- 您现在的位置：买卖IC网 > Datasheet目录314 > ATSTK600 (Atmel)DEV KIT FOR AVR/AVR32 Datasheet资料下载
参数资料
| 型号： | ATSTK600 |
| 厂商： | Atmel |
| 文件页数： | 41/61页 |
| 文件大小： | 0K |
| 描述： | DEV KIT FOR AVR/AVR32 |
| 其它有关文件： | STK600 Socket Pkg Selection Guide |
| 产品培训模块： | ATmega128RFA1 Wireless MCU MCU Product Line Introduction |
| 标准包装： | 1 |
| 系列： | AVR® |
| 类型： | MCU |
| 适用于相关产品： | Atmel AVR 设备 |
| 所含物品： | 板，线缆 |
| 产品目录页面： | 615 (CN2011-ZH PDF) |
| 配用： | ATSTK600-ATTINY10-ND - STK600-ATTINY10 SOCKET PACKAGE |
| 相关产品： | SAM8734-ND - IDC CABLE F-F 6POS 6 LONG ATTINY87-SU-ND - IC MCU AVR 8K FLASH 20SOIC ATTINY167-SU-ND - IC MCU AVR 16K FLASH 20SOIC ATMEGA64C1-15MZTR-ND - MCU AVR 64KB FLASH CAN 32-VQFN ATMEGA64C1-15AZTR-ND - MCU AVR 64KB FLASH CAN 32TQFP ATMEGA64M1-15MZTR-ND - MCU AVR 64KB FLASH 3PSC 32-VQFN ATMEGA64M1-15AZTR-ND - MCU AVR 64KB FLASH 3PSC 32TQFP ATMEGA644P-A15AZTR-ND - MCU AVR 64KB FLASH 16MHZ 44TQFP ATMEGA644P-A15MZTR-ND - MCU AVR 64KB FLASH 16MHZ 44QFN ATMEGA324P-A15MZTR-ND - MCU AVR 32KB FLASH 15MHZ 44-VQFN 更多... |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页当前第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页
AVR079
11.2 PARAM_SW_MAJOR
The PARAM_SW_MAJOR and PARAM_SW_MINOR returns the firmware version of
the master mcu.
11.3 PARAM_SW_MINOR
See PARAM_SW_MAJOR.
11.4 PARAM_VTARGET
The parameter value is voltage in volts x10, i.e. a parameter value of 42 (decimal)
corresponds to 4.2V.
Note: This parameter cannot be set when the STK600 is in programming mode.
The maximum target voltage level is dependant on what target routing/socket board is
mounted.
To find the maximum allowable target voltage the board-id must be read before
setting a new voltage.
The maximum voltage for the board is found in “targetboard.xml”
11.5 PARAM_STATUS_TGT_CONN
This parameter returns the
same
status
value
as
CMD_CHECK_TARGET_CONNECTION.
See chapter 3.9
The difference between using the command and the GET_PARAM is that bits 4-5 are
only updated after the command has been run.
11.6 PARAM2_SCK_DURATION
This is a two-byte value, which sets the ISP frequency.
When using the ISP programming interface, the ISP clock frequency must not exceed
what the target device supports. (The maximum ISP clock frequency depends on the
device system clock, internal clock division etc.)
The STK600 supports ISP frequencies from 1953 Hz up to 8.0 MHz. The value for
PARAM_SCK_DURATION can be found using the following algorithm:
unsigned int CalcSckDur(int freq)
{
sck_dur = ceil((16e6/(2*freq))-1);
return __min(4096, sck_dur);
// 4096 is an illegal value
}
11.7 PARAM_CONTROLLER_INIT
This parameter is internally set to 0 when the programmer MCU resets. The host
software can write any value it wants to this parameter, and it can be read back later.
41
8133A-AVR-04/08
相关PDF资料 |
PDF描述 |
|---|---|
| ATXMEGAB1-XPLD | KIT EVAL FOR ATXMEGAB1 |
| AUIR2085S | IC DVR HALF-BRDG SELF OSC 8SOIC |
| AUIRS2003S | IC DRVIER HALF-BRIDGE 8SOIC |
| AUIRS2004S | IC DRVIER HALF-BRIDGE 8SOIC |
| AUIRS2112S | IC DRIVER HIGH/LOW SIDE 16SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ATSTK600-ATMEGA2560 | 功能描述:插座和适配器 STK600 DEVICECARD ATMEGA2560 RoHS:否 制造商:Silicon Labs 产品:Adapter 用于:EM35x |
| ATSTK600-ATTINY10 | 功能描述:插座和适配器 STK600 adaptercard for ATtiny10 RoHS:否 制造商:Silicon Labs 产品:Adapter 用于:EM35x |
| ATSTK600-DIP40 | 功能描述:插座和适配器 SOCKET ADAPTER CARD FOR ATSTK600 RoHS:否 制造商:Silicon Labs 产品:Adapter 用于:EM35x |
| ATSTK600-LCD160 | 功能描述:子卡和OEM板 STK600 LCD EXTENSION CARD FOR megaAVR RoHS:否 制造商:BeagleBoard by CircuitCo 产品:BeagleBone LCD4 Boards 用于:BeagleBone - BB-Bone - Open Source Development Kit |
| ATSTK600-LCDX | 功能描述:子卡和OEM板 STK600 LCD FOR XMEGAB RoHS:否 制造商:BeagleBoard by CircuitCo 产品:BeagleBone LCD4 Boards 用于:BeagleBone - BB-Bone - Open Source Development Kit |
发布紧急采购，3分钟左右您将得到回复。