- 您现在的位置：买卖IC网 > PDF目录381285 > APL5902-16UC (Anpec Electronics Corporation) Low IQ, Low Dropout 900mA Fixed Voltage Regulator PDF资料下载
参数资料
| 型号： | APL5902-16UC |
| 厂商： | Anpec Electronics Corporation |
| 英文描述： | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| 中文描述： | 低智商，低压差稳压器九〇 〇毫安固定 |
| 文件页数： | 10/21页 |
| 文件大小： | 615K |
| 代理商： | APL5902-16UC |
Copyright
ANPEC Electronics Corp.
Rev. B.2 - May., 2005
APL5901/ 2
www.anpec.com.tw
10
The minimum input-output voltage difference (dropout)
determines the lowest usable supply voltage. In bat-
tery-powered systems, this will determine the useful
end-of-life battery voltage. Because the APL5901/2
use a p-channel MOSFET pass transistor, the drop-
out voltage is a function of drain-to-source on-resis-
tance (R
DS(ON)
) multiplied by the load current.
The APL5901/2 load-transient response graphs in typi-
cal characteristics show the transient response. A
step change in the load current from 10mA to 900mA
at 10
μ
s will cause a 20mV transient spike. Larger
output capacitor and lower ESR can reduce transient
spike.
Application I nformation
Capacitor S election and Regulator
S tability
The APL5901/2 use at least a 1
μ
F capacitor on the
input, and this capacitor can be Aluminum, Tantalum
or Ceramic capacitor. The input capacitor with larger
value and lower ESR provides better PSRR and line-
transient response. The output capacitor also can use
Aluminum, Tantalum or Ceramic capacitor, and a mini-
mum value of 4.7
μ
F and ESR above 0.02
is
recommended. A larger output capacitor can reduce
noise and improve load-transient response, stability,
and PSRR. Note that some ceramic dielectrics ex-
hibit large capacitance and ESR variation with
temperature. When using this capacitor, a minimum
10uF or more may be required to ensure the stability
at low temperature operation. Use a bypass capaci-
tor at BP pin for low output nvise. Increasing the ca-
pacitance will slightly decrease the output noise, but
increase the start-up time.
Load-Transient Considerations
Input-Output (Dropout)Voltage
Reverse Current Protection
The APL5901/2 have an internal reverse protection, it
does not need an external schottky diode to connect
the regulator input and output. If the output voltage is
forced above the input voltage by more than 11mV,
the IC will be shutdown and the ground pin current is
below 0.1uA.
Current Limit
The APL5901/2 have a current limit protection. The
ouptut voltage will drop close to zero volt, when load
current reaches the limit, and then the load current
will be limited at 200mA after output voltage is below
0.7V. When the load current back to the value where
limiting started, the output voltage and current will re-
turn to normal value. When output is shorted to
ground, the APL5901/2 will keep short circuit current
at 200mA .
S hutdow n/E nable
The APL5901/2 have an active high enable function.
Force EN high (>1.6V) enables the regulator, EN low
(<0.4V) disables the regulator and enter the shutdown
mode. In shutdown mode, the quiescent current can
reduce below 1uA. The EN pin cannot be floating, a
floating EN pin may cause an indeterminate state on
the output. If it is no use, connect to V
IN
for normal
operation.
相关PDF资料 |
PDF描述 |
|---|---|
| APL5902-16VC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| APL5902-17DC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| APL5902-17KC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| APL5902-17UC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
| APL5902-17VC | Low IQ, Low Dropout 900mA Fixed Voltage Regulator |
相关代理商/技术参数 |
参数描述 |
|---|---|
| APL6 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| APL602B2 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Volts:600V RDS(ON)0.125Ohms ID(cont):49Amps|Linear MOSFETs |
| APL602B2G | 功能描述:MOSFET N-CH 600V 49A T-MAX RoHS:是 类别:分离式半导体产品 >> FET - 单 系列:- 标准包装:1,000 系列:MESH OVERLAY™ FET 型:MOSFET N 通道，金属氧化物 FET 特点:逻辑电平门 漏极至源极电压(Vdss):200V 电流 - 连续漏极(Id) @ 25° C:18A 开态Rds（最大）@ Id, Vgs @ 25° C:180 毫欧 @ 9A，10V Id 时的 Vgs(th)（最大）:4V @ 250µA 闸电荷(Qg) @ Vgs:72nC @ 10V 输入电容 (Ciss) @ Vds:1560pF @ 25V 功率 - 最大:40W 安装类型:通孔 封装/外壳:TO-220-3 整包 供应商设备封装:TO-220FP 包装:管件 |
| APL602J | 功能描述:MOSFET N-CH 600V 43A SOT-227 RoHS:是 类别:半导体模块 >> FET 系列:- 标准包装:10 系列:* |
| APL602L | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Volts:600V RDS(ON)0.125Ohms ID(cont):49Amps|Linear MOSFETs |
发布紧急采购，3分钟左右您将得到回复。