参数资料
型号: AP1202LSL
厂商: INTEGRATED CIRCUIT TECHNOLOGY CORP
元件分类: MOSFETs
英文描述: 0.6 A HALF BRDG BASED MOSFET DRIVER, PDSO8
封装: LEAD FREE, SOIC-8
文件页数: 11/11页
文件大小: 702K
代理商: AP1202LSL
AP1202
Dual USB High-Side Power Switch
Anachip Corp.
www.anachip.com.tw
Rev 1.1 May.26, 2005
9/11
Function Description
Error Flag
An open-drained output of N-channel MOSFET, the
FLG output is pulled low to signal the following fault
conditions: input under-voltage, output current limit,
and thermal shutdown.
Current Limit
The current limit threshold is preset internally. It
protects the output MOSFET switches from
damage due to undesirable short circuit conditions
or excess inrush current often encountered during
hot plug-in. The low limit of the current limit
threshold of the AP1202 allows a minimum current
of 0.5A through the MOSFET switches. A current
limit condition will signal the error flag.
Thermal Shutdown
When the chip temperature exceeds 140C for any
reason other than over-current fault of either one of
the two MOSFET switches, the thermal shutdown
function turns off both MOSFET switches and
signal the error flag. A hysteresis of 10C prevents
the MOSFETs from turning back on until the chip
temperature drops to below 130C.
Supply Filtering
A 0.1F to 1F bypass capacitor from IN to GND,
located near the device, is strongly recommended
to control supply transients. Without a bypass
capacitor, an output short may cause sufficient
ringing on the input (from supply lead inductance)
to damage internal control circuitry.
Transient Droop Requirements
USB support dynamic attachment (hot plug-in) of
peripherals. A current surge is caused by the input
capacitance of downstream device. Ferrite beads
are recommended in series with all power and
ground connector pins. Ferrite beads reduce EMI
and limit the inrush current during hot-attachment
by filtering high-frequency signals.
Short Circuit Transient
Bulk capacitance provides the short-term transient
current needed during a hot-attachment event. With
a 33F, 16V tantalum or 100F, 10V electrolytic
capacitor mounted close to downstream connector
per port should provide transient drop protection.
Printed Circuit Layout
The power circuitry of USB printed circuit boards
requires a customized layout to maximize thermal
dissipation and to minimize voltage drop and EMI.
Marking Information
Part Number
1
4
PDIP/SOP
Logo
Enable Type
H: Active High
L: Active Low
ID code: internal
Year: "01" =2001
"02" =2002
Xth week: 01~52
~
8
5
AP1202 X
YY WW X X
(Top View)
Blank: normal
L: Lead Free Package
相关PDF资料
PDF描述
AP1202LS 0.6 A HALF BRDG BASED MOSFET DRIVER, PDSO8
AP121-89 880 MHz - 915 MHz RF/MICROWAVE NARROW BAND HIGH POWER AMPLIFIER
AP1506-T5 6.5 A SWITCHING REGULATOR, 173 kHz SWITCHING FREQ-MAX, PSFM5
AP1506-33N 6.5 A SWITCHING REGULATOR, 173 kHz SWITCHING FREQ-MAX, PDIP8
AP1506-50T5RL 6.5 A SWITCHING REGULATOR, 173 kHz SWITCHING FREQ-MAX, PZFM5
相关代理商/技术参数
参数描述
AP1202LSLA 功能描述:电源开关 IC - USB Dual Ch Power Switch RoHS:否 制造商:Micrel 电源电压-最小:2.7 V 电源电压-最大:5.5 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-8 封装:Tube
AP1203AGMT-HF 制造商:A-POWER 制造商全称:Advanced Power Electronics Corp. 功能描述:Simple Drive Requirement, RoHS Compliant
AP1203AGMT-HF-3TR 制造商:ADVANCED POWER ELECTRONICS CORP 功能描述:MOSFET NCH 30V 12MOHM PMPAK5X6 制造商:ADVANCED POWER ELECTRONICS CORP 功能描述:MOSFET, NCH, 30V, 12MOHM, PMPAK5X6 制造商:ADVANCED POWER ELECTRONICS CORP 功能描述:MOSFET, NCH, 30V, 12MOHM, PMPAK5X6, Transistor Polarity:N Channel, Continuous Drain Current Id:37A, Drain Source Voltage Vds:30V, On Resistance Rds(on):0.012ohm, Rds(on) Test Voltage Vgs:10V, Power Dissipation Pd:27.8W, Operating , RoHS Compliant: Yes 制造商:APEC (ADVANCED POWER ELECTRONICS CORP) 功能描述:MOSFET, NCH, 30V, 12MOHM, PMPAK5X6, Transistor Polarity:N Channel, Continuous Dr
AP1203GMA 制造商:A-POWER 制造商全称:Advanced Power Electronics Corp. 功能描述:N-CHANNEL ENHANCEMENT MODE POWER MOSFET
AP-1205G-F2-LF 制造商:DAILY WIN MANUFACTURE 功能描述: