参数资料
型号: AS1337A-BTDT
厂商: ams
文件页数: 9/16页
文件大小: 0K
描述: IC REG BUCK BOOST SYNC ADJ 8TDFN
标准包装: 1
类型: 降压(降压),升压(升压)
输出类型: 可调式
输出数: 1
输出电压: 2.5 V ~ 5 V
输入电压: 0.65 V ~ 4.5 V
PWM 型: 电流模式
频率 - 开关: 1.2MHz
电流 - 输出: 200mA
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-WDFN 裸露焊盘
包装: 标准包装
供应商设备封装: 8-TDFN(3x3)
其它名称: AS1337A-BTDTDKR
AS1337
Datasheet - D e t a i l e d D e s c r i p t i o n
Low-Voltage Start-Up and Soft Start
The AS1337 requires a V IN of only 0.85V (typ) or higher to start up. The low-voltage start-up circuitry controls the internal switches and provides
a soft start function, where the inductor current during start up is limited for a certain time. This soft start and in rush current limitation feature pro-
vides also a smooth curve of V OUT after start up and makes the overshoot of V OUT minimal. To achieve this, a 100pF capacitor as C FF is
needed (see Figure 13 on page 7) to speed up the feedback loop.
After a certain time a bigger inductor current is allowed and the soft start is disabled.
Low-Noise Fixed-Frequency Operation
Oscillator
The AS1337 switching frequency is internally fixed at 1.2MHz allowing the use of very small external components.
Current Sensing
A signal representing the internal NMOS-switch current is summed with the slope compensator. The summed signal is compared to the error
amplifier output to provide a peak current control command for the PWM. Peak switch current is limited to approximately 850mA independent of
V IN or V OUT .
Zero Current Comparator
The zero current comparator monitors the inductor current to the output and shuts off the PMOS synchronous rectifier once this current drops to
20mA (approx.). This prevents the inductor current from reversing polarity and results in improved converter efficiency at light loads.
Anti-Ringing Control
Anti-ringing control circuitry prevents high-frequency ringing on pin LX as the inductor current approaches zero. This is accomplished by damp-
ing the resonant circuit formed by the inductor and the capacitance on pin LX.
Setting Output Voltage
A voltage divider from VOUT to GND programs the output voltage from 2.5V to 5V via pin FB as:
V OUT = 1.23V(1 + (R 1 /R 2 ))
(EQ 1)
Powersave Operation
In light load conditions, the integrated powersave feature removes power from all circuitry not required to monitor V OUT . When V OUT has
dropped approximately 1% from nominal, the AS1337 powers up and begins normal PWM operation.
C OUT (see Figure 13 on page 7) recharges, causing the AS1337 to re-enter powersave mode as long as the output load remains below the pow-
ersave threshold. The frequency of this intermittent PWM is proportional to load current; i.e., as the load current drops further below the power-
save threshold, the AS1337 turns on less frequently. When the load current increases above the powersave threshold, the AS1337 will resume
continuous, seamless PWM operation.
Note: An optional capacitor (C FF ) between pins VOUT and FB in some applications can reduce V OUTp-p ripple and input quiescent current
during powersave mode. Typical values for C FF range from 15pF to 220pF.
Buck Mode
Both devices, the AS1337A and the AS1337B, offer a low power buck mode for V IN > V OUT operation. The switching during buck mode is simi-
lar to boost mode, but with forced reduction of some energy internal to be able to provide a buck conversion.
Shutdown
When pin EN is low the AS1337 is switched off and <1μA current is drawn from battery; when pin EN is high the device is switched on. If EN is
driven from a logic-level output, the logic high-level (on) should be referenced to V OUT to avoid intermittently switching the device on.
Note: If pin EN is not used, it should be connected directly to pin VOUT.
Caution: Because of the feedthrough the output voltage is the same as the input voltage during shutdown. If V IN >
V OUT the output voltage will jump to the value of the input voltage when the device switches into shutdown.
During normal operation the device is in down conversion mode.
Revision 1.05
8 - 15
相关PDF资料
PDF描述
AS1339-BWLT IC CONV BUCK 650MA 16-WLP
AS1340A-BTDT-10-6K IC REG BOOST SYNC ADJ 1.4A 8TDFN
AS1341-BTDT-6K IC REG BUCK 5V/ADJ 0.6A 8TDFN
AS1346-BTDT-3318 IC REG BUCK SYNC DL 12TDFN
AS1353-36-T IC REG LDO 3.6V .15A SOT23-5
相关代理商/技术参数
参数描述
AS1337A-BTDT EB 制造商:ams 功能描述:Evaluation Board
AS1337A-TD_EK_ST 功能描述:AS1337A - DC/DC, Step Up or Down 1, Non-Isolated Outputs Evaluation Board 制造商:ams 系列:- 零件状态:过期 主要用途:DC/DC,步升/步降 输出和类型:1,非隔离 功率 - 输出:- 电压 - 输出:3.3V 电流 - 输出:200mA 电压 - 输入:0.65 V ~ 4.5 V 稳压器拓扑:升压,降压 频率 - 开关:1.2MHz 板类型:完全填充 所含物品:板 使用的 IC/零件:AS1337A 标准包装:1
AS1337BBTDT 制造商:ams 功能描述:T&R / TDFN 3x3 10
AS1337B-BTDT 功能描述:直流/直流开关转换器 RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
AS1339 制造商:AMSCO 制造商全称:austriamicrosystems AG 功能描述:650mA RF Step-Down DC-DC for PA, with two LDOs