- 您现在的位置：买卖IC网 > Datasheet目录318 > CAT4104V-GT3 (ON Semiconductor)IC LED DVR 4CH 175MA 8SOIC Datasheet资料下载
参数资料
| 型号： | CAT4104V-GT3 |
| 厂商： | ON Semiconductor |
| 文件页数： | 9/13页 |
| 文件大小： | 0K |
| 描述： | IC LED DVR 4CH 175MA 8SOIC |
| 标准包装： | 3,000 |
| 恒定电流： | 是 |
| 拓扑： | PWM |
| 输出数： | 4 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 汽车，背光，通用型 |
| 类型 - 次要： | 高亮度 LED（HBLED） |
| 电源电压： | 3 V ~ 5.5 V |
| 输出电压： | 25V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 带卷 (TR) |
| 工作温度： | -40°C ~ 85°C |
| 其它名称： | CAT4104V-GT3-ND CAT4104V-GT3OSTR |
CAT4104
Application Information
1 m F 5 k W
R1
C1
0.1 m F
LED3
OFF ON
R4
Single 12 V Supply
The circuit shown in Figure 20 shows how to power the
LEDs from a single 12 V supply using the CAT4104. Three
external components are needed to create a lower voltage
necessary for the VIN pin (below 5.5 V). The resistor R2 and
zener diode Z provide a regulated voltage while the
quiescent current runs through the N ? Channel transistor M.
The recommended parts are ON Semiconductor MM3Z6V2
zener diode (in SOD ? 323 package), and 2N7002L
N ? Channel transistor (in SOT23).
12 V
C2 R2
M
Z
6.2 V
VIN LED1
C1 CAT4104
0.1 m F LED2
EN/PWM
LED3
RSET LED4
GND
Figure 20. Single Supply Driving 12 LEDs
Daylight Detection
The circuit in Figure 21 shows how to use CAT4104 in an
automatic light sensor application. The light sensor allows
the CAT4104 to be enabled during the day and disabled
during the night. Two external components are required to
configure the part for ambient light detection and conserve
power. Resistor R1 sets the bias for the light sensor. The
recommended part is Microsemi LX1972 light sensor. For
best performance, the LED light should not interfere with
the light sensor.
5V
Nightlight Detection
The circuit shown in Figure 22 illustrates how to use the
CAT4104 in an automatic night light application. The light
sensor allows the CAT4104 to be disabled during the day and
enabled during the night. Five external components are
needed to properly configure the part for night detection.
Resistor R3 limits the quiescent current through the
N ? Channel transistor M. Resistors R1 and R2 act as a
voltage divider to create the required voltage to turn on
transistor M, which disables the CAT4104. The
recommended parts are ON Semiconductor 2N7002L
N ? Channel transistor (in SOT23) and the Microsemi
LX1972 light sensor. For best performance, the LED light
should not interfere with the light sensor.
5V
C2 R1
1 m F 100 k W
R3
VDD 100 k W VIN LED1
Light CAT4104
Sensor LED2
VSS
EN/PWM
M RSET LED4
R2 GND
1 M W
Figure 22. Nightlight Detection
LED Current Derating
The circuit shown in Figure 23 provides LED temperature
derating to avoid over ? driving the LED under high ambient
temperatures, by reducing the LED current to protect the
LED from over ? heating. The positive thermo coefficient
(PTC) thermistor RPTC is used for temperature sensing and
should be located near the LED. As the temperature of
RPTC increases, the gate voltage of the MOSFET M1
C2
1 m F
R1
100 k W
decreases. This causes the transistor M1 on ? resistance to
increase which results in a reduction of the LED current. The
circuit is powered from a single VCC voltage of 5 V. The
VDD
Light
Sensor
VSS
C1
0.1 m F
OFF ON
R1
VIN LED1
CAT4104
LED2
LED3
EN/PWM
RSET LED4
GND
recommended parts are Vishay 70 ° C thermistor
PTCSS12T071DTE and ON Semiconductor 2N7002L
N ? Channel transistor (in SOT23).
The PCB and heatsink for the LED should be designed
such that the LED current is constant within the normal
temperature range. But as soon as the ambient temperature
exceeds a max threshold, the LED current drops to protect
the LEDs from overheating.
Figure 21. Daylight Detection
http://onsemi.com
9
相关PDF资料 |
PDF描述 |
|---|---|
| CAT4106YP-T2 | IC LED DVR 4CH BOOST 16TSSOP |
| CAT4109V-GT2 | IC LED DRIVER RGB 16-SOIC |
| CAT4134HV2-T2 | IC LED DRVR BKLGHT FLASH 12-TDFN |
| CAT4137TD-T3 | IC LED DRVR WHITE BCKLGHT TSOT-5 |
| CAT4139TD-GT3 | IC LED DRVR WHITE BCKLGT TSOT-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CAT4104VP2-GT3 | 功能描述:LED照明驱动器 LED Driver 32 LED Series/Parallel RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| CAT4106 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:6 W Quad Channel DC/DC LED Driver with Diagnostics |
| CAT4106AEVB | 功能描述:BOARD EVALUATION DPP CAT4106A RoHS:是 类别:编程器，开发系统 >> 评估板 - LED 驱动器 系列:* 标准包装:1 系列:PowerWise® 电流 - 输出 / 通道:20mA 输出及类型:1，非隔离 输出电压:17V 特点:可调光 输入电压:2.7 ~ 5.5 V 已供物品:板 已用 IC / 零件:LM3508 相关产品:LM3508TLX-ND - IC LED DRVR WHT BCKLGT 9USMDLM3508TLDKR-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLCT-ND - IC LED DRVR WHT BCKLGT 9MICROSMDLM3508TLTR-ND - IC LED DRVR WHT BCKLGT 9MICROSMD |
| CAT4106AGEVB | 制造商:ON Semiconductor 功能描述:EVAL BOARD - Bulk |
| CAT4106HV4-G | 功能描述:LED照明驱动器 6W Quad-Ch DC/DC LED Driver w/Diag. RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
发布紧急采购，3分钟左右您将得到回复。