参数资料
| 型号： | AT90LS2343-1PI |
| 厂商： | Atmel |
| 文件页数： | 53/63页 |
| 文件大小： | 0K |
| 描述： | IC MCU 2K FLASH 1MHZ IND 8-DIP |
| 标准包装： | 50 |
| 系列： | AVR® 90LS |
| 核心处理器： | AVR |
| 芯体尺寸： | 8-位 |
| 速度： | 1MHz |
| 连通性： | SPI |
| 外围设备： | 欠压检测/复位，POR，WDT |
| 输入/输出数： | 5 |
| 程序存储器容量： | 2KB（1K x 16） |
| 程序存储器类型： | 闪存 |
| EEPROM 大小： | 128 x 8 |
| RAM 容量： | 128 x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2.7 V ~ 6 V |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页当前第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页
PIC16C433
DS41139B-page 56
Preliminary
2002 Microchip Technology Inc.
9.4
Power-on Reset (POR), Power-up
Timer (PWRT) and Oscillator Start-up
Timer (OST)
9.4.1
POWER-ON RESET (POR)
The on-chip POR circuit holds the chip in RESET until
VDD has reached a high enough level for proper oper-
ation. To take advantage of the POR, just tie the MCLR
pin through a resistor to VDD. This will eliminate exter-
nal RC components usually needed to create a Power-
on Reset. A maximum rise time for VDD is specified.
See Electrical Specifications for details.
When the device starts normal operation (exits the
RESET condition), device operating parameters (volt-
age, frequency, temperature, ...) must be met to ensure
operation. If these conditions are not met, the device
must be held in RESET until the operating conditions
are met.
For additional information, refer to Application Note
AN607, "Power-up Trouble Shooting."
9.4.2
POWER-UP TIMER (PWRT)
The Power-up Timer provides a fixed 72 ms nominal
timeout on power-up only, from the POR. The Power-
up Timer operates on an internal RC oscillator. The
chip is kept in RESET as long as the PWRT is active.
The PWRT’s time delay allows VDD to rise to an accept-
able level. A configuration bit is provided to enable/dis-
able the PWRT.
The power-up time delay will vary from chip to chip due
to VDD, temperature and process variation.
9.4.3
OSCILLATOR START-UP TIMER (OST)
The Oscillator Start-up Timer (OST) provides 1024
oscillator cycle (from OSC1 input) delay after the
PWRT delay is over. This ensures that the crystal oscil-
lator, or resonator has started and stabilized.
The OST timeout is invoked only for XT, LP and HS
modes and only on Power-on Reset or wake-up from
SLEEP.
9.4.4
TIMEOUT SEQUENCE
On power-up, the timeout Sequence is as follows: first,
PWRT timeout is invoked after the POR time delay has
expired; then, OST is activated. The total timeout will
vary, based on oscillator configuration and the status of
the PWRT. For example, in RC mode with the PWRT
disabled, there will be no timeout at all. Figure 9-7,
Figure 9-8, and Figure 9-9 depict timeout sequences
on power-up.
Since the timeouts occur from the POR pulse, if MCLR
is kept low long enough, the timeouts will expire. Then
bringing MCLR high will begin execution immediately
(Figure 9-9). This is useful for testing purposes, or to
synchronize more than one PIC16C433 device operat-
ing in parallel.
9.4.5
POWER CONTROL/STATUS REGISTER
(PCON)
The Power Control/Status Register, PCON (address
8Eh), has one bit.
Bit1 is POR (Power-on Reset). It is cleared on a Power-
on Reset and is unaffected otherwise. The user sets
this bit following a Power-on Reset. On subsequent
RESETS, if POR is ‘0’, it will indicate that a Power-on
Reset must have occurred.
TABLE 9-4:
TIMEOUT IN VARIOUS SITUATIONS
TABLE 9-5:
STATUS/PCON BITS AND THEIR SIGNIFICANCE
Legend: u = unchanged, x = unknown
Oscillator Configuration
Power-up
Wake-up from SLEEP
PWRTE = 0
PWRTE = 1
XT, HS, LP
72 ms + 1024TOSC
1024TOSC
INTRC, EXTRC
72 ms
—
POR
TO
PD
01
1
Power-on Reset
00
x
Illegal, TO is set on POR
0x
0
Illegal, PD is set on POR
10
u
WDT Reset
10
0
WDT Wake-up
1u
u
MCLR Reset during normal operation
11
0
MCLR Reset during SLEEP or interrupt Wake-up from SLEEP
相关PDF资料 |
PDF描述 |
|---|---|
| AT90LS2343-1PC | IC MCU 2K FLASH 1MHZ COM 8-DIP |
| AT89S52-24PI | IC MCU 8K FLASH 24MHZ 40-DIP |
| DSPIC33FJ32MC202-I/SS | IC DSPIC MCU/DSP 32K 28SSOP |
| PIC18LF46J13-I/ML | IC PIC MCU 64KB FLASH 44QFN |
| 52892-1890 | CONN FFC 18POS .50MM R/A ZIF SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT90LS2343-1SC | 功能描述:IC MCU 2K FLASH 1MHZ COM 8-SOIC RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:AVR® 90LS 标准包装:9 系列:87C 核心处理器:8051 芯体尺寸:8-位 速度:40/20MHz 连通性:UART/USART 外围设备:POR，WDT 输入/输出数:32 程序存储器容量:32KB（32K x 8） 程序存储器类型:OTP EEPROM 大小:- RAM 容量:256 x 8 电压 - 电源 (Vcc/Vdd):4.5 V ~ 5.5 V 数据转换器:- 振荡器型:内部 工作温度:0°C ~ 70°C 封装/外壳:40-DIP（0.600"，15.24mm） 包装:管件 |
| AT90LS2343-1SI | 功能描述:8位微控制器 -MCU 2k bit RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| AT90LS2343-4PC | 功能描述:8位微控制器 -MCU 2k bit RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| AT90LS2343-4PI | 功能描述:8位微控制器 -MCU 2k bit RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| AT90LS2343-4SC | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-Bit Microcontroller with 2K Bytes of In-System Programmable Flash |
发布紧急采购，3分钟左右您将得到回复。