参数资料
型号: ATMEGA16A-MU
厂商: Atmel
文件页数: 7/88页
文件大小: 0K
描述: MCU AVR 16K FLASH 16MHZ 44-QFN
产品培训模块: MCU Product Line Introduction
megaAVR Introduction
标准包装: 360
系列: AVR® ATmega
核心处理器: AVR
芯体尺寸: 8-位
速度: 16MHz
连通性: I²C,SPI,UART/USART
外围设备: 欠压检测/复位,POR,PWM,WDT
输入/输出数: 32
程序存储器容量: 16KB(8K x 16)
程序存储器类型: 闪存
EEPROM 大小: 512 x 8
RAM 容量: 1K x 8
电压 - 电源 (Vcc/Vdd): 2.7 V ~ 5.5 V
数据转换器: A/D 8x10b
振荡器型: 内部
工作温度: -40°C ~ 85°C
封装/外壳: 44-VFQFN 裸露焊盘
包装: 托盘
配用: ATSTK600-ND - DEV KIT FOR AVR/AVR32
ATSTK500-ND - PROGRAMMER AVR STARTER KIT
2009 Microchip Technology Inc.
DS41288F-page 107
PIC16F610/616/16HV610/616
11.0
VOLTAGE REGULATOR
The PIC16HV610/16HV616 include a permanent
internal 5 volt (nominal) shunt regulator in parallel with
the VDD pin. This eliminates the need for an external
voltage
regulator
in
systems
sourced
by
an
unregulated supply. All external devices connected
directly to the VDD pin will share the regulated supply
voltage and contribute to the total VDD supply current
(ILOAD).
11.1
Regulator Operation
A shunt regulator generates a specific supply voltage
by creating a voltage drop across a pass resistor RSER.
The voltage at the VDD pin of the microcontroller is
monitored and compared to an internal voltage refer-
ence. The current through the resistor is then adjusted,
based on the result of the comparison, to produce a
voltage drop equal to the difference between the supply
voltage VUNREG and the VDD of the microcontroller.
See Figure 11-1 for voltage regulator schematic.
FIGURE 11-1:
VOLTAGE REGULATOR
An external current limiting resistor, RSER, located
between the unregulated supply, VUNREG, and the VDD
pin, drops the difference in voltage between VUNREG
and VDD. RSER must be between RMAX and RMIN as
defined by Equation 11-1.
EQUATION 11-1:
RSER LIMITING RESISTOR
11.2
Regulator Considerations
The supply voltage VUNREG and load current are not
constant. Therefore, the current range of the regulator
is limited. Selecting a value for RSER must take these
three factors into consideration.
Since the regulator uses the band gap voltage as the
regulated voltage reference, this voltage reference is
permanently enabled in the PIC16HV610/16HV616
devices.
Feedback
VDD
VSS
CBYPASS
RSER
VUNREG
ISUPPLY
ISHUNT
ILOAD
RMAX =
(VUMIN - 5V)
1.05 (4 MA + ILOAD)
RMIN =
(VUMAX - 5V)
0.95 (50 MA)
Where:
RMAX = maximum value of RSER (ohms)
RMIN
= minimum value of RSER (ohms)
VUMIN = minimum value of VUNREG
VUMAX = maximum value of VUNREG
VDD
= regulated voltage (5V nominal)
ILOAD = maximum expected load current in mA
including I/O pin currents and external
circuits connected to VDD.
1.05
= compensation for +5% tolerance of RSER
0.95
= compensation for -5% tolerance of RSER
相关PDF资料
PDF描述
862434-6 CONN PLUG 2POS KIT
VE-JTV-IX-B1 CONVERTER MOD DC/DC 5.8V 75W
VI-JTY-IX-F1 CONVERTER MOD DC/DC 3.3V 49.5W
ATMEGA16A-AU MCU AVR 16K FLASH 16MHZ 44-TQFP
VE-JTT-IX-B1 CONVERTER MOD DC/DC 6.5V 75W
相关代理商/技术参数
参数描述
ATMEGA16A-MUR 功能描述:8位微控制器 -MCU AVR 16KB FLASH 512B EE 1KB SRAM-16MHZ RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA16A-PU 功能描述:8位微控制器 -MCU 16KB In-system Flash 2.7V - 5.5V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA16HVA 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:8-bit Microcontroller with 8K/16K Bytes In-System Programmable Flash
ATMEGA16HVA-4CKU 功能描述:8位微控制器 -MCU 16KB Flash Memory 1.8V - 9.0V Supply RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA16HVA-4CKUR 功能描述:8位微控制器 -MCU AVR batman 16KB FLSH 4 MHZ,LGA,GRN1.8-9V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT