Drawing No. :
453069
Rev. -
Page 7 of 11
7.0 RELIABILITY TEST
10
7.1 REFLOW PROFILE
Temperature Cycle
6
Solder Heat Resistance
No.
1
2
The components shall remain within the electrical specifications after pulled 2Kgs
weight for 10 seconds towards an axis of each teminal.
Durability
Apply 3V DC on the ocmponent and keep it at 70 ±2 for 250 hours.
9
Terminal Strength
The components shall remain within the electrical specifications after 1000 shocks,
acceleration 392 m/s2 , duration 6ms.
8
Vibration
The components shall remain within the electrical specifications after loaded vibration
at 20Hz, amplitude 1.5mm, for 2 hours.
7
Mechanical shock
Test Items
Test Conditions
High temperature
The components shall remain within the electrical specifications after being kept at
the 85 ±2 for 48 hours, then kept at room temperature for 2 hours
Low temperature
The components shall remain within the electrical specifications after being kept at
the –25 ±2 for 48 hours, then kept at room temperature for 2 hours.
3
NOTE: The information contained in this Source Control Drawing is subject to Abracon’s standard Terms and Conditions of Sale. The full text can be found at http://www.abracon.com/Support/terms.pdf.
The components shall remain within the electrical specifications after 5 cycles of high
and low temperature testing (one cycle: 80 for 30 minutes -> 25 for 5 minutes ->
-25 for 30 minutes), then kept at room temperature for 2 hours.
4
Humidity test
Keep the components at 40 ±2 , and 90% RH for 96 hours, then release the
components into room conditions for 1 hour before measurement.
5
Solderability:
Solderability of terminal shall be kept at more than 80% after dipped in the solder flux
at 230
5 for 5±1s.
The components shall remain within the electrical specifications after dipped in the
solder at 260 for 10±1 seconds, then kept at room temperature for 2 hours.
(Terminal must be dipped leaving 1.5mm from the case).
||||||||||||| | |
Pb RoHS
Compliant
30332 Esperanza, Rancho Santa Margarita, California 92688
tel 949-546-8000 | fax 949-546-8001| www.abracon.com
Revised: 08.30.10
Visit www.abracon.com for Terms & Conditions of Sale
REFLOW PROFILE:
ABRACON IS
CERTIFIED
ABRACON IS
ISO9001:2008
CERTIFIED
TAPE AND REEL:
5.0 x 5.0 x 1.3mm
ASR418E
418 MHz SMD SAW RESONATOR
ATTENTION: Abracon Corporation’s products are COTS – Commercial-Off-The-Shelf products; suitable for Commercial, Industrial and, where designated, Automotive Applications. Abracon’s products are not
specifically designed for Military, Aviation, Aerospace, Life-dependant Medical applications or any application requiring high reliability where component failure could result in loss of life and/or property. For
applications requiring high reliability and/or presenting an extreme operating environment, written consent and authorization from Abracon Corporation is required. Please contact Abracon Corporation for
more information.