- 您现在的位置：买卖IC网 > PDF目录20400 > AT24C16B-TSU-T (Atmel)IC EEPROM 16KBIT 1MHZ SOT23-5 PDF资料下载
参数资料
| 型号： | AT24C16B-TSU-T |
| 厂商： | Atmel |
| 文件页数： | 6/27页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 16KBIT 1MHZ SOT23-5 |
| 标准包装： | 5,000 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 16K (2K x 8) |
| 速度： | 400kHz，1MHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | SC-74A，SOT-753 |
| 供应商设备封装： | SOT-23-5 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页
5. Device Operation
CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an external device.
Data on the SDA pin may change only during SCL low time periods (see Figure 7-2 on page 8 ).
Data changes during SCL high periods will indicate a start or stop condition as defined below.
START CONDITION: A high-to-low transition of SDA with SCL high is a start condition which
must precede any other command (see Figure 7-3 on page 8 ).
STOP CONDITION: A low-to-high transition of SDA with SCL high is a stop condition. After a
read sequence, the stop command will place the EEPROM in a standby power mode (see Fig-
ure 7-3 on page 8 ).
ACKNOWLEDGE: All addresses and data words are serially transmitted to and from the
EEPROM in 8-bit words. The EEPROM sends a zero to acknowledge that it has received each
word. This happens during the ninth clock cycle.
STANDBY MODE: The AT24C16B features a low-power standby mode which is enabled: (a)
upon power-up and (b) after the receipt of the STOP bit and the completion of any internal
operations.
2-WIRE SOFTWARE RESET: After an interruption in protocol, power loss or system reset, any
2-wire part can be protocol reset by following these steps:
1. Create a start bit condition.
2. Clock 9 cycles.
3. Create another start bit followed by stop bit condition as shown below.
Start bit
Dummy Clock Cycles
Start bit
Stop bit
SCL
1
2
3
8
9
SDA
6
AT24C16B
5175E–SEEPR–3/09
相关PDF资料 |
PDF描述 |
|---|---|
| T95Z106M035LSAL | CAP TANT 10UF 35V 20% 2910 |
| IFSC0806AZER2R2M01 | INDUCTOR POWER 2.2UH 1.30A SMD |
| F720J107MRC | CAP TANT 100UF 6.3V 20% 2824 |
| VI-JNM-CW-F3 | CONVERTER MOD DC/DC 10V 100W |
| IR2128 | IC MOSFET DRIVER CUR-SENSE 8-DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT24C16BTSU-T | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Two-wire Serial EEPROM |
| AT24C16BU2-UU-T | 制造商:Atmel Corporation 功能描述:8 DBGA2,PB/HALO FREE,1.8V - 8 DBGA2,PB/HALO FREE, 1.8V - Tape and Reel |
| AT24C16BU3-UU-T | 功能描述:电可擦除可编程只读存储器 1.8V 16Kbit 2-Wire Bus RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| AT24C16B-W-11 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Two-wire Serial EEPROM |
| AT24C16BY6-YH-T | 功能描述:电可擦除可编程只读存储器 8 MINI MAP 1.8V RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
发布紧急采购，3分钟左右您将得到回复。