Ref; CE-P252 03/08
Specification sheet
9/10
8. Precautions
(1) Avoid the application of any stress to the lens portion.
(2) Avoid any contact by a sharp metal nail or other materials with the lens portion.
(3) This product should be secured firmly by fastening an M3 screw on both sides of the product.
Please be careful not to apply any stress to the product during the clamping operation.
As the connection status could vary depending on materials of outer heat sink,
Please check thoroughly.
< Recommended installation screw pitch: 46.5 mm >
(4) A heat radiating grease should be applied to the whole rear surface so that this product can dissipate
heat as a whole. This product could be bent during the clamping operation if heat grease in sheet form
is used. For this reason, it is recommended that grease in paste form is used.
(5) Handling of static electricity
-
Please take measures to prevent any static electricity being produced such as the wearing of a
wristband or anti-static gloves when handling this product.
-
As for damages due to static electricity, please check them by lighting inspection.
CE’s lighting inspection criterion
Condition
Judgmental criterion
IF =1mA or less
No-lighting should not exist
(6) Please be aware that this product should not come into contact with any other parts in assembled
status.
Dec. 17, 2007
Approved
Checked
Drawn
Symbol
Name
CL-L102-C7WW
Drawing
No.
Mark
Date
Description
CITIZEN ELECTRONICS CO.,LTD.
Lens portion (Shaded area)
46.5 mm
Thermal conductive silicone grease
Outer heat sink
Spring washer (=<Φ6mm)
M3 screw
Plane washer (=<Φ6mm)