参数资料
型号: AT89C5115-TISIM
厂商: ATMEL CORP
元件分类: 微控制器/微处理器
英文描述: 8-BIT, FLASH, 40 MHz, MICROCONTROLLER, PDSO28
封装: GREEN, SOIC-28
文件页数: 86/109页
文件大小: 10824K
代理商: AT89C5115-TISIM
63
ATtiny20 [DATASHEET]
8235E–AVR–03/2013
Be aware that the COM0x[1:0] bits are not double buffered together with the compare value. Changing the COM0x[1:0]
bits will take effect immediately.
11.6
Compare Match Output Unit
The Compare Output mode (COM0x[1:0]) bits have two functions. The Waveform Generator uses the COM0x[1:0] bits
for defining the Output Compare (OC0x) state at the next Compare Match. Also, the COM0x[1:0] bits control the OC0x
pin output source. Figure 11-4 on page 63 shows a simplified schematic of the logic affected by the COM0x[1:0] bit
setting. The I/O Registers, I/O bits, and I/O pins in the figure are shown in bold. Only the parts of the general I/O Port
Control Registers (DDR and PORT) that are affected by the COM0x[1:0] bits are shown. When referring to the OC0x
state, the reference is for the internal OC0x Register, not the OC0x pin. If a system reset occur, the OC0x Register is
reset to “0”.
Figure 11-4. Compare Match Output Unit, Schematic
The general I/O port function is overridden by the Output Compare (OC0x) from the Waveform Generator if either of the
COM0x[1:0] bits are set. However, the OC0x pin direction (input or output) is still controlled by the Data Direction
Register (DDR) for the port pin. The Data Direction Register bit for the OC0x pin (DDR_OC0x) must be set as output
before the OC0x value is visible on the pin. The port override function is independent of the Waveform Generation mode.
The design of the Output Compare pin logic allows initialization of the OC0x state before the output is enabled. Note that
some COM0x[1:0] bit settings are reserved for certain modes of operation, see “Register Description” on page 69
11.6.1 Compare Output Mode and Waveform Generation
The Waveform Generator uses the COM0x[1:0] bits differently in Normal, CTC, and PWM modes. For all modes, setting
the COM0x[1:0] = 0 tells the Waveform Generator that no action on the OC0x Register is to be performed on the next
Compare Match. For compare output actions in the non-PWM modes refer to Table 11-2 on page 70. For fast PWM
mode, refer to Table 11-3 on page 70, and for phase correct PWM refer to Table 11-4 on page 70.
PORT
DDR
DQ
OCn
Pin
OCnx
DQ
Waveform
Generator
COMnx1
COMnx0
0
1
D
ATA
B
U
S
FOCn
clk
I/O
相关PDF资料
PDF描述
AT90CAN128-15MT 8-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, QCC64
ABM8-FREQ-18-R050-D-7-H-T QUARTZ CRYSTAL RESONATOR, 30 MHz - 60 MHz
ABM3B-FREQ-18-R050 QUARTZ CRYSTAL RESONATOR, 16 MHz - 60 MHz
ABM3B-FREQ-18-R070-1-X QUARTZ CRYSTAL RESONATOR, 12 MHz - 15.999 MHz
ABM3B-FREQ-18-R070-1-Z QUARTZ CRYSTAL RESONATOR, 12 MHz - 15.999 MHz
相关代理商/技术参数
参数描述
AT89C5115-TISUM 功能描述:8位微控制器 -MCU 16K Flash ADC RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
AT89C51-16AA 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-Bit Microcontroller with 4K Bytes Flash
AT89C51-16AC 功能描述:8位微控制器 -MCU Microcontroller RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
AT89C51-16AI 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-Bit Microcontroller with 4K Bytes Flash
AT89C51-16JA 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-Bit Microcontroller with 4K Bytes Flash