参数资料
| 型号： | AT17F16-30TQI |
| 厂商： | Atmel |
| 文件页数： | 18/20页 |
| 文件大小： | 0K |
| 描述： | IC FLASH CONFIG 16M 44TQFP |
| 标准包装： | 100 |
| 可编程类型： | 闪存 |
| 存储容量： | 16Mb |
| 电源电压： | 2.97 V ~ 3.63 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 44-TQFP |
| 供应商设备封装： | 44-TQFP（10x10） |
| 包装： | 托盘 |
| 产品目录页面： | 609 (CN2011-ZH PDF) |
| 配用： | ATDH2225-ND - CABLE ISP FOR AT17 ATDH2200E-ND - CONFIGURATOR PROGRAM BOARD KIT |
7
3392F–CNFG–2/08
AT17F16
6.
FPGA Master Serial Mode Summary
The I/O and logic functions of any SRAM-based FPGA are established by a configuration pro-
gram. The program is loaded either automatically upon power-up, or on command, depending
on the state of the FPGA mode pins. In Master mode, the FPGA automatically loads the config-
uration program from an external memory. The AT17F Serial Configuration PROM has been
designed for compatibility with the Master Serial mode.
This document discusses the Atmel AT40K, AT40KAL and AT94KAL applications as well as Xil-
inx applications.
7.
Control of Configuration
Most connections between the FPGA device and the AT17F Serial Configurator PROM are sim-
ple and self-explanatory.
The DATA output of the AT17F Series Configurator drives DIN of the FPGA devices.
The master FPGA CCLK output drives the CLK input of the AT17F Series Configurator.
The CEO output of any AT17F Series Configurator drives the CE input of the next
Configurator in a cascade chain of configurator devices.
SER_EN must be connected to V
CC or allowed to float to logic High via the internal pull-up
resistor (except during ISP).
The READY pin is available as an open-collector indicator of the device’s reset status; it is
driven Low while the device is in its power-on reset cycle and released (tri-stated) when the
cycle is complete.
PAGE_EN must be held Low if download paging is not desired. The PAGESEL[1:0] inputs
must be tied off High or Low. If paging is desired, PAGE_EN must be High and the PAGESEL
pins must be set to High or Low such that the desired page is selected, see Table 5-2 on
8.
Cascading Serial Configuration Devices
For multiple FPGAs configured as a daisy-chain, or for FPGAs requiring larger configuration
memories, cascaded configurators provide additional memory.
After the last bit from the first configurator is read, the clock signal to the configurator asserts its
CEO output Low and disables its DATA line driver. The second configurator recognizes the Low
level on its CE input and enables its DATA output.
After configuration is complete, the address counters of all cascaded configurators are reset if
the RESET/OE on each configurator is driven to its active (Low) level.
If the address counters are not to be reset upon completion, then the RESET/OE input can be
tied to its inactive (High) level.
相关PDF资料 |
PDF描述 |
|---|---|
| AT17F16A-30JU | IC FLASH CONFIG 16M 20PLCC |
| AT17F32-30BJU | IC EEPROM FLASH 32MBIT 44-PLCC |
| AT17F32A-30BJU | IC EEPROM FLASH 32MBIT 44-PLCC |
| AT17LV002A-10CU | IC FPGA EEPROM 2M ALTERA 8LAP |
| AT17LV512-10PC | IC SRL CONFG EEPROM 512K LV 8DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT17F16A | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:FPGA Configuration Flash Memory |
| AT17F16A-30CC | 功能描述:FPGA-配置存储器 Serial Flash RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| AT17F16A-30CI | 功能描述:FPGA-配置存储器 Serial Flash RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| AT17F16A-30CU | 功能描述:FPGA-配置存储器 SER CONFIG FLASH-16M ALTERA PINOUT-30MHZ RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| AT17F16A-30JC | 功能描述:FPGA-配置存储器 SER CONFIG FLASH-16M ALTERA PINOUT-30MHZ RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
发布紧急采购，3分钟左右您将得到回复。