- 您现在的位置：买卖IC网 > PDF目录295067 > AP2007 Synchronous PWM Controller PDF资料下载
参数资料
| 型号： | AP2007 |
| 英文描述： | Synchronous PWM Controller |
| 中文描述： | 同步PWM控制器 |
| 文件页数： | 6/7页 |
| 文件大小： | 181K |
| 代理商： | AP2007 |
AP2007
Synchronous PWM with VFC Controller
(Preliminary)
Anachip Corp
www.anachip.com.tw
Rev. 1.0 Apr 1, 2005
6/7
Function Description (Continued)
Hiccup Mode
During power up, the SS/ SHDN pin is internally
pulled low until VCC reaches the under-voltage
lockout level of 4V. Once VCC has reached 4V, the
SS/ SHDN pin is released and begins to source
10uA of current to the external soft-start capacitor.
As the soft-start voltage rises, the inverting input of
the error comparator is clamped to this voltage.
When the error signal reaches the level of the
internal 0.8V reference, the output voltage is to have
reached its programmed voltage. If an over-current
condition has not occurred the soft-start voltage will
continue to rise and level off at about 2.5V.
An over-current condition occurs when the high-side
drive is turned on, but the PHASE node does not
reach the voltage level set at the OCSET pin. Once
an over-current occurs, the high-side drive is turned
off and the low-side drive turns on and the
SS/ SHDN pin begins to sink 2uA. The soft-start
voltage will begin to decrease as the 2uA of current
discharge the external capacitor. When the soft-start
voltage reaches 0.2V, the SS/ SHDN pin will begin to
source 10uA and begin to charge the external
capacitor causing the soft-start voltage to rise again.
If the over-current condition is no longer present,
normal operation will continue. If the over-current
condition is still present, the SS/ SHDN pin will again
begin to sink 2uA. This cycle will continue indefinitely
until the over-current condition is removed.
In order to prevent substrate glitching, a small-signal
diode should be placed in close proximity to the chip
with cathode connected to PHASE and anode
connected to GND.
Marking Information
(Top View)
SOP-8L
1
8
4
AP2007
YY WW X
Logo
Part No.
ID code: internal
Year: "01" =2001
"02" =2002
Xth week: 01~52
~
5
相关PDF资料 |
PDF描述 |
|---|---|
| AP2007S | Synchronous PWM Controller |
| AP2007SA | Surface Mount Resistors Thick Film Chip Resistors |
| AP2014SG-13 | |
| AP2112K-2.5TRG1 | 2.5 V FIXED POSITIVE LDO REGULATOR, 0.4 V DROPOUT, PDSO5 |
| AP2112R5-1.8TRG1 | 1.8 V FIXED POSITIVE LDO REGULATOR, 0.7 V DROPOUT, PDSO5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AP2007S | 制造商:ANACHIP 制造商全称:Anachip Corp 功能描述:Synchronous PWM Controller |
| AP2007SA | 制造商:ANACHIP 制造商全称:Anachip Corp 功能描述:Synchronous PWM Controller |
| AP2007SL-13 | 功能描述:开关变换器、稳压器与控制器 SW REG CNTL BUCK BI 200K 9.5MA 20V 1.25V RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| AP2007SL-U | 功能描述:开关变换器、稳压器与控制器 SW REG CNTL BUCK BI 200K 9.5MA 20V 1.25V RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| AP2008 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:PWM Buck Controller |
发布紧急采购，3分钟左右您将得到回复。