01
10
11
Booting Mode
SPI Slave Boot
SPI Master Boot
Parallel Port Boot via EPROM
No booting occurs. Processor executes
? Pulse width count/capture mode
? External event watchdog mode
Each general-purpose timer has one bidirectional pin and four
registers that implement its mode of operation: a 6-bit configu-
ration register, a 32-bit count register, a 32-bit period register,
and a 32-bit pulse width register. A single control and status
register enables or disables all three general-purpose timers
independently.
I/O PROCESSOR FEATURES
The processor’s I/O provides many channels of DMA and con-
trols the extensive set of peripherals described in the previous
sections.
DMA Controller
The processor’s on-chip DMA controllers allow data transfers
without processor intervention. The DMA controller operates
independently and invisibly to the processor core, allowing
DMA operations to occur while the core is simultaneously exe-
cuting its program instructions. DMA transfers can occur
between the processor’s internal memory and its serial ports, the
SPI-compatible (serial peripheral interface) ports, the IDP
(input data port), the parallel data acquisition port (PDAP), or
Table 4. DMA Channels
from internal ROM after reset.
Phase-Locked Loop
The processors use an on-chip phase-locked loop (PLL) to gen-
erate the internal clock for the core. On power-up, the
CLK_CFG1–0 pins are used to select ratios of 32:1, 16:1, and
6:1. After booting, numerous other ratios can be selected via
software control.
The ratios are made up of software configurable numerator val-
ues from 1 to 64 and software configurable divisor values of 1, 2,
4, and 8.
Power Supplies
The processor has a separate power supply connection for the
internal (V DDINT ), external (V DDEXT ), and analog (A VDD /A VSS )
power supplies. The internal and analog supplies must meet the
1.2 V requirement for K, B, and Y grade models, and the 1.0 V
requirement for Y models. (For information on the temperature
ment. All external supply pins must be connected to the same
power supply.
Note that the analog supply pin (A VDD ) powers the processor’s
internal clock generator PLL. To produce a stable clock, it is rec-
ommended that PCB designs use an external filter circuit for the
A VDD pin. Place the filter components as close as possible to the
Peripheral
SPORTs
IDP/PDAP
SPI
MTM/DTCP
Parallel Port
Total DMA Channels
ADSP-2136x
12
8
2
2
1
25
A VDD /A VSS pins. For an example circuit, see Figure 3 . (A
recommended ferrite chip is the muRata BLM18AG102SN1D.)
To reduce noise coupling, the PCB should use a parallel pair of
power and ground planes for V DDINT and GND. Use wide traces
to connect the bypass capacitors to the analog power (A VDD )
and ground (A VSS ) pins. Note that the A VDD and A VSS pins
specified in Figure 3 are inputs to the processor and not the ana-
log ground plane on the board—the A VSS pin should connect
directly to digital ground (GND) at the chip.
Rev. J |
Page 8 of 60 |
July 2013
相关PDF资料 |
PDF描述 |
|---|---|
| RCM08DTBH-S189 | CONN EDGECARD 16POS R/A .156 SLD |
| VI-B21-CY-F3 | CONVERTER MOD DC/DC 12V 50W |
| VI-B20-CY-F4 | CONVERTER MOD DC/DC 5V 50W |
| 1130-152K-RC | CHOKE RF HI CURR 1500UH 10% RAD |
| ADSP-2188NBSTZ-320 | IC DSP CONTROLLER 16BIT 100LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADSP-21364 | 制造商:AD 制造商全称:Analog Devices 功能描述:SHARC Processor |
| ADSP-21364BBC-1AA | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| ADSP-21364BBC-1AAZ | 制造商:Analog Devices 功能描述:DSP 32BIT SHARC 333MHZ 136CSPBGA |
| ADSP-21364BBCZ-1AA | 功能描述:IC DSP 32BIT 333MHZ 136-CSPBGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - DSP（数字式信号处理器） 系列:SHARC® 标准包装:2 系列:StarCore 类型:SC140 内核 接口:DSI，以太网，RS-232 时钟速率:400MHz 非易失内存:外部 芯片上RAM:1.436MB 电压 - 输入/输出:3.30V 电压 - 核心:1.20V 工作温度:-40°C ~ 105°C 安装类型:表面贴装 封装/外壳:431-BFBGA，FCBGA 供应商设备封装:431-FCPBGA（20x20） 包装:托盘 |
| ADSP-21364BSQZ-1AX | 制造商:Analog Devices 功能描述:333 MHZ, PROCESSOR W/ON CHIP ROM,S/PDIF - Trays |
发布紧急采购，3分钟左右您将得到回复。