参数资料
| 型号： | AT80251G2D-SLRUM |
| 厂商： | Atmel |
| 文件页数： | 37/77页 |
| 文件大小： | 0K |
| 描述： | IC 8051 MCU ROMLESS 44PLCC |
| 标准包装： | 500 |
| 系列： | 8x251 |
| 核心处理器： | C251 |
| 芯体尺寸： | 8/16-位 |
| 速度： | 24MHz |
| 连通性： | EBI/EMI，I²C，Microwire，SPI，UART/USART |
| 外围设备： | POR，PWM，WDT |
| 输入/输出数： | 32 |
| 程序存储器类型： | ROMless |
| RAM 容量： | 1K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 4.5 V ~ 5.5 V |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 44-LCC（J 形引线） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页当前第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页
42
AT/TSC8x251G2D
4135F–8051–11/06
To preserve the secrecy of the encryption key byte sequence, the Encryption Array can
not be verified.
Notes: 1. When a MOVC instruction is executed, the content of the ROM is not encrypted. In
order to fully protect the user program code, the lock bit level 1 (see Table 33) must
always be set when encryption is used.
2. If the encryption feature is implemented, the portion of the on-chip code memory that
does not contain program code should be filled with “random” byte values to prevent
the encryption key sequence from being revealed.
Signature Bytes
The TSC80251G2D derivatives contain factory-programmed Signature Bytes. These
bytes are located in non-volatile memory outside the memory address space at 30h,
31h, 60h and 61h. To read the Signature Bytes, perform the procedure described in sec-
tion Verify Algorithm, using the verify signature mode (see Table 37). Signature byte
values are listed in Table 35.
Table 35.
Signature Bytes (Electronic ID)
Programming Algorithm
Figure 6 shows the hardware setup needed to program the TSC87251G2D
EPROM/OTPROM areas:
The chip has to be put under reset and maintained in this state until completion of
the programming sequence.
PSEN# and the other control signals (ALE and Port 0) have to be set to a high level.
Then PSEN# has to be to forced to a low level after two clock cycles or more and it
has to be maintained in this state until the completion of the programming sequence
(see below).
The voltage on the EA# pin must be set to VDD.
The programming mode is selected according to the code applied on Port 0 (see
Table 36). It has to be applied until the completion of this programming operation.
The programming address is applied on Ports 1 and 3 which are respectively the
Most Significant Byte (MSB) and the Least Significant Byte (LSB) of the address.
The programming data are applied on Port 2.
The EPROM Programming is done by raising the voltage on the EA# pin to VPP,
then by generating a low level pulse on ALE/PROG# pin.
The voltage on the EA# pin must be lowered to VDD before completing the
programming operation.
It is possible to alternate programming and verifying operation (See Paragraph
Verify Algorithm). Please make sure the voltage on the EA# pin has actually been
lowered to VDD before performing the verifying operation.
Signature Address
Signature Data
Vendor
Atmel
30h
58h
Architecture
C251
31h
40h
Memory
32 kilobytes EPROM or
OTPROM
60h
F7h
32 kilobytes MaskROM
or ROMless
77h
Revision
TSC80251G2D
derivative
61h
FDh
相关PDF资料 |
PDF描述 |
|---|---|
| AT80251G2D-RLTUM | IC 8051 MCU ROMLESS 44VQFP |
| TS87C51RD2-VIL | IC MCU 8051 OTP 64K 5V 68PLCC |
| PIC18LF2423-I/SP | IC PIC MCU FLASH 8KX16 28-DIP |
| PIC16LF84A-04I/SS | IC MCU FLASH 1KX14 EE 20SSOP |
| 5176916-1 | HIGH CURRENT DRAWER 24P |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT80251G2D-SLSUL | 功能描述:8位微控制器 -MCU ROMless 8/16bit 5.5V 16MHz RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| AT80251G2D-SLSUM | 功能描述:8位微控制器 -MCU ROMless 8/16bit 5V 24MHz RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| AT804 | 制造商:POSEICO 制造商全称:POSEICO 功能描述:PHASE CONTROL THYRISTOR |
| AT804S12 | 制造商:n/a 功能描述:Thyristor |
| AT804S16 | 制造商:POSEICO 制造商全称:POSEICO 功能描述:PHASE CONTROL THYRISTOR |
发布紧急采购，3分钟左右您将得到回复。