- 您现在的位置：买卖IC网 > PDF目录20815 > CAT37TDI-GT3 (ON Semiconductor)IC BOOST CONV DC/DC TSOT23-5 PDF资料下载
参数资料
| 型号： | CAT37TDI-GT3 |
| 厂商： | ON Semiconductor |
| 文件页数： | 8/11页 |
| 文件大小： | 0K |
| 描述： | IC BOOST CONV DC/DC TSOT23-5 |
| 标准包装： | 3,000 |
| 拓扑： | PWM，升压（升压） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 800kHz ~ 1.6MHz |
| 电源电压： | 2.5 V ~ 7 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-5 细型，TSOT-23-5 |
| 供应商设备封装： | TSOT-23-5 |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
CAT37
R1 +
LED Dimming with DC Signal
Dimming the LEDs can be done by applying a variable
DC voltage as shown on Figure 14. As the V DC increase the
voltage across R1 decreases and therefore lower the LED
current. The resistors R2 and R3 must be large enough so
that their current (tens of m A) is much smaller than the LED
current but much larger than the FB leakage current (I FB ).
When adjusting V DC between 0 V and 2 V, the resistors
shown on Figure 14 will set the LED current between 0 mA
and 15 mA.
LED Dimming with a Logic Signal
For applications that need to adjust the LED brightness in
discrete steps, a logic signal can be used as shown in
Figure 16. R1 sets the minimum LED current value (when
the NMOS switch is OFF):
0.095 V
I LED(MIN)
R INCR determines how much LED current increases when
the external NMOS switch is turned ON.
LED Dimming with PWM Signal
PWM brightness control provides the widest dimming
R INCR +
0.095 V
I LED(INCREASE)
range (greater than 20:1). By turning the LEDs ON and OFF
using the control signal, the LEDs operate at either zero or
full current, but their average current changes with the PWM
signal duty cycle. Typically, a 5 kHz to 40 kHz PWM signal
is used.
A filtered PWM signal is used to dim the LEDs, as shown
in Figure 15.
In addition to providing the widest dimming range, PWM
brightness control also ensures the “purest” white LED color
over the entire dimming range. The true color of a white
LED changes with operating current, and is the “purest”
white at a specific forward current, usually 15 mA or
20 mA. If the LED current is less than or more than this
value, the emitted light becomes more blue. Applications
involving color LCDs can find the blue tint objectionable.
PCB Layout Guidelines
The CAT37 is a high ? frequency switching regulator
where proper PCB board layout and component placement
can minimize noise and radiation and increase efficiency. To
maximize efficiency, the CAT37 design has fast switch rise
and fall times. To prevent radiation and high frequency
resonance problems minimize the length and area of all
traces connected to the SW pin and use a ground plane under
the switching regulator.
The SW pin, schottky diode and capacitor C2 signal path
should be kept as short as possible. The ground connection
for the R1 resistor should be tied directly to the GND pin and
not be shared with other components.
CAT37
FB
CAT37
FB
CAT37
FB
V DC
R3
180 k W
R2
10 k W
R1
6.3 W
PWM
10 k W
R3
180 k W
0.1 m F
R2
10 k W
R1
6.3 W
Logic
Signal
R INCR
2N7002
R1
6.3 W
Figure 14. Dimming with a
DC Voltage
Figure 15. Dimming with a
Filtered PWM Signal
http://onsemi.com
8
Figure 16. Dimming with a
Logic Signal
相关PDF资料 |
PDF描述 |
|---|---|
| REC5-2415DRWZ/H6/A/M/CTRL | CONV DC/DC 5W 9-36VIN +/-15VOUT |
| REC3-2405DRWZ/H2/A/M/SMD-R | CONV DC/DC 3W 9-36VIN +/-05VOUT |
| P51-50-S-AA-P-4.5OVP-000-000 | SENSOR 50PSI 7/16-20 UNF .5-4.5V |
| P51-15-S-UCA-P-4.5OVP-000-000 | SENSOR 15PSI 7/16-20 UNF .5-4.5V |
| NPS 2-T126 750.000 OHM 1% | RES 750 OHM 25W 1% DPAK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CAT37TDI-T2 | 功能描述:IC LED DRVR WHITE BCKLGHT TSOT-5 RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:1 系列:- 恒定电流:- 恒定电压:- 拓扑:PWM，切换式电容器（充电泵） 输出数:1 内部驱动器:是 类型 - 主要:背光 类型 - 次要:白色 LED 频率:642kHz 电源电压:2.7 V ~ 5.5 V 输出电压:5V 安装类型:表面贴装 封装/外壳:10-VFDFN 裸露焊盘 供应商设备封装:10-VSON 包装:剪切带 (CT) 工作温度:-30°C ~ 85°C 产品目录页面:1371 (CN2011-ZH PDF) 其它名称:BD1603NUV-E2CT |
| CAT37TDI-T3 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:CMOS White LED Driver Boost Converter |
| CAT37TDI-TE7 | 功能描述:LED照明驱动器 White LED Boost RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| CAT-38-PP | 功能描述:INSTALL TOOL ORANGE FOR SHR SER RoHS:是 类别:工具 >> 螺线形绕线，伸缩套管 系列:- 标准包装:1 系列:Slit-N-Wrap® |
| CAT-38-PP-BU | 功能描述:INSTALL TOOL ORANGE FOR SHR SER RoHS:是 类别:工具 >> 螺线形绕线，伸缩套管 系列:- 标准包装:1 系列:Slit-N-Wrap® |
发布紧急采购，3分钟左右您将得到回复。