- 您现在的位置：买卖IC网 > PDF目录14467 > BD9701T (Rohm Semiconductor)IC REG BUCK ADJ 1.5A TO220FP PDF资料下载
参数资料
| 型号： | BD9701T |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 9/19页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 1.5A TO220FP |
| 标准包装： | 500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1 V ~ 32 V |
| 输入电压： | 8 V ~ 36 V |
| 频率 - 开关： | 100kHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | TO-220-5 整包 |
| 包装： | 散装 |
| 供应商设备封装： | TO-220FP-5 |
| 产品目录页面： | 1373 (CN2011-ZH PDF) |
BD9701FP/CP-V5/T/T-V5,BD9703FP/CP-V5/T/T-V5,BD9702CP-V5/T/T-V5
● Notes for PCB layout
C5
Technical Note
R2 : 1kO
4
R1 : 4kO
INV
STBY 5
1 VCC
OUT 2
L1
5.0V
C1
C2
GND
3
D1
C4
C3
Fig.30 Layout
? Place capacitors between VCC and Ground, and the Schottky diode as close as possible to the IC to reduce noise and
maximize efficiency.
? Connect resistors between INV and Ground, and the output capacitor filter at the same Ground potential in order to stabilize
the output voltage.
● Application component selection and settings
Inductor L1
If the winding resistance of the choke coil is too high, the efficiency may deteriorate.
As the overcurrent protection operates over minimum 1.6A (BD9701FP/CP-V5/T/T-V5, BD9703FP/CP-V5/T-V5) or 3.2A
minimum (BD9701CP-V5/T/T-V5), attention must be paid to the heating of the inductor due to overload of short-circulated
load.
Note that the current rating for the coil should be higher than I OUT (MAX) ＋ ⊿ IL .
Iout (MAX): maximum load current
1
If you flow more than maximum current rating, coil will become overload, and cause magnetic saturation, and those
account for efficiency deterioration. Select from enough current rating of coil which doesn’t over peak current.
(VCC-VOUT) VOUT
⊿IL . = × ×
L1 VCC fosc
L1:inductor value, VCC:maximum input voltage, VOUT:output voltage, ⊿ IL:coil ripple current value, fosc:oscillation
frequency
Shottky Barrier Diodes D1
A Schottky diode with extremely low forward voltage should be used. Selection should be based on the following
guidelines regarding maximum forward current, reverse voltage, and power dissipation:
? The maximum current rating is higher than the combined maximum load current and coil ripple current ( ⊿ I L ).
? The reverse voltage rating is higher than the VIN value.
? Power dissipation for the selected diode must be within the rated level.
The power dissipation of the diode is expressed by the following formula:
Pdi=Iout(MAX)×Vf×(1-VOUT/VCC)
Iout (MAX): maximum load current, Vf: forward voltage, VOUT: output voltage, VCC: input voltage
Capacitor C1,C2,C3,C4,C5
As large ripple currents flow across C1 and C3 capacitors, high frequency and low impedance capacitor for a switching
regulator must be used. The ceramic capacitor C2 must be connected. If not, noise may cause an abnormal operation. If
the ripple voltage of input and output is large, C4 selected among ceramic , tantalum and OS capacitor with low ESR may
decrease the ripple, however if the only low ESR capacitor is used, an oscillation or unstable operation may be caused.
C5 is the capacitor for phase compensation and normally not used. If you need to improve the stability of feedback
network, connect C5 between INV and OUTPUT.
Feed back resistance R1,R2
The offset of output voltage is determined by both Feed back resistance and INV pin input current.
VOUT=(R1+R2) VINV/R2 (VINV pin Threshold Votage)
If Feed back resistance is high, the setting of output voltage will be move.
Recommended : Resistance between INV pin and GND = less than 10k ? .
www.rohm.com
? 2009 ROHM Co., Ltd. All rights reserved.
9/16
2009.04- Rev.B
相关PDF资料 |
PDF描述 |
|---|---|
| ECM12DRMD-S273 | CONN EDGECARD 24POS .156 WW |
| GSM15DSEI-S243 | CONN EDGECARD 30POS .156 EYELET |
| LP331M450H5P3 | CAP ALUM 330UF 450V 20% SNAP |
| ESM12DSEF-S243 | CONN EDGECARD 24POS .156 EYELET |
| GBM28DTBT-S189 | CONN EDGECARD 56POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BD9701T-V5 | 功能描述:直流/直流开关调节器 DC/DC CONV4-35V 5PIN RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| BD9702CP-V5 | 制造商:ROHM Semiconductor 功能描述:Reg,Simple Back,Vo=1.0to32V,TO220CP-V5 |
| BD9702CP-V5E2 | 功能描述:直流/直流开关调节器 SWITCHING POWER RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| BD9702T | 功能描述:直流/直流开关调节器 IC SW 1CHAN 3A RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| BD9702T-V5 | 制造商:ROHM Semiconductor 功能描述: |
发布紧急采购，3分钟左右您将得到回复。