参数资料
| 型号： | ATMEGA48-20MMU |
| 厂商： | Atmel |
| 文件页数： | 17/36页 |
| 文件大小： | 0K |
| 描述： | IC AVR MCU 4K FLASH 20MHZ 28QFN |
| 产品培训模块： | MCU Product Line Introduction megaAVR Introduction |
| 标准包装： | 490 |
| 系列： | AVR® ATmega |
| 核心处理器： | AVR |
| 芯体尺寸： | 8-位 |
| 速度： | 20MHz |
| 连通性： | I²C，SPI，UART/USART |
| 外围设备： | 欠压检测/复位，POR，PWM，WDT |
| 输入/输出数： | 23 |
| 程序存储器容量： | 4KB（2K x 16） |
| 程序存储器类型： | 闪存 |
| EEPROM 大小： | 256 x 8 |
| RAM 容量： | 512 x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 数据转换器： | A/D 8x10b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 28-VFQFN 裸露焊盘 |
| 包装： | 托盘 |
| 产品目录页面： | 613 (CN2011-ZH PDF) |
| 配用： | ATSTK600-TQFP32-ND - STK600 SOCKET/ADAPTER 32-TQFP ATSTK600-ND - DEV KIT FOR AVR/AVR32 ATAVRDRAGON-ND - KIT DRAGON FLASH MEM AVR ATAVRISP2-ND - PROGRAMMER AVR IN SYSTEM ATJTAGICE2-ND - AVR ON-CHIP D-BUG SYSTEM |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
24
2545TS–AVR–05/11
ATmega48/88/168
11.1.4
Rev A
Part may hang in reset
Wrong values read after erase only operation
Watchdog timer interrupt disabled
Start-up time with crystal oscillator is higher than expected
High power consumption in power-down with external clock
Asynchronous oscillator does not stop in power-down
Interrupts may be lost when writing the timer registers in the asynchronous timer
1.
Part may hang in reset
Some parts may get stuck in a reset state when a reset signal is applied when the internal
reset state-machine is in a specific state. The internal reset state-machine is in this state for
approximately 10ns immediately before the part wakes up after a reset, and in a 10ns win-
dow when altering the system clock prescaler. The problem is most often seen during In-
System Programming of the device. There are theoretical possibilities of this happening also
in run-mode. The following three cases can trigger the device to get stuck in a reset-state:
- Two succeeding resets are applied where the second reset occurs in the 10ns window
before the device is out of the reset-state caused by the first reset.
- A reset is applied in a 10ns window while the system clock prescaler value is updated by
software.
- Leaving SPI-programming mode generates an internal reset signal that can trigger this
case.
The two first cases can occur during normal operating mode, while the last case occurs only
during programming of the device.
Problem fix/workaround
The first case can be avoided during run-mode by ensuring that only one reset source is
active. If an external reset push button is used, the reset start-up time should be selected
such that the reset line is fully debounced during the start-up time.
The second case can be avoided by not using the system clock prescaler.
The third case occurs during In-System programming only. It is most frequently seen when
using the internal RC at maximum frequency.
If the device gets stuck in the reset-state, turn power off, then on again to get the device out
of this state.
2.
Wrong values read after erase only operation
At supply voltages below 2.7V, an EEPROM location that is erased by the Erase Only oper-
ation may read as programmed (0x00).
Problem fix/workaround
If it is necessary to read an EEPROM location after Erase Only, use an Atomic Write opera-
tion with 0xFF as data in order to erase a location. In any case, the Write Only operation can
be used as intended. Thus no special considerations are needed as long as the erased loca-
tion is not read before it is programmed.
相关PDF资料 |
PDF描述 |
|---|---|
| ATTINY43U-SU | MCU AVR 4K FLASH 8MHZ 20-SOIC |
| ATMEGA48-20PU | IC AVR MCU 4K 20MHZ 5V 28DIP |
| 308237951000200 | COVER ASSMBLY FOR DIN CONN |
| ATMEGA48V-10PU | IC AVR MCU 4K 10MHZ 1.8V 28DIP |
| ATSAM3N00AA-MU | IC MCU 16KB CORTEX-M3 48-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ATmega48-20MU | 功能描述:8位微控制器 -MCU 4kB Flash 0.256kB EEPROM 23 I/O Pins RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| ATMEGA48-20MUR | 功能描述:8位微控制器 -MCU AVR 4KB FLSH 256B EE 512B EE-20MHZ 5V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| ATMEGA4820PI | 制造商:Atmel Corporation 功能描述: |
| ATmega48-20PI | 功能描述:8位微控制器 -MCU AVR 4K FLSH 256B EE 512B SRAM ADC 5V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| ATMEGA48-20PJ | 功能描述:IC AVR MCU 4K 5V 20MHZ 28-DIP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:AVR® ATmega 标准包装:9 系列:87C 核心处理器:8051 芯体尺寸:8-位 速度:40/20MHz 连通性:UART/USART 外围设备:POR，WDT 输入/输出数:32 程序存储器容量:32KB（32K x 8） 程序存储器类型:OTP EEPROM 大小:- RAM 容量:256 x 8 电压 - 电源 (Vcc/Vdd):4.5 V ~ 5.5 V 数据转换器:- 振荡器型:内部 工作温度:0°C ~ 70°C 封装/外壳:40-DIP（0.600"，15.24mm） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。