参数资料
| 型号： | AT17LV512-10PC |
| 厂商： | Atmel |
| 文件页数： | 24/26页 |
| 文件大小： | 0K |
| 描述： | IC SRL CONFG EEPROM 512K LV 8DIP |
| 标准包装： | 50 |
| 可编程类型： | 串行 EEPROM |
| 存储容量： | 512kb |
| 电源电压： | 3 V ~ 3.6 V，4.75 V ~ 5.25 V |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-DIP |
| 包装： | 管件 |
| 产品目录页面： | 609 (CN2011-ZH PDF) |
| 配用： | ATDH2225-ND - CABLE ISP FOR AT17 ATDH2200E-ND - CONFIGURATOR PROGRAM BOARD KIT |
7
2321I–CNFG–2/08
AT17LV65/128/256/512/010/002/040
4.1
DATA
Three-state DATA output for configuration. Open-collector bi-directional pin for programming.
4.2
CLK
Clock input. Used to increment the internal address and bit counter for reading and
programming.
4.3
WP1
WRITE PROTECT (1). Used to protect portions of memory during programming. Disabled
by default due to internal pull-down resistor. This input pin is not used during FPGA loading
operations. This pin is only available on AT17LV512/010/002 devices.
4.4
RESET/OE
Output Enable (active High) and RESET (active Low) when SER_EN is High. A Low level on
RESET/OE resets both the address and bit counters. A High level (with CE Low) enables the
data output driver. The logic polarity of this input is programmable as either RESET/OE or
RESET/OE. For most applications, RESET should be programmed active Low. This document
describes the pin as RESET/OE.
4.5
WP
Write protect (WP) input (when CE is Low) during programming only (SER_EN Low). When WP
is Low, the entire memory can be written. When WP is enabled (High), the lowest block of the
memory cannot be written. This pin is only available on AT17LV65/128/256 devices.
4.6
WP2
WRITE PROTECT (2). Used to protect portions of memory during programming. Disabled
by default due to internal pull-down resistor. This input pin is not used during FPGA loading
operations. This pin is only available on AT17LV512/010 devices.
4.7
CE
Chip Enable input (active Low). A Low level (with OE High) allows CLK to increment the address
counter and enables the data output driver. A High level on CE disables both the address and bit
counters and forces the device into a low-power standby mode. Note that this pin will not
enable/disable the device in the Two-Wire Serial Programming mode (SER_EN Low).
4.8
GND
Ground pin. A 0.2 F decoupling capacitor between V
CC and GND is recommended.
4.9
CEO
Chip Enable Output (active Low). This output goes Low when the address counter has reached
its maximum value. In a daisy chain of AT17LV series devices, the CEO pin of one device must
be connected to the CE input of the next device in the chain. It will stay Low as long as CE is
Low and OE is High. It will then follow CE until OE goes Low; thereafter, CEO will stay High until
the entire EEPROM is read again. This CEO feature is not available on the AT17LV65 device.
相关PDF资料 |
PDF描述 |
|---|---|
| AT17N512-10SI | IC FPGA 512K CONFIG MEM 20SOIC |
| AT18F080-30XU | IC FLASH CONFIG 7MBIT 20-TSSOP |
| AT22LV10L-25SI | IC PLD EE 25NS LV UV 24-SOIC |
| AT32AP7000-CTUR | IC MCU AVR32 256-CTBGA |
| AT32AP7001-ALUT | IC MCU 32BIT AVR32 208-LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT17LV512-10PI | 功能描述:FPGA-配置存储器 2M bit FPGA RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| AT17LV512-10SC | 功能描述:FPGA-配置存储器 Serial EEPROM RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| AT17LV512-10SI | 功能描述:FPGA-配置存储器 Serial EEPROM RoHS:否 制造商:Altera Corporation 存储类型:Flash 存储容量:1.6 Mbit 工作频率:10 MHz 电源电压-最大:5.25 V 电源电压-最小:3 V 电源电流:50 uA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:PLCC-20 |
| AT17LV512-10TQC | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory |
| AT17LV512-10TQI | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:FPGA Configuration EEPROM Memory |
发布紧急采购，3分钟左右您将得到回复。