参数资料
| 型号： | BD8963EFJ-E2 |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 14/23页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 3A 8HTSOP |
| 标准包装： | 1 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1 V ~ 2.5 V |
| 输入电压： | 2.7 V ~ 5.5 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 1MHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 是 |
| 工作温度： | -25°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 标准包装 |
| 供应商设备封装： | 8-HTSOP-J |
| 其它名称： | BD8963EFJ-E2DKR |
BD8963EFJ
Datasheet
4. Determination of RCOMP, CCOMP that works as a phase compensator
As the Current Mode Control is designed to limit a inductor current, a pole (phase lag) appears in the low frequency area
due to a CR filter consisting of a output capacitor and a load resistance, while a zero (phase lead) appears in the
high frequency area due to the output capacitor and its ESR. So, the phases are easily compensated by adding a
zero to the power amplifier output with C and R as described below to cancel a pole at the power amplifier.
fp(Min.)
fp=
fz (ESR) =
Gain
[dB]
A
0
I OUT Min.
fp(Max.)
I OUT Max.
fz(ESR)
1
2 π× R O × C O
1
2 π× E SR × C O
Pole at power amplifier
fp (Min.) =
[Hz] ← with lighter load
Phase
[deg]
0
-90
When the output current decreases, the load resistance Ro
increases and the pole frequency lowers.
1
2 π× R OMax. × C O
Fig.29 Open loop gain characteristics
fp (Max.) =
1
2 π× R OMin. × C O
[Hz] ← with heavier load
fz (Amp.) =
Gain
[dB]
Phase
[deg]
A
0
0
-90
fz(Amp.)
Zero at power amplifier
Increasing capacitance of the output capacitor lowers the pole
frequency while the zero frequency does not change. (This is
because when the capacitance is doubled, the capacitor ESR
reduces to half.)
1
2 π× R ITH × C ITH
Fig.30 Error amp phase compensation characteristics
V CC
Cin
EN
V CC
SW
L
V OUT
V OUT
ADJ
COMP
GND
ESR
C O
R O
R COMP
C COMP
Fig.31 Typical application
Stable feedback loop may be achieved by canceling the pole fp (Min.) produced by the output capacitor and the load
resistance with CR zero correction by the error amplifier.
fz (Amp.) = fp (Min.)
1
2 π× R COMP × C COMP
=
1
2 π× R OMax. × C O
www.rohm.com
?2012 ROHM Co., Ltd. All rights reserved.
TSZ22111 ? 15 ? 001
14/21
TSZ02201-0J3J0AJ00040-1-2
02.MAR.2012 Rev.001
相关PDF资料 |
PDF描述 |
|---|---|
| BD8964FVM-TR | IC REG BUCK SYNC ADJ 1.2A MSOP8 |
| BD8966FVM-TR | IC REG BUCK SYNC ADJ 0.8A MSOP8 |
| BD91361MUV-E2 | IC REG BUCK SYNC ADJ 4A 20VQFN |
| BD9137MUV-E2 | IC REG BUCK SYNC ADJ 4A 20VQFN |
| BD9139MUV-E2 | IC REG BUCK SYNC ADJ 3A 16VQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BD8964FVM | 制造商:ROHM 制造商全称:Rohm 功能描述:4.0V to 5.5V, 1.2A 1ch Synchronous Buck Converter Integrated FET |
| BD8964FVM_12 | 制造商:ROHM 制造商全称:Rohm 功能描述:4.0V to 5.5V, 1.2A 1ch Synchronous Buck Converter Integrated FET |
| BD8964FVM-TR | 功能描述:IC REG BUCK SYNC ADJ 1.2A MSOP8 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:500 系列:- 类型:切换式电容器（充电泵），反相 输出类型:固定 输出数:1 输出电压:-3V 输入电压:2.3 V ~ 5.5 V PWM 型:Burst Mode? 频率 - 开关:900kHz 电流 - 输出:100mA 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-6 细型，TSOT-23-6 包装:带卷 (TR) 供应商设备封装:TSOT-23-6 其它名称:LTC1983ES6-3#TRMTR |
| BD8966FVM | 制造商:ROHM 制造商全称:Rohm 功能描述:4.0V to 5.5V, 0.8A 1ch Synchronous Buck Converter integrated FET |
| BD8966FVM_10 | 制造商:ROHM 制造商全称:Rohm 功能描述:Low Noise High Efficiency Step-down Switching Regulator with Built-in Power MOSFET |
发布紧急采购，3分钟左右您将得到回复。