参数资料
型号: AUIPS71411GTR
厂商: International Rectifier
文件页数: 6/14页
文件大小: 0K
描述: IC SW IPS 1CH HIGH SIDE 8SOIC
标准包装: 2,500
类型: 高端,电流感应
输入类型: 非反相
输出数: 1
导通状态电阻: 75 毫欧
电流 - 输出 / 通道: 1.5A
电流 - 峰值输出: 7A
电源电压: 3 V ~ 4.5 V
工作温度: -40°C ~ 150°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SO
包装: 带卷 (TR)
AUIPS71411G
Truth Table
Op. Conditions
Normal mode
Normal mode
Open load
Open load
Short circuit to GND
Short circuit to GND
Over temperature
Over temperature
Input
H
L
H
L
H
L
H
L
Output
L
H
L
H
L
L
L
L
Ifb pin voltage
0V
I load x Rfb / Ratio
0V
0V
0V
V fault (latched)
0V
V fault (latched)
Operating voltage
Maximum Vcc voltage : this is the maximum voltage before the breakdown of the IC process.
Operating voltage : This is the Vcc range in which the functionality of the part is guaranteed. The Q100 qualification is
run at the maximum operating voltage specified in the datasheet.
Reverse battery
During the reverse battery the Mosfet is kept off and the load current is flowing into the body diode of the power Mosfet.
Power dissipation in the IPS : P = I load * Vf
If the power dissipation is too high in Rifb, a diode in serial can be added to block the current.
The transistor used to pull-down the input should be a bipolar in order to block the reverse current. The 100ohm input
resistor can not sustain continuously 16V (see Vcc-Vin max. in the Absolute Maximum Ratings section)
Active clamp
The purpose of the active clamp is to limit the voltage across the MOSFET to a value below the body diode break down
voltage to reduce the amount of stress on the device during switching.
The temperature increase during active clamp can be estimated as follows:
? Tj ? P CL ? Z TH ( t CLAMP )
Where: Z TH ( t CLAMP ) is the thermal impedance at t CLAMP and can be read from the thermal impedance curves given in the
data sheets.
P CL ? V CL ? I CLavg : Power dissipation during active clamp
V CL ? 65V : Typical V CLAMP value.
I CLavg ?
I CL : Average current during active clamp
2
t CL ?
I CL : Active clamp duration
di
dt
di
dt
?
V Battery ? V CL : Demagnetization current
L
Figure 9 gives the maximum inductance versus the load current in the worst case : the part switch off after an over
temperature detection. If the load inductance exceed the curve, a free wheeling diode is required.
Over-current protection
The threshold of the over-current protection is set in order to guaranteed that the device is able to turn on a load with an
inrush current lower than the minimum of Isd. Nevertheless for high current and high temperature the device may switch
off for a lower current due to the over-temperature protection (see Figure 11).
www.irf.com
6
相关PDF资料
PDF描述
AUIPS7145RTR IC SW IPS 1CH HIGH SIDE DPAK-5
AUIPS7221R IC PWM IPS HIGH SIDE DPAK-5
AUIR3313S IC DVR CURR SENSE PROG D2PAK-5
AUIR3314S IC DVR CURR SENSE PROG D2PAK-5
AUIR3315STRR IC DVR CURR SENSE PROG D2PAK-5
相关代理商/技术参数
参数描述
AUIPS7141R 功能描述:功率驱动器IC CURRNT High Side 100mOhms 5A 65V RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
AUIPS7141RTR 功能描述:功率驱动器IC CURRNT High Side 100mOhms 5A 65V RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
AUIPS7141RTRL 功能描述:功率驱动器IC CURRNT High Side 100mOhms 5A 65V RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
AUIPS7141RTRR 功能描述:功率驱动器IC CURRNT High Side 100mOhms 5A 65V RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube
AUIPS7142G 功能描述:功率驱动器IC AUTO PWR SWITCH 2 CH 100mOhms 20A 65V RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube