- 您现在的位置：买卖IC网 > PDF目录17830 > BZ019A333ZSB (AVX Corporation)CAP SUPER 33MF 9V BZ01 SMD PDF资料下载
参数资料
| 型号： | BZ019A333ZSB |
| 厂商： | AVX Corporation |
| 文件页数： | 19/26页 |
| 文件大小： | 0K |
| 描述： | CAP SUPER 33MF 9V BZ01 SMD |
| 标准包装： | 100 |
| 系列： | BestCap® BZ |
| 电容： | 33mF |
| 电压 - 额定： | 9V |
| 容差： | -20%，+80% |
| ESR（等效串联电阻）： | 250 毫欧 |
| 寿命@温度： | 70°C 时为 1000 小时 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | BZ01，3 引线 |
| 包装： | 散装 |
| 尺寸/尺寸： | 1.102" L x 0.669" W（28.00mm x 17.00mm） |
| 高度 - 座高（最大）： | 0.236"（6.00mm） |
| 工作温度： | -20°C ~ 70°C |
| 其它名称： | 478-6269 |
BestCap Ultra-low ESR
?
High Power Pulse Supercapacitors
SECTION 3.4: QUALIFICATION TEST SUMMARY
Test
Initial Capacitance
Measurement
Test Method
Charge to test voltage at room temperature. Disconnect parts from
voltage to remove charging effects. Discharge cells with a constant current
Parameter
Capacitance (Cap)
Limits
+80% / -20%
of rated Cap
(4 mA) noting voltage and time 1 and 2 seconds after beginning discharge.
C = I * dt/dv
Initial DCL
Measurement
Charge to test voltage at room temperature. Disconnect parts from
voltage to remove charging effects. Note voltage and time 5 minutes
Leakage Current (DCL)
Within Limit
and 25 minutes after disconnecting. I = C * dV/dt
Initial ESR
Measurement
Load Life
Shelf Life
Humidity Life
Leg pull strength
Surge Voltage
Measurement frequency @ 1kHz; Measurement voltage @ 10 mV
at room temperature
Apply test voltage at 70oC for 1000 hours. Allow to cool to room
temperature and measure Cap, DCL and ESR
Maintain at 70oC for 1000 hours with no voltage applied. Allow to
cool to room temperature and measure Cap, DCL and ESR.
Maintain at 40°C / 95% RH for 1000 hours. Allow to cool to room
temperature and measure Cap, DCL and ESR.
Apply an increasing force in shear mode until leg pulls away
Step
Equivalent Series
Resistance (ESR)
DCL
Cap
ESR
DCL
Cap
ESR
DCL
Cap
ESR
Yield Force
(A and L leads only)
+20% / -50%
of typical value
< 2.0x rated max.
> 0.7x rated
< 3.0x rated
< 1.5x rated max.
> 0.7x rated
< 2.0x rated
< 1.5x rated max.
> 0.7x rated
< 1.5x rated
Not less than
25 pounds shear
Temperature Cycling
Temperature
1
2
3
Step
1
2
3
Step
Apply 125% of the rated voltage for 10 seconds
Short the cell for 10 minutes
Repeat 1 and 2 for 1000 cycles
Ramp oven down to –20°C and then hold for 15 min.
Ramp oven up to 70oC and then hold for 15 min.
Repeat 1 and 2 for 100 cycles
Temp Soak Time (prior to test)
DCL
Cap
ESR
DCL
Cap
ESR
< 1.5x rated max.
> 0.7x rated
< 1.5x rated
< 1.5x rated max.
> 0.7x rated
< 1.5x rated
Characteristics
1
-40°C 4 hours
DCL
2
3
Measure Cap, ESR, DCL (-40oC rated parts only)
-20°C 4 hours
Measure Cap, ESR, DCL
-10°C 4 hours
Measure Cap, ESR, DCL
70°C
Cap
< 10x rated
4
0°C 4 hours
25°C
> 80% rated
Measure Cap, ESR, DCL
5
25°C 4 hours
ESR
Measure Cap, ESR, DCL
-40°C
< 20x rated
6
7
8
40°C 4 hours
Measure Cap, ESR, DCL
60°C 4 hours
Measure Cap, ESR, DCL
70°C 4 hours
-20°C
-10°C
70°C
< 5x rated
< 4x rated
< 1.3x rated
< 1.3x rated
Measure Cap, ESR, DCL
Thermal Shock
Step
1
2
Place cells into an oven at –20°C for 30 minutes
In less than 15 seconds, move cells into a
DCL
Cap
< 2.0x rated max.
> 0.7x rated
70oC oven for 30 minutes
Vibration
3
Step
1
2
Repeat 1 and 2 for 100 cycles
Apply a harmonic motion that is deflected 0.03 inches
Vary frequency from 10 cycles per second to
ESR
DCL
Cap
< 2.0x rated max.
< 2.0x rated max.
> 0.7x rated
55 cycles at a ramp rate of 1 Hz per minute
3
4
5
Vibrate the cells in the X-Y direction for three hours
Vibrate the cells in the Z direction for three hours
Measure Cap, ESR and DCL
ESR
< 2.0x rated max.
18
相关PDF资料 |
PDF描述 |
|---|---|
| CTZ3E-03A-W1-PF | CAP TRIMMER 1-3PF 25V SMD |
| PV36Y100C01B00 | TRIMMER 10 OHM 0.5W TH |
| 3364B-1-502E | TRIMMER 5K OHM 0.2W SMD |
| BZ015B603ZSB | CAP SUPER 60MF 5.5V BZ01 SMD |
| 500SEAF-ACF | OSC PROG CMOS 2.5V 150PPM OE SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BZ019A333ZSBAJ | 功能描述:超级电容/超级电容器 9volts 33MF 80 -20% RoHS:否 制造商:Murata 电容:350 mF 容差: 电压额定值:4.2 V ESR:60 mOhms 工作温度范围:- 30 C to + 70 C 端接类型:SMD/SMT 引线间隔: 尺寸:18.5 mm W x 20.5 mm L x 3 mm H |
| BZ019B223ZAB | 功能描述:超级电容/超级电容器 9v 22mF Tol. -20/+80% RoHS:否 制造商:Murata 电容:350 mF 容差: 电压额定值:4.2 V ESR:60 mOhms 工作温度范围:- 30 C to + 70 C 端接类型:SMD/SMT 引线间隔: 尺寸:18.5 mm W x 20.5 mm L x 3 mm H |
| BZ019B223ZHB | 功能描述:超级电容/超级电容器 9v 22mF Tol. -20/+80% RoHS:否 制造商:Murata 电容:350 mF 容差: 电压额定值:4.2 V ESR:60 mOhms 工作温度范围:- 30 C to + 70 C 端接类型:SMD/SMT 引线间隔: 尺寸:18.5 mm W x 20.5 mm L x 3 mm H |
| BZ019B223ZSB | 功能描述:超级电容/超级电容器 9v 22mF Tol. -20/+80% RoHS:否 制造商:Murata 电容:350 mF 容差: 电压额定值:4.2 V ESR:60 mOhms 工作温度范围:- 30 C to + 70 C 端接类型:SMD/SMT 引线间隔: 尺寸:18.5 mm W x 20.5 mm L x 3 mm H |
| BZ019B223ZSBAJ | 功能描述:超级电容/超级电容器 9volts 0.02F 80 -20% RoHS:否 制造商:Murata 电容:350 mF 容差: 电压额定值:4.2 V ESR:60 mOhms 工作温度范围:- 30 C to + 70 C 端接类型:SMD/SMT 引线间隔: 尺寸:18.5 mm W x 20.5 mm L x 3 mm H |
发布紧急采购，3分钟左右您将得到回复。