参数资料
型号: ALD1704SAL
厂商: Advanced Linear Devices Inc
文件页数: 1/9页
文件大小: 0K
描述: IC OPAMP GP R-R CMOS 8SOIC
标准包装: 50
放大器类型: 通用
电路数: 1
输出类型: 满摆幅
转换速率: 5 V/µs
增益带宽积: 2.1MHz
电流 - 输入偏压: 1pA
电压 - 输入偏移: 4500µV
电流 - 电源: 3mA
电流 - 输出 / 通道: 15mA
电压 - 电源,单路/双路(±): 6.5 V ~ 10 V,±3.25 V ~ 5 V
工作温度: 0°C ~ 70°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SOIC
包装: 管件
其它名称: 1014-1081
Rev 2.1 2010 Advanced Linear Devices, Inc. 415 Tasman Drive, Sunnyvale, CA 94089-1706 Tel: (408) 747-1155 Fax: (408) 747-1286
www.aldinc.com
GENERAL DESCRIPTION
The ALD1704A/ALD1704B/ALD1704/ALD1704G is a CMOS monolithic
operational amplifier with MOSFET input that has rail-to-rail input and
output voltage ranges. The input voltage range and output voltage range
are very close to the positive and negative power supply voltages.
Typically the input voltage can be beyond positive power supply voltage
V+, or the negative power supply voltage V- by up to 300mV. The output
voltage swings to within 60mV of either positive or negative power supply
voltages at rated load.
This device is designed as an alternative to the popular JFET input
operational amplifiers in applications where lower operating voltages,
such as 9V battery or ±3.25V to ±5V power supplies are being used. It
offers high slew rate of 5V/s at low operating power of 30mW. Since the
ALD1704A/ALD1704B/ALD1704/ALD1704G is designed and manufac-
tured with Advanced Linear Devices' standard enhanced ACMOS silicon
gate CMOS process, it also offers low unit cost and exceptional reliability.
The rail-to-rail input and output feature of the ALD1704A/ALD1704B/
ALD1704/ALD1704G allows a lower operating supply voltage for a given
signal voltage range and allows numerous analog serial stages to be
implemented without losing operating voltage margin. The output stage
is designed to drive up to 10mA into 400pF capacitive and 1.5K resistive
loads at unity gain and up to 4000 pF at a gain of 5. Short circuit protection
to either ground or the power supply rails is at approximately 15mA clamp
current. Due to complementary output stage design, the output can both
source and sink 10mA into a load with symmetrical drive and is ideally
suited for applications where push-pull voltage drive is desired.
The offset voltage is trimmed on-chip to eliminate the need for external
nulling in many applications. For precision applications, the output is
designed to settle to 0.1% in 2s. For large signal buffer applications, the
operational amplifier can function as an ultra high input impedance
voltage follower/buffer that allows input and output voltage swings from
positive to negative supply voltages. This feature is intended to greatly
simplify systems design and eliminate higher voltage power supplies in
many applications. Additionally, robust design and rigorous screening
make this device especially suitable for operation in temperature-ex-
treme environments and rugged conditions.
RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER
ALD1704A/ALD1704B
ALD1704/ALD1704G
ADVANCED
LINEAR
DEVICES, INC.
APPLICATIONS
Voltage amplifier
Voltage follower/buffer
Charge integrator
Photodiode amplifier
Data acquisition systems
High performance portable
instruments
Signal conditioning circuits
Low leakage amplifiers
Active filters
Sample/Hold amplifier
Picoammeter
Current to voltage converter
Coaxial cable driver
Capacitive sensor amplifier
Piezoelectric transducer amplifier
FEATURES
Rail-to-rail input and output voltage ranges
5.0V/s slew rate
Output settles to 2mV of supply rails
High capacitive load capability -- up to 4000pF
Symmetrical push-pull output drives
No frequency compensation required --
unity gain stable
Extremely low input bias currents -- 1.0pA
typical (20pAMax)
Ideal for high source impedance applications
High voltage gain -- typically 150V/mV
Output short circuit protected
Unity gain bandwidth of 2.1MHz
Suitable for rugged, temperature-extreme
environments
Operating Temperature Range
0°C to +70°C0°C to +70°C
-55°C to 125°C
8-Pin
Small Outline
Plastic Dip
CERDIP
Package (SOIC)
Package
ALD1704ASAL
ALD1704APAL
ALD1704ADA
ALD1704BSAL
ALD1704BPAL
ALD17041BDA
ALD1704SAL
ALD1704PAL
ALD1704DA
ALD1704GSAL
ALD1704GPAL
ALD1704GDA
* Contact factory for leaded (non-RoHS) or extended high/low temperature versions.
ORDERING INFORMATION (“L” suffix denotes lead-free (RoHS))
PIN CONFIGURATION
* N/C pins are internally connected. Do not connect externally.
1
2
3
4
8
7
6
5
N/C
-IN
+IN
N/C
OUT
N/C
V-
V+
TOP VIEW
SAL, PAL, DA PACKAGES
相关PDF资料
PDF描述
ALD2706PAL IC OPAMP GP R-R CMOS DUAL 8PDIP
961104-5900-AR-TP CONN HEADER R/A 4POS GOLD SMD
961113-6804-AR CONN HEADER VERT SGL 13POS GOLD
RC0805FR-077R15L RES 7.15 OHM 1/8W 1% 0805 SMD
961113-6404-AR CONN HEADER VERT SGL 13POS GOLD
相关代理商/技术参数
参数描述
ALD1704Z 制造商:未知厂家 制造商全称:未知厂家 功能描述:Voltage-Feedback Operational Amplifier
ALD1706 制造商:ALD 制造商全称:Advanced Linear Devices 功能描述:ULTRA MICROPOWER RAIL TO RAIL CMOS OPERATIONAL AMPLIFIER
ALD1706A 制造商:ALD 制造商全称:Advanced Linear Devices 功能描述:ULTRA MICROPOWER RAIL TO RAIL CMOS OPERATIONAL AMPLIFIER
ALD1706A_10 制造商:ALD 制造商全称:Advanced Linear Devices 功能描述:ULTRA MICROPOWER RAIL-TO-RAIL CMOS OPERATIONAL AMPLIFIER
ALD1706ADA 制造商:ALD 制造商全称:Advanced Linear Devices 功能描述:ULTRA MICROPOWER RAIL TO RAIL CMOS OPERATIONAL AMPLIFIER