参数资料
型号: AT91M55800A-33CJ-999
厂商: Atmel
文件页数: 7/28页
文件大小: 0K
描述: IC MCU 32BIT RISC 176LFBGA
标准包装: 1
系列: AT91
核心处理器: ARM7
芯体尺寸: 16/32-位
速度: 33MHz
连通性: EBI/EMI,SPI,UART/USART
外围设备: POR,WDT
输入/输出数: 58
程序存储器类型: ROMless
RAM 容量: 8K x 8
电压 - 电源 (Vcc/Vdd): 2.7 V ~ 3.6 V
数据转换器: A/D 8x10b; D/A 2x10b
振荡器型: 内部
工作温度: -40°C ~ 85°C
封装/外壳: 176-LFBGA
包装: 剪切带 (CT)
其它名称: AT91M55800A-33CJ-999CT
15
1745FS–ATARM–18-Apr-06
AT91M55800A Summary
In order to benefit the most regarding the separation of NRST and NTRST during the Debug
phase of development, the user must independently manage both signals as shown in exam-
ple (1) of Figure 7-1 above. However, once Debug is completed, both signals are easily
managed together during production as shown in example (2) of Figure 7-1 above.
7.4.3
Watchdog Reset
The watchdog can be programmed to generate an internal reset. In this case, the reset has
the same effect as the NRST pin assertion, but the BMS and NTRI pins are not sampled. Boot
Mode and Tri-state Mode are not updated. If the NRST pin is asserted and the watchdog trig-
gers the internal reset, the NRST pin has priority.
7.5
Emulation Functions
7.5.1
Tri-state Mode
The AT91M55800A provides a Tri-state Mode, which is used for debug purposes. This
enables the connection of an emulator probe to an application board without having to desol-
der the device from the target board. In Tri-state Mode, all the output pin drivers of the
AT91M55800A microcontroller are disabled.
To enter Tri-state Mode, the NTRI pin must be held low during the last 10 clock cycles before
the rising edge of NRST. For normal operation the NTRI pin must be held high during reset, by
a resistor of up to 400K Ohm.
NTRI is multiplexed with I/O line PA18 and USART 1 serial data transmit line TXD1.
Standard RS232 drivers generally contain internal 400K Ohm pull-up resistors. If TXD1 is con-
nected to a device not including this pull-up, the user must make sure that a high level is tied
on NTRI while NRST is asserted.
7.5.2
JTAG/ICE Debug Mode
ARM Standard Embedded In-Circuit Emulation is supported via the JTAG/ICE port. It is con-
nected to a host computer via an external ICE Interface. The JTAG/ICE debug mode is
enabled when JTAGSEL is low.
In ICE Debug Mode the ARM Core responds with a non-JTAG chip ID which identifies the core
to the ICE system. This is not JTAG compliant.
7.5.3
IEEE 1149.1 JTAG Boundary-scan
JTAG Boundary-scan is enabled when JTAGSEL is high. The functions SAMPLE, EXTEST
and BYPASS are implemented. There is no JTAG chip ID. The Special Function module pro-
vides a chip ID which is independent of JTAG.
It is not possible to switch directly between JTAG and ICE operations. A chip reset must be
performed (NRST and NTRST) after JTAGSEL is changed.
7.6
Memory Controller
The ARM7TDMI processor address space is 4G bytes. The memory controller decodes the
internal 32-bit address bus and defines three address spaces:
Internal memories in the four lowest megabytes
Middle space reserved for the external devices (memory or peripherals) controlled by the
EBI
相关PDF资料
PDF描述
MS3116F16-26P CONN PLUG 26POS STRAIGHT W/PINS
MS3100A24-10S CONN RCPT 7POS WALL MNT W/SCKT
MS27474T18F32P CONN RCPT 32POS JAM NUT W/PINS
D38999/20MD19SA CONN RCPT 19POS WALL MNT W/SCKT
MS27474T16B35SC CONN RCPT 55POS JAM NUT W/SCKT
相关代理商/技术参数
参数描述
AT91M55800A-33CJ-T 功能描述:IC MCU 32BIT ROMLESS 176LFBGA 制造商:microchip technology 系列:AT91 包装:带卷(TR) 零件状态:停產 核心处理器:ARM7? 核心尺寸:16/32-位 速度:33MHz 连接性:EBI/EMI,SPI,UART/USART 外设:POR,WDT I/O 数:58 程序存储容量:- 程序存储器类型:ROMless EEPROM 容量:- RAM 容量:8K x 8 电压 - 电源(Vcc/Vdd):2.7 V ~ 3.6 V 数据转换器:A/D 8x10b;D/A 2x10b 振荡器类型:内部 工作温度:-40°C ~ 85°C(TA) 封装/外壳:176-LFBGA 供应商器件封装:176-LFBGA(11.2x11.2) 基本零件编号:AT91M55800 标准包装:1,000
AT91M63200 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:AT91 ARM Thumb Microcontrollers
AT91M63200_99 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:AT91 ARM Thumb Microcontrollers
AT91M63200-12AI-1.8 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:ARM Thumb Microcontrollers
AT91M63200-25AC 功能描述:IC MCU 32BIT ROMLESS 176TQFP 制造商:microchip technology 系列:AT91SAM 包装:托盘 零件状态:停產 核心处理器:ARM7? 核心尺寸:16/32-位 速度:25MHz 连接性:EBI/EMI,SPI,UART/USART 外设:POR,WDT I/O 数:58 程序存储容量:- 程序存储器类型:ROMless EEPROM 容量:- RAM 容量:2K x 8 电压 - 电源(Vcc/Vdd):1.8 V ~ 3.6 V 数据转换器:- 振荡器类型:外部 工作温度:0°C ~ 70°C 封装/外壳:176-LQFP 供应商器件封装:176-TQFP(24x24) 基本零件编号:AT91M63200 标准包装:40