参数资料
型号: ATTINY13A-SFR
厂商: Atmel
文件页数: 3/67页
文件大小: 0K
描述: IC MCU AVR 1K FLASH 8SOIC
产品培训模块: MCU Product Line Introduction
tinyAVR Introduction
标准包装: 1
系列: AVR® ATtiny
核心处理器: AVR
芯体尺寸: 8-位
速度: 20MHz
外围设备: 欠压检测/复位,POR,PWM,WDT
输入/输出数: 6
程序存储器容量: 1KB(512 x 16)
程序存储器类型: 闪存
EEPROM 大小: 64 x 8
RAM 容量: 64 x 8
电压 - 电源 (Vcc/Vdd): 1.8 V ~ 5.5 V
数据转换器: A/D 4x10b
振荡器型: 内部
工作温度: -40°C ~ 125°C
封装/外壳: 8-SOIC(0.209",5.30mm 宽)
包装: 标准包装
其它名称: ATTINY13A-SFRDKR
11
8126F–AVR–05/12
ATtiny13A
Figure 4-3.
The X-, Y-, and Z-registers
In the different addressing modes these address registers have functions as fixed displacement,
automatic increment, and automatic decrement (see the instruction set reference for details).
4.5
Stack Pointer
The Stack is mainly used for storing temporary data, for storing local variables and for storing
return addresses after interrupts and subroutine calls. The Stack Pointer Register always points
to the top of the Stack. Note that the Stack is implemented as growing from higher memory loca-
tions to lower memory locations. This implies that a Stack PUSH command decreases the Stack
Pointer.
The Stack Pointer points to the data SRAM Stack area where the Subroutine and Interrupt
Stacks are located. This Stack space in the data SRAM is automaticall defined to the last
address in SRAM during power on reset. The Stack Pointer must be set to point above 0x60.
The Stack Pointer is decremented by one when data is pushed onto the Stack with the PUSH
instruction, and it is decremented by two when the return address is pushed onto the Stack with
subroutine call or interrupt. The Stack Pointer is incremented by one when data is popped from
the Stack with the POP instruction, and it is incremented by two when data is popped from the
Stack with return from subroutine RET or return from interrupt RETI.
The AVR Stack Pointer is implemented as two 8-bit registers in the I/O space. The number of
bits actually used is implementation dependent. Note that the data space in some implementa-
tions of the AVR architecture is so small that only SPL is needed. In this case, the SPH Register
will not be present.
4.5.1
SPL – Stack Pointer Low
15
XH
XL
0
X-register
70
7
0
R27 (0x1B)
R26 (0x1A)
15
YH
YL
0
Y-register
70
7
0
R29 (0x1D)
R28 (0x1C)
15
ZH
ZL
0
Z-register
7
070
R31 (0x1F)
R30 (0x1E)
Bit
76543210
SP7
SP6
SP5
SP4
SP3
SP2
SP1
SP0
SPL
Read/Write
R/W
Initial Value
10011111
相关PDF资料
PDF描述
PCA9539PW,118 IC I/O EXPANDER I2C 16B 24TSSOP
ATTINY13A-MUR MCU AVR 1KB FLASH 20MHZ 20QFN
480142-3 CONN HOUSING 22POS W/MOUNT EARS
530521-7 HIGH CURRENT HSG 9 POS
480110-2 HSG AMP LEAF 15 POS
相关代理商/技术参数
参数描述
ATTINY13A-SH 功能描述:8位微控制器 -MCU AVR 1KB, 64B EE 20MHz 64B SRAM RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATTINY13A-SHR 功能描述:8位微控制器 -MCU AVR 1KB FLSH 64B EE SRAM-20MHz NiPdAu RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATTINY13A-SN 功能描述:8位微控制器 -MCU 1KB FLASH 64B EE 64B SRAM 20MHz RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATTINY13A-SNR 功能描述:8位微控制器 -MCU AVR 1KB FL 64B EE 64B SRAM 20MHz GRN RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATTINY13A-SS7 功能描述:8位微控制器 -MCU AVR 1KB FLSH 64B EE 64B SRAM+105C NiPdAu RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT