- 您现在的位置：买卖IC网 > PDF目录20595 > CHIPPROG-ISP (Phyton Inc)PROGRAMMER IN-SYSTEM UNIVERSAL PDF资料下载
参数资料
| 型号： | CHIPPROG-ISP |
| 厂商： | Phyton Inc |
| 文件页数： | 89/182页 |
| 文件大小： | 0K |
| 描述： | PROGRAMMER IN-SYSTEM UNIVERSAL |
| 产品目录绘图： | CHIPPROG-ISP |
| 标准包装： | 1 |
| 类型： | 系统内编程器 |
| 适用于相关产品： | EEPROM，FLASH，MCU |
| 所含物品： | 编程器，线缆，CD |
| 产品目录页面： | 598 (CN2011-ZH PDF) |
| 相关产品： | AS-ISP-ST7-ND - ISP CABLE ADAPTER 14-PIN HEADER AS-ISP-NEC-ND - ISP CABLE ADAPTER 16-PIN HEADER AS-ISP-MSP430-ND - UNIVERSAL ISP CABLE-ADAPTER AS-ISP-CABLE-ND - CABLE STD ISP CHIP PROG ISP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页当前第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页第154页第155页第156页第157页第158页第159页第160页第161页第162页第163页第164页第165页第166页第167页第168页第169页第170页第171页第172页第173页第174页第175页第176页第177页第178页第179页第180页第181页第182页
Operating with Programmers
Read also about bad blocks in the NAND Flash memory devices.
89
5.4.1.1
Invalid blocks
NAND Flash memory devices have invalid memory blocks that cannot be used for storing data because
some memory cells inside of the device have physical defects - either inherent in a process of the device
manufacturing or acquired in a process of the device exploitation and reprogramming in the user's
equipment. Since a percentage of invalid blocks is pretty small inside of the chip (usually less than 1%)
it is possible to use the device for data storing. In order to use NAND devices with bad blocks these
blocks should be marked in a certain way to prevent fetching data from these blocks or writing in it. This
document equally uses both known terms for such blocks: invalid and bad.
Locations of the invalid blocks or the invalid blocks map should be accessible by the application for
skipping the bad blocks or handling them in other way. To keep the invalid block map every NAND Flash
device has a special cell array, known as the for storing addresses of invalid blocks. See the Spare
Area location in the NAND Flash memory architecture
The Spare Area in "small page" 8-bit devices is 16 large, 16-bit devices - 8 Words. The Spare Area in
"large page" devices - 64 Bytes and 32 Words respectfully. Though the Spare Area is dedicated for
marking bad blocks it can be also used as a general purpose memory for storing the user's data. To
avoid accidental losing of the bad block map it is recommended to assign a whole entire Spare Area for
storing the invalid block map and do not write in this area anything else.
5.4.1.1.1 Managing invalid blocks
There are three mostly used methods of handling invalid memory blocks:
Skip Block method
Error Checking and Correction
The ChipProg programmers support all the methods above.
5.4.1.1.1.1 Skipping invalid blocks
This is the simplest method of managing invalid blocks. The programming algorithm first reads the entire
Spare Area to collect the addresses of invalid memory blocks. Then, the programming equipment
writes data to the device page by page with checking the block addresses. If the current block's number
is marked as bad the programmer skips this block and write into the next valid one.
5.4.1.1.1.2 Reserved Block Area
This method is based on the idea of replacing invalid blocks with good blocks by re-directing reading
and writing operations to these good blocks. To implement this method the programming equipment
splits the entire memory in three areas following each other from the start address of the memory
device. Each of these areas may include both good and bad blocks:
User Block Area (UBA) - a linear memory array for storing the user's data;
? 2010 Phyton, Inc. Microsystems and Development Tools
相关PDF资料 |
PDF描述 |
|---|---|
| R1D-3.312/HP | CONV DC/DC 1W 3.3VIN +/-12VOUT |
| VE-B0L-CY-B1 | CONVERTER MOD DC/DC 28V 50W |
| VE-B0J-CY-B1 | CONVERTER MOD DC/DC 36V 50W |
| FEPB6CTHE3/81 | DIODE 6A 150V 35NS DUAL TO263AB |
| GEC26DRTH | CONN EDGECARD 52POS DIP .100 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CHIPPROG-ISP2 | |
| CHIPS CAPACITOR 0.015UF 50V CERAMIC | 制造商:AVX Corporation 功能描述:CHIPS CAPACITOR 0.015UF50VCERAMIC*NIC* |
| CHIPS-IN-DIPS | 制造商:未知厂家 制造商全称:未知厂家 功能描述:ASIC |
| CHIPT1593CSE6327X1SA1 | 制造商:Infineon Technologies AG 功能描述:RF SILICON MMIC - Gel-pak, waffle pack, wafer, diced wafer on film |
| CHIPV6 | 制造商:JDSU 制造商全称:JDS Uniphase Corporation 功能描述:The industrya??s most compact 100 G test solution |
发布紧急采购，3分钟左右您将得到回复。