- 您现在的位置：买卖IC网 > PDF目录11795 > AT32UC3A364-ALUR (Atmel)IC MCU 64KB FLASH 144LQFP PDF资料下载
参数资料
| 型号： | AT32UC3A364-ALUR |
| 厂商： | Atmel |
| 文件页数： | 26/94页 |
| 文件大小： | 0K |
| 描述： | IC MCU 64KB FLASH 144LQFP |
| 产品培训模块： | MCU Product Line Introduction AVR® UC3 Introduction |
| 标准包装： | 1 |
| 系列： | AVR®32 UC3 A3 |
| 核心处理器： | AVR |
| 芯体尺寸： | 32-位 |
| 速度： | 66MHz |
| 连通性： | EBI/EMI，I²C，IrDA，MMC，SPI，SSC，UART/USART，USB OTG |
| 外围设备： | 欠压检测/复位，DMA，POR，WDT |
| 输入/输出数： | 110 |
| 程序存储器容量： | 64KB（64K x 8） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 128K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 1.65 V ~ 1.95 V |
| 数据转换器： | A/D 8x10b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 144-LQFP |
| 包装： | 剪切带 (CT) |
| 配用： | ATSTK600-RC32-ND - STK600 ROUTING CARD AVR |
| 其它名称： | AT32UC3A364-ALURCT |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页
32
32072SH–AVR32–10/2012
AT32UC3A3
status register. Upon entry into Debug mode, hardware sets the SR[D] bit and jumps to the
Debug Exception handler. By default, Debug mode executes in the exception context, but with
dedicated Return Address Register and Return Status Register. These dedicated registers
remove the need for storing this data to the system stack, thereby improving debuggability. The
mode bits in the status register can freely be manipulated in Debug mode, to observe registers
in all contexts, while retaining full privileges.
Debug mode is exited by executing the retd instruction. This returns to the previous context.
4.5.5
Entry Points for Events
Several different event handler entry points exists. In AVR32UC, the reset address is
0x8000_0000. This places the reset address in the boot flash memory area.
TLB miss exceptions and scall have a dedicated space relative to EVBA where their event han-
dler can be placed. This speeds up execution by removing the need for a jump instruction placed
at the program address jumped to by the event hardware. All other exceptions have a dedicated
event routine entry point located relative to EVBA. The handler routine address identifies the
exception source directly.
AVR32UC uses the ITLB and DTLB protection exceptions to signal a MPU protection violation.
ITLB and DTLB miss exceptions are used to signal that an access address did not map to any of
the entries in the MPU. TLB multiple hit exception indicates that an access address did map to
multiple TLB entries, signalling an error.
All external interrupt requests have entry points located at an offset relative to EVBA. This
autovector offset is specified by an external Interrupt Controller. The programmer must make
sure that none of the autovector offsets interfere with the placement of other code. The autovec-
tor offset has 14 address bits, giving an offset of maximum 16384 bytes.
Special considerations should be made when loading EVBA with a pointer. Due to security con-
siderations, the event handlers should be located in non-writeable flash memory, or optionally in
a privileged memory protection region if an MPU is present.
If several events occur on the same instruction, they are handled in a prioritized way. The priority
ordering is presented in Table 4-4. If events occur on several instructions at different locations in
the pipeline, the events on the oldest instruction are always handled before any events on any
younger instruction, even if the younger instruction has events of higher priority than the oldest
instruction. An instruction B is younger than an instruction A if it was sent down the pipeline later
than A.
The addresses and priority of simultaneous events are shown in Table 4-4. Some of the excep-
tions are unused in AVR32UC since it has no MMU, coprocessor interface, or floating-point unit.
相关PDF资料 |
PDF描述 |
|---|---|
| DS80C310+FCG | IC MCU HI SPEED 25MHZ 44-MQFP |
| D38999/20WD5SN | CONN RCPT 5POS WALL MNT W/SCKT |
| ATMEGA6490-16AUR | MCU AVR 64KB FLASH 16MHZ 64TQFP |
| D38999/20FD5SN | CONN RCPT 5POS WALL MNT W/SCKT |
| 1604057-1 | KIT,350A,4/0 AWG,YELLOW |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT32UC3A364-ALUT | 功能描述:32位微控制器 - MCU 64KB, 144LQFP Ind RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT |
| AT32UC3A364-CTUR | 功能描述:32位微控制器 - MCU 64KB, 144FFBGA Ind RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT |
| AT32UC3A364-CTUT | 功能描述:32位微控制器 - MCU 64KB, 144FFBGA Ind RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT |
| AT32UC3A364-DDW | 功能描述:32位微控制器 - MCU UC3A3 64Kb flash - 64Kflash UC3A - Wafer RoHS:否 制造商:Texas Instruments 核心:C28x 处理器系列:TMS320F28x 数据总线宽度:32 bit 最大时钟频率:90 MHz 程序存储器大小:64 KB 数据 RAM 大小:26 KB 片上 ADC:Yes 工作电源电压:2.97 V to 3.63 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:LQFP-80 安装风格:SMD/SMT |
| AT32UC3A364S | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:32-bit AVR? Microcontroller |
发布紧急采购，3分钟左右您将得到回复。