Notice) Specifications are subject to change for improvement advance without notice.
Company Confidential
Ref.CE
Ref.CE--P160 05/07
P160 05/07
Precautions
(1) Avoid any stress added to the lens portion.
(2) Avoid any friction by sharp metal nail etc. to the lens portion.the lens portion
(3) In case of fixing a product,fix two places of right and left with a M3 screw well At the time ofscrew
clamping, please be careful not to hang stress to a product.
< Recommended screw pace >
(4) In case of fixing a product, apply radiation of heat grease to the product back side whole, and please
install it to be able to radiate heat in the whole product.
In case that used seat-shaped radiation of heat materials, a product may turn at the time of screw
clamping.Therefore I recommend paste-shaped grease.
(5) Please take a wristband and an anti-static electricity measure such as gloves at the time of the
handling.
(6) In addition, there are by anode, cathode each electrode pat two places to a product Have you can
adapt yourself to a use state and use both electrode pat and increase.
(7) A circuit drive method recommends Sadamu electric current circuit. Also avoid reverse voltage (over-
current) applied instantaneously when ON or OFF.
(8) Extra care must be taken when assembling the circuit board into the finished product, avoiding the
component parts from touching other parts.
(9) Care in the connector handing.Hold on to electric wire of a socket connector (collectively) and pull
straight up* see figure 1. (Only CL-L100 Series)
(10) Method of joining LED.Specified wire harnesses is used below.
Manufacturer:J.S.T.MFG.Co,.Ltd.
Product No.:BM03B-ACHSS-GAN-TF (Only CL-L100 Series)
The lens portion
figure 1