参数资料
| 型号： | AP393AM8G-13 |
| 厂商： | Diodes Inc |
| 文件页数： | 11/15页 |
| 文件大小： | 0K |
| 描述： | IC COMP DUAL LOW POWER 8-MSOP |
| 标准包装： | 2,500 |
| 类型： | 通用 |
| 元件数： | 2 |
| 输出类型： | CMOS，DTL，ECL，MOS，开路集电极，TTL |
| 电压 - 电源，单路/双路(±)： | 2 V ~ 36 V，±1 V ~ 18 V |
| 电压 - 输入偏移（最小值）： | 8mV @ 5V |
| 电流 - 输入偏压（最小值）： | 0.4µA @ 5V |
| 电流 - 输出（标准）： | 16mA @ 5V |
| 电流 - 静态（最大值）： | 2.5mA |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 安装类型： | 表面贴装 |
| 包装： | 带卷 (TR) |
AP393A
LOW POWER LOW OFFSET VOLTAGE DUAL
COMPARATORS
AP393A Rev. 7
5 of 15
FEBRUARY 2009
Diodes Incorporated
Electrical Characteristics
(Continued)
( VCC = 5V ) ( Note 6 )
Symbol
Parameter
Conditions
Min
Typ.
Max
Unit
VOFFSET
Input Offset Voltage
(Note 11)
--
9
mV
IOFFSET
Input Offset Current
IIN(+) -IIN(-), VCM = 0V
-
180
nA
IBIAS
Input Bias Current
IIN(+) or IIN(-) with Output In
Linear Range, VCM = 0V
(Note 7)
-
500
nA
Input Common Mode Voltage
Range
V
+ =30V (Note 8)
0
-
V
+ -2.0
V
VSAT
Saturation Voltage
VIN(-) = 1V, VIN(+) = 0,
ISINK ≤ 4mA
-
700
mV
IO(Leak)
Output Leakage Current
VIN(-) = 0, VIN(+) = 1V,
VO = 30V
-
1.0
μA
Differential Input Voltage
Keep All VIN’s ≥ 0V (or V
-, if
Used), (Note 10)
-
36
V
θ
JA
Thermal Resistance
Junction-to-Ambient
MSOP-8L (Note 12)
208
oC/W
SOP-8L (Note 12)
165
θ
JC
Thermal Resistance
Junction-to-Case
MSOP-8L (Note 12)
39
oC/W
SOP-8L (Note 12)
26
Notes:
3. For operating at high temperatures, the AP393A must be derated based on a 125°C maximum junction temperature and a
thermal resistance of 170°C/W which applies for the device soldered in a printed circuit board, operating in a still air ambient.
The low bias dissipation and the “ON-OFF” characteristic of the outputs keeps the chip dissipation very small (PD <100mW), provided the
output transistors are allowed to saturate.
4. Short circuits from the output to V
+ can cause excessive heating and eventual destruction. When considering short circuits to
ground, the maximum output current is approximately 20mA independent of the magnitude of V
+.
5. This input current will only exist when the voltage at any of the input leads is driven negative. It is due to the collector-base
junction of the input PNP transistors becoming forward biased and thereby acting as input diode clamps. In addition to this
diode action, there is also lateral NPN parasitic transistor action on the IC chip. This transistor action can cause the output
voltages of the comparators to go to the V
+ voltage level (or to ground for a large overdrive) for the time duration that an input
is driven negative. This is not destructive and normal output states will re-establish when the input voltage, which is negative,
again returns to a value greater than -0.3V.
6. The AP393A temperature specifications are limited to 0°C < TOP < +70°C.
7. The direction of the input current is out of the IC due to the PNP input stage. This current is essentially constant, independent
of the state of the output so no loading change exists on the reference or input lines.
8. The input common-mode voltage or either input signal voltage should not be allowed to go negative by more than 0.3V. The
upper end of the common-mode voltage range is V
+-1.5V at 25°C, but either or both inputs can go to 36V without damage,
independent of the magnitude of V
+.
9. The response time specified is for a 100mV input step with 5mV overdrive. For larger overdrive signals 300ns can be
obtained, see typical performance characteristics section.
10. Positive excursions of input voltage may exceed the power supply level. As long as the other voltage remains within the
common-mode range, the comparator will provide a proper output state. The low input voltage state must not be less than
-0.3V (or 0.3V below the magnitude of the negative power supply, if used).
11. At output switch point, VO ~ 1.4V, RS=0 with V
+ from 5V to 30V; and over the full input common-mode range (0V to V+-1.5V), at 25°C.
12. Test condition for MSOP-8L and SOP-8L: Device mounted on FR-4 substrate PC board, 2oz copper, with minimum recommended pad layout.
相关PDF资料 |
PDF描述 |
|---|---|
| APX393SG-13 | IC OP AMP R-R DUAL 8-SOIC |
| AR1020-I/ML | IC TOUCH SCREEN CTRLR 20-QFN |
| AR1100BRD | IC TOUCH SCREEN BOARD MOD |
| AR1100T-I/SO | IC TOUCH SCREEN CTLR 20-SOIC |
| AS1972 | IC COMPARATOR DUAL 8-MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AP393AM8G-U | 制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:LOW POWER LOW OFFSET VOLTAGE DUAL COMPARATORS |
| AP393ASG-13 | 功能描述:开关变换器、稳压器与控制器 5.0V-36.0V 16mA RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| AP393ASG-U | 制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:LOW POWER LOW OFFSET VOLTAGE DUAL COMPARATORS |
| AP393N | 制造商:ANACHIP 制造商全称:Anachip Corp 功能描述:Low Power Low Offset Voltage Dual Comparators |
| AP393NA | 制造商:ANACHIP 制造商全称:Anachip Corp 功能描述:Low Power Low Offset Voltage Dual Comparators |
发布紧急采购，3分钟左右您将得到回复。