- 您现在的位置：买卖IC网 > PDF目录378429 > C164CI-8E (SIEMENS AG) 16-bit microcontrollers(16位微控制器) PDF资料下载
参数资料
| 型号： | C164CI-8E |
| 厂商： | SIEMENS AG |
| 英文描述： | 16-bit microcontrollers(16位微控制器) |
| 中文描述： | 16位微控制器（16位微控制器） |
| 文件页数： | 7/10页 |
| 文件大小： | 35K |
| 代理商： | C164CI-8E |
Semiconductor Group
7 of 10
AP1639 02.99
C164 OTP Memory Programming
All software including the programming data is downloaded from a host PC into the internal RAM of
the microcontroller. The application expects only internal RAM, external RAM is not required.
For OTP programming an additional programming voltage (e.g. 11,5 V) has to be applied to pin EA/
Vpp. Please check for the right Vpp value in the data sheet.
In order to download the application from a PC, a serial link has to be established. The C164CI
already provides an asynchronous serial interface that only has to be connected to COM1 or COM2
of your PC. Supposing you are using a Phytec C164CI starter kit, you can directly connect its serial
connector with the COM1/ COM2 interface of your PC.
Note:
For getting started two steps are needed:
1.) Activate bootstrap loader mode and enter CPU host mode (these modes are activated with port
pins P0L.2 and P0L.4 “LOW” during reset; simple 8.2k pull down resistors are applicable)
2.) Connect the target with the C164CI device to a host PC with a serial cable.
4.1
Special Memtool Options
For default Memtool expects serial communication via RS232. Some drivers also support single-
wire transmission (K-Line). All drivers which support K-Line protocol are marked with “KL” (see box
“Target”/ “Change”/ “Select Controller Type”). Select the desired mode (RS232 or K-Line) in box
“Interface” / “Setup Interface”.
In some cases it is also useful to get a LOG-file of the transmitted data. For LOG-file generation
switch “DIAGLOG” in the Memtool configuration file (memtool.ini/ siemtool.ini) has to be set to “1”.
The LOG-file will be closed by leaving Memtool. A set box for the LOG switch is currently not
implemented.
5
Pits, Traps and Mines
To prevent the controller from beeing damaged, generally main power must be connected
before
and disconnected
after
Vpp. Also the microcontroller has to be in a programming mode (CHM or
EHM) when applying Vpp. In case of in-system programming via Memtool the controller must be in
CHM programming mode.
The data transmission speed via K-line (single-wire) can be increased, when the FIFO of the used
communication port (COM1, COM2) of the PC is
deactivated
.
The C164CI enters bootstrap mode if pin P0L.4 is sampled low at the end of a hardware reset. In
this case the BSL is activated, independent of the selected bus mode; no evaluation of pin EA
(external access) in bootstrap loader mode.
In CPU host mode (CHM) the default setting of bit BUSACT0 in register BUSCON0 is “1”, which
means: external bus
enabled
. In single-chip applications this might could lead to problems with
external peripherals, because accesses to the OTP programming interface (respectively to the
registers OPAD, OPDAT, OPCTRL) can be seen
externally
. In this case it is necessary to reset bit
BUSACT0
before
performing the first OTP programming interface access. The default setting of
相关PDF资料 |
PDF描述 |
|---|---|
| C164CI | 16-bit CMOS Single-Chip Microcontroller |
| C164CL | 16-Bit Single-Chip Microcontroller |
| C164SI | 16-Bit Single-Chip Microcontroller |
| C164SL | 16-Bit Single-Chip Microcontroller |
| C164CM | 16-Bit Single-Chip Microcontrol ler |
相关代理商/技术参数 |
参数描述 |
|---|---|
| C164CI8E25MDBFXQMA1 | 功能描述:C166 C16xx Microcontroller IC 16-Bit 25MHz 64KB (64K x 8) OTP PG-MQFP-80 制造商:infineon technologies 系列:C16xx 包装:托盘 零件状态:在售 核心处理器:C166 核心尺寸:16-位 速度:25MHz 连接性:CAN，EBI/EMI，SPI，SSC，UART/USART 外设:POR，PWM，WDT I/O 数:59 程序存储容量:64KB（64K x 8） 程序存储器类型:OTP EEPROM 容量:- RAM 容量:4K x 8 电压 - 电源（Vcc/Vdd）:4.75 V ~ 5.5 V 数据转换器:A/D 8x10b 振荡器类型:外部 工作温度:-40°C ~ 85°C（TA） 封装/外壳:80-QFP 供应商器件封装:PG-MQFP-80 标准包装:504 |
| C164CI8E25MDBFXUMA1 | 制造商:Infineon Technologies AG 功能描述:MCU 16-bit C166 CISC/RISC 64KB EPROM 5V 80-Pin MQFP 制造商:Infineon Technologies AG 功能描述:16 BIT OTP - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC MCU 16BIT 64KB OTP MQFP-80-1 |
| C164CI8E25MDBKXQMA1 | 制造商:Infineon Technologies AG 功能描述:MCU 16-bit C166 CISC/RISC 64KB EPROM 5V 80-Pin MQFP 制造商:Infineon Technologies AG 功能描述:16 BIT OTP - Trays 制造商:Infineon Technologies AG 功能描述:IC MCU 16BIT 64KB OTP MQFP-80-1 |
| C164CI8E25MDBKXUMA1 | 功能描述:IC MCU 16BIT 64KB OTP 80MQFP 制造商:infineon technologies 系列:C16xx 包装:带卷（TR） 零件状态:最後搶購 核心处理器:C166 核心尺寸:16-位 速度:25MHz 连接性:CAN，EBI/EMI，SPI，SSC，UART/USART 外设:POR，PWM，WDT I/O 数:59 程序存储容量:64KB（64K x 8） 程序存储器类型:OTP EEPROM 容量:- RAM 容量:4K x 8 电压 - 电源（Vcc/Vdd）:4.75 V ~ 5.5 V 数据转换器:A/D 8x10b 振荡器类型:外部 工作温度:-40°C ~ 125°C（TA） 封装/外壳:80-QFP 供应商器件封装:PG-MQFP-80-7 标准包装:850 |
| C164CI8E28MDBFXUMA1 | 制造商:Infineon Technologies AG 功能描述:MCU 16-BIT C166 CISC/RISC 64KB EPROM 5V 80-PIN MQFP 制造商:Infineon Technologies AG 功能描述:16 BIT OTP - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC MCU 16BIT OTP MQFP-80-1 |
发布紧急采购，3分钟左右您将得到回复。