参数资料
型号: CKSR 15-NP
厂商: LEM USA Inc
文件页数: 12/18页
文件大小: 0K
描述: SENSOR CURRENT 15A 5V MOD
产品培训模块: CAS Modules Overview
产品目录绘图: CKSR Series Side
标准包装: 50
系列: CKSR
电流 - 感应: 15A
精确度: ±0.8%
灵敏度: 41.67mV/A
传感器类型: 磁通量闸门
电源电压: 4.75 V ~ 5.25 V
输出: 0 ~ 5 VDC
频率: 300kHz
响应时间: 300ns
电极标记: 双向
工作温度: -40°C ~ 105°C
封装/外壳: 模块
包装: 管件
产品目录页面: 2809 (CN2011-ZH PDF)
其它名称: 398-1096-5
Performance parameters definition
Ampere-turns and amperes
The transducer is sensitive to the primary current linkage
Q P (also called ampere-turns).
Q P = N P I P (At)
Where N P is the number of primary turn (1, 2 , 3
or 4 depending on the connection of the primary
jumpers)
Caution: As most applications will use the transducer with
only one single primary turn ( N P = 1), much of this datasheet
is written in terms of primary current instead of current
linkages. However, the ampere-turns (A-t) unit is used to
emphasis that current linkages are intended and applicable.
Transducer simplified model
The static model of the transducer at temperature T A is:
V OUT = G Q P + error
Sensitivity and linearity
To measure sensitivity and linearity, the primary current (DC)
is cycled from 0 to I P , then to - I P and back to 0 (equally spaced
I P /10 steps).
The sensitivity G is defined as the slope of the linear regres-
sion line for a cycle between ± I PN .
The linearity error ε L is the maximum positive or negative
difference between the measured points and the linear
regression line, expressed in % of I PN .
Magnetic offset
The magnetic offset current I OM is the consequence of a cur-
rent on the primary side (“memory effect” of the transducer ’s
ferro-magnetic parts). It is included in the linearity figure but
can be measured individually.
It is measured using the following primary current cycle.
I OM depends on the current value I P1 .
In which error =
V OE + V OT ( T A ) + ε G · Q P · G + ε L ( Q Pmax )· Q Pmax · G + TCG ·( T A -25)· Q P · G
I
OM
=
V OUT ( t 1 ) ? V OUT ( t 2 )
2
?
1
Gth
Ip( t
t 1
t
Ip(3)
With:
Q P = N P I P
Q P max
V OUT
T A
V OE
V OT ( T A )
G
ε G
ε L ( Q Pmax )
:the input ampere-turns (At)
Please read above warning.
:the maxi input ampere-turns that have
been applied to the transducer (At)
:the secondary voltage (V)
:the ambient temperature (°C)
:the electrical offset voltage (V)
:the temperature variation of V O at
temperature T A ( V )
:the sensitivity of the transducer (V/At)
:the sensitivity error
:the linearity error for Q Pmax
I P (DC)
I P1
t 2
0A
3)
- I P1
Figure 30: Current cycle used to measure magnetic and
electrical offset (transducer supplied)
This model is valid for primary ampere-turns Q P between
- Q Pmax and + Q Pmax only.
Min., Max., Typ. definition
Some parameters have a statistically normal distribution. The
typical value published in the LEM datasheet is the mean or
average value of the distribution. The typical value listed is the
1 sigma value. This means that in 68 % of the devices tested,
the parameters is found to be ± the typical value or better. LEM
currently uses ± 3 sigma (99.73 %) to define minimum and
maximum values. Usually, typical values are set when the part
is characterized and never changes.
Page 12/18
12October2012/version 8
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice
www.lem.com
相关PDF资料
PDF描述
CL-827-S95-XT CHROMALIT LT SOURCE SQUARE
CLS15-22C/L213G/TR8 IR COLOR SENSOR RGB
CM1982SP T-3 BAYONET BASE HALOGEN LAMP
CMA3000-A01 ACCELEROMETER 3-AXIS ANALOG OUT
CMD-HHTX-433 XMITTER HANDHELD 433MHZ 8 BUTTON
相关代理商/技术参数
参数描述
CKSR15-NP 制造商:LEM Holdings SSA 功能描述:Current Transducer 15A, Low Drift +5V Vs
CKSR25-NP 制造商:LEM Holdings SSA 功能描述:Current Transducer 25A, Low Drift +5V Vs
CKSR50-NP 制造商:LEM Holdings SSA 功能描述:Current Transducer 50A, Low Drift +5V Vs
CKSR6-NP 制造商:LEM Holdings SSA 功能描述:Current Transducer 6A, Low Drift +5V Vs
CKSSD 制造商:Hubbell Wiring Device-Kellems 功能描述:CAB, ACCESS,SERVR,STATIONARY SHELF,1U