- 您现在的位置：买卖IC网 > PDF目录298900 > CAT22C12PI-20 NVRAM (EEPROM Based) PDF资料下载
参数资料
| 型号： | CAT22C12PI-20 |
| 英文描述： | NVRAM (EEPROM Based) |
| 中文描述： | NVRAM中（EEPROM的基础） |
| 文件页数： | 9/10页 |
| 文件大小： | 107K |
| 代理商： | CAT22C12PI-20 |
CAT22C10
8
Doc. No. 25018-0A 2/98 N-1
Recall
At anytime, except during a store operation, taking the
RECALL pin low will initiate a recall operation. This is
independent of the state of
CS, WE, or A0–A5. After the
RECALL pin has been held low for the duration of the
Recall Pulse Width (tRCP), the recall will continue inde-
pendent of any other inputs. During the recall, the entire
contents of the E2PROM array is transferred to the Static
RAM array. The first byte of data may be externally
accessed after the recalled data access time from end of
recall (tARC) is met. After this, any other byte may be
accessed by using the normal read mode.
If the
RECALL pin is held low for the entire Recall Cycle
time (tRCC), the contents of the Static RAM may be
immediately accessed by using the normal read mode.
A recall operation can be performed an unlimited num-
ber of times without affecting the integrity of the data.
The outputs I/O0–I/O3 will go into the high impedance
state as long as the
RECALL signal is held low.
Store
At any time, except during a recall operation, taking the
STORE pin low will initiate a store operation. This takes
place independent of the state of
CS, WE or A0–A5. The
STORE pin must be held low for the duration of the Store
Pulse Width (tSTP) to ensure that a store operation is
initiated. Once initiated, the
STORE pin becomes a
“Don’t Care”, and the store operation will complete its
transfer of the entire contents of the Static RAM array
into the E2PROM array within the Store Cycle time
(tSTC). If a store operation is initiated during a write cycle,
the contents of the addressed Static RAM byte and its
corresponding byte in the E2PROM array will be un-
known.
During the store operation, the outputs are in a high
impedance state. A minimum of 100,000 store opera-
tions can be performed reliably and the data written into
the E2PROM array has a minimum data retention time
of 10 years.
DATA PROTECTION DURING POWER-UP AND
POWER-DOWN
The CAT22C10 has on-chip circuitry which will prevent
a store operation from occurring when VCC falls below
3.0V typ. This function eliminates the potential hazard of
spurious signals initiating a store operation when the
system power is below 3.0V typ.
Figure 4. Recall Cycle Timing
5153 FHD F08
5153 FHD F07
Figure 5. Store Cycle Timing
CS
DATA I/O
RECALL
ADDRESS
DATA UNDEFINED
DATA VALID
HIGH-Z
tRCZ
tORC
tARC
tRCP
tRCC
STORE
DATA I/O
tSTZ
tOST
HIGH-Z
tSTP
tSTC
This Material Copyrighted by Its Respective Manufacturer
相关PDF资料 |
PDF描述 |
|---|---|
| CAT22C12PI-30 | NVRAM (EEPROM Based) |
| CAT24AA01WI-T3 | 128 X 8 I2C/2-WIRE SERIAL EEPROM, PDSO8 |
| CAT24C01BGZE-1.8TE13REV-A | 128 X 8 I2C/2-WIRE SERIAL EEPROM, PDSO8 |
| CAT24C01BJE-1.8TE13REV-A | 128 X 8 I2C/2-WIRE SERIAL EEPROM, PDSO8 |
| CAT24C01BWE-TE13REV-A | 128 X 8 I2C/2-WIRE SERIAL EEPROM, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CAT22C12PI-30 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:NVRAM (EEPROM Based) |
| CAT22SM | 制造商:Nagahori Industry 功能描述:CAT22SM |
| CAT2300 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:SENSEFET Current Monitor SENSEFET Current Monitor TDFNa??8 |
| CAT2300VP2-GT3 | 功能描述:监控电路 SENSE FET CONTROLLER RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟（典型值）:10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel |
| CAT23SM | 制造商:Nagahori Industry 功能描述:CAT23SM |
发布紧急采购，3分钟左右您将得到回复。