- 您现在的位置：买卖IC网 > Datasheet目录310 > AP8802SPG-13 (Diodes Inc)IC LED DRIVER HIGH BRIGHT 8SOIC Datasheet资料下载
参数资料
| 型号： | AP8802SPG-13 |
| 厂商： | Diodes Inc |
| 文件页数： | 11/19页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVER HIGH BRIGHT 8SOIC |
| 特色产品： | LED Driver Solutions AP880X Series Step-Down DC/DC Converter |
| 标准包装： | 1 |
| 恒定电流： | 是 |
| 拓扑： | PWM，降压（降压） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光 |
| 类型 - 次要： | 高亮度 LED（HBLED） |
| 频率： | 500kHz |
| 电源电压： | 8 V ~ 48 V |
| 输出电压： | 48V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOP-EP |
| 包装： | 标准包装 |
| 工作温度： | -40°C ~ 105°C |
| 产品目录页面： | 1138 (CN2011-ZH PDF) |
| 其它名称： | AP8802SPGDIDKR |
AP8802
1A LED STEP-DOWN CONVERTER
Application Information (cont.)
PWM Dimming of LED Current
When a low frequency PWM signal with voltages between 2.5V and a low level of zero is applied to the CTRL pin the output current will be
switched on and off at the PWM frequency. The resultant LED current I LEDavg will be proportional to the PWM duty cycle. See Figure 20.
A Pulse Width Modulated (PWM) signal with a max resolution of 8-bit, can be applied to the CTRL pin to change the output current to a value
above or below the nominal average value set by resistor R SET .
To achieve this resolution the PWM frequency has to be lower than 500Hz. The ultimate resolution will be determined by the number of
switching cycles required to get back to nominal LED current once the PWM voltage is high relative to PWM frequency. Lower switching
frequencies and higher PWM frequencies will result in lower PWM dimming dynamic ranges.
Figure 20. Low Frequency PWM Operating Waveforms
There are different ways of accomplishing PWM dimming of the AP8802 LED current:
Directly Driving CTRL Input
A Pulse Width Modulated (PWM) signal with duty cycle DPWM can be applied to the CTRL pin to adjust the output current to a value above or
below the nominal average value set by resistor R SET . When driving the CTRL with a voltage waveform care should be taken not to exceed a
drive voltage of 2.5V (where extra brightness is required) or 1.25V if a maximum of 100% brightness is required.
A way of avoiding over-driving the CTRL pin is use an open collector/drain driver to drive the CTRL pin.
Driving the CTRL Input via Open Collector Transistor
The recommended method of driving the CTRL pin and controlling the amplitude of the PWM waveform is to use a small NPN switching
transistor. This uses the internal pull-up resistor between the CTRL pin and the internal voltage reference to pull-up CTRL pin when the
external transistor is turned off.
Driving the CTRL Input From a Microcontroller
If the CTRL pin is driven by a MOSFET (either discrete or open-drain output of a micro-controller) then Schottky diode maybe be required due
to high Gate / Drain capacitance, which could inject a negative spike into CTRL input of the AP8802 and cause erratic operation but the
addition of a Schottky clamp diode (eg Diodes Inc. SD103CWS) to ground and inclusion of a series resistor (3.3k) will prevent this.
AP8802
Document number: DS31766 Rev. 9 - 2
11 of 19
www.diodes.com
May 2012
? Diodes Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| AP8803WTG-7 | IC LED DRIVER CONN CURR TSOT23-5 |
| APEK4402KLP-01-T-DK | BOARD EVAL FOR A4402 |
| APP-001-15AMP | PLUG AUTO PWR BLACK W/LED 15AMP |
| APP-001-20AMP | AUTO PLUG 12VOLT WITH 20AMP FUSE |
| APP-001-VO | PLUG AUTO PWR BLACK W/LED IND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AP8803 | 制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:Cost effective 3W LED driver for consumer applications |
| AP8803EV1 | 功能描述:AP8803 1, Non-Isolated Output LED Driver Evaluation Board 制造商:diodes incorporated 系列:- 零件状态:有效 电流 - 输出/通道:680mA 输出和类型:1，非隔离 电压 - 输出:- 特性:可调光 电压 - 输入:8 V ~ 30 V 所含物品:板 使用的 IC/零件:AP8803 标准包装:1 |
| AP8803WTG-7 | 功能描述:LED照明驱动器 BUCK LED DRIVER 30V 3W RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| AP8821 | 制造商:APLUS 制造商全称:APLUS 功能描述:21 sec VOICE OTP |
| AP8841 | 制造商:American Power Conversion Corp (APC by Schneider Electric) 功能描述:RACK PDU 2G, METERED, ZEROU, 30A, 200/208V, (36) C13 & (6) C19 制造商:Schneider Electric 功能描述:RACK PDU 2G, METERED, ZEROU, 30A 200/208V, (36) C13 & (6) C1 - Bulk |
发布紧急采购，3分钟左右您将得到回复。