8 - 18
AS1322
Datasheet - Detailed Description
8.2 Low-Noise Fixed-Frequency Operation
8.2.1 Oscillator
The AS1322 switching frequency is internally fixed at 1.2MHz allowing the use of very small external components.
8.2.2 Error Amplifier
The integrated error amplifier is an internally compensated trans-conductance (g
m
) type (current output). The internal 1.23V reference voltage is
compared to the voltage at pin FB to generate an error signal at the output of the error amplifier. A voltage divider fromV
OUT
to GND programs
the output voltage from2.5 to 5V via pin FB as:
V
OUT
= 1.23V(1 + (R
1
/R
2
))
(EQ 1)
8.2.3 Current Sensing
A signal representing the internal NMOS-switch current is summed with the slope compensator. The summed signal is compared to the error
amplifier output to provide a peak current control command for the PWM Peak switch current is limted to approximately 850mA independent of
V
IN
or V
OUT
.
8.2.4 Zero Current Comparator
The zero current comparator monitors the inductor current to the output and shuts off the PMOS synchronous rectifier once this current drops to
20mA (approx.). This prevents the inductor current fromreversing polarity and results in improved converter efficiency at light loads.
8.2.5 Anti-Ringing Control
Anti-ringing control circuitry prevents high-frequency ringing on pin SW as the inductor current approaches zero. This is accomplished by
damping the resonant circuit formed by the inductor and the capacitance on pin SW (C
SW
).
8.3 Powersave Operation (AS1322A)
In light load conditions, the integrated powersave feature removes power fromall circuitry not required to monitor V
OUT
. When V
OUT
has
dropped approximately 1% fromnomnal, the AS1322A powers up and begins normal PWMoperation.
C
OUT
(see Figure 15 on page 7)
recharges, causing the AS1322A to re-enter powersave mode as long as the output load remains below the
powersave threshold. The frequency of this intermttent PWMis proportional to load current; i.e., as the load current drops further below the
powersave threshold, the AS1322A turns on less frequently. When the load current increases above the powersave threshold, the AS1322A will
resume continuous, seamess PWMoperation.
Notes:
1. An optional capacitor (C
FF
) between pins V
OUT
and FB in some applications can reduce V
OUTp-p
ripple and input quiescent current
during powersave mode. Typical values for C
FF
range from15 to 220pF.
2. In powersave mode the AS1322A draws only 30μA fromthe output capacitor(s), greatly improving converter efficiency.
8.4 Shutdown
When pin SHDNN is low the AS1322 is switched off and <1μA current is drawn frombattery; when pin SHDNN is high the device is switched on.
If SHDNN is driven froma logic-level output, the logic high-level (on) should be referenced to V
OUT
to avoid intermttently switching the device
on.
Note:
If pin SHDNN is not used, it should be connected directly to pin OUT. V
OUT
is held at approximately V
IN
- 0.6V during shutdown.
In shutdown the battery input is connected to the output through the inductor and the internal synchronous rectifier P-FET. Due to the body diode
of the internal synchronous rectifier PFET, V
OUT
is held at approximately V
IN
- 0.6V during shutdown. This allows the input battery to provide
backup power for devices such as an idle mcrocontroller, memory, or real-time-clock, without the usual diode forward drop. In this way a
separate backup battery is not needed.