- 您现在的位置：买卖IC网 > PDF目录20401 > AT24C04B-TSU-T (Atmel)IC EEPROM 4KBIT 1MHZ SOT23-5 PDF资料下载
参数资料
| 型号： | AT24C04B-TSU-T |
| 厂商： | Atmel |
| 文件页数： | 6/28页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 4KBIT 1MHZ SOT23-5 |
| 产品变化通告： | AT24C04,08B Obsolescence 04/Nov/2011 |
| 标准包装： | 5,000 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 4K (512 x 8) |
| 速度： | 400kHz，1MHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | SC-74A，SOT-753 |
| 供应商设备封装： | SOT-23-5 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
3.
Device Operation
CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an external device. Data on the SDA pin
may change only during SCL low time periods (see Figure 6 ). Data changes during SCL high periods will indicate a
start or stop condition as defined below.
START CONDITION: A high-to-low transition of SDA with SCL high is a start condition which must precede any other
command (see Figure 7) .
STOP CONDITION:
A low-to-high transition of SDA with SCL high is a stop condition. After a read sequence, the stop
command will place the EEPROM in a standby power mode (see Figure 7) .
ACKNOWLEDGE: All addresses and data words are serially transmitted to and from the EEPROM in 8-bit words. The
EEPROM sends a zero to acknowledge that it has received each word. This happens during the ninth clock cycle.
STANDBY MODE: The AT24C04B/08B features a low-power standby mode which is enabled:
(a) Upon power-up and
(b) After the receipt of the STOP bit and the completion of any internal operations.
2-WIRE SOFTWARE RESET: After an interruption in protocol, power loss or system reset,
2-wire part can be reset by following these steps:
(a) Create a start bit condition,
any
(b)
Clock 9 cycles,
(c) Create another start bit followed by a stop bit condition as shown below. The device is ready for the next
communication after the above steps have been completed.
Figure 3.
Software reset
Start bit
Dummy Clock Cycles
Start bit
Stop bit
SCL
1
2
3
8
9
SDA
6
AT24C04B/08B
5226G–SEEPR–11/09
相关PDF资料 |
PDF描述 |
|---|---|
| S1M-13 | RECTIFIER GPP SMD 1000V 1A SMA |
| VI-JNK-CW-F3 | CONVERTER MOD DC/DC 40V 100W |
| IFSC1008ABER4R7M01 | INDUCTOR POWER 4.7UH 1.2A SMD |
| T95Z107K6R3LSAL | CAP TANT 100UF 6.3V 10% 2910 |
| 346-080-526-202 | CARDEDGE 80POS DUAL .125 GREEN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT24C04BU3-UU-T | 功能描述:电可擦除可编程只读存储器 PB/HALO FREE 1.8V RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| AT24C04B-W-11 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Two-wire Serial EEPROM 4K (512 x 8) 8K (1024 x 8) |
| AT24C04BY6-YH-T | 功能描述:电可擦除可编程只读存储器 PB/HALO FREE 1.8V RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| AT24C04C-CUM-T | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:I2C-Compatible, (2-wire) Serial EEPROM |
| AT24C04C-MAHM-T | 功能描述:电可擦除可编程只读存储器 4K (512x8) 2-WIRE NiPdAu, 1.7V RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
发布紧急采购，3分钟左右您将得到回复。