- 您现在的位置：买卖IC网 > Datasheet目录855 > CMR05F101JODR (Cornell Dubilier Electronics (CDE))CAP MICA 100PF 500V 5% RADIAL Datasheet资料下载
参数资料
| 型号： | CMR05F101JODR |
| 厂商： | Cornell Dubilier Electronics (CDE) |
| 文件页数： | 4/6页 |
| 文件大小： | 0K |
| 描述： | CAP MICA 100PF 500V 5% RADIAL |
| 标准包装： | 1 |
| 系列： | CMR |
| 电容： | 100pF |
| 电压 - 额定： | 500V |
| 容差： | ±5% |
| 电介质材料： | 云母 |
| 安装类型： | 通孔 |
| 封装/外壳： | 径向 |
| 引线间隔： | 0.224"（5.70mm） |
| 工作温度： | -55°C ~ 125°C |
| 特点： | 通用 |
| 包装： | 散装 |
| 尺寸/尺寸： | 0.461" L x 0.181" W（11.70mm x 4.60mm） |
| 高度 - 座高（最大）： | 0.358"（9.10mm） |
Type CMR , High-Reliability, Mica Capacitors
Specifications
Capacitance is within tolerance when
measured at these frequencies:
1 - 1000 pF @ 1 MHz
> 1000 pF @ 1 Khz
Dissipation Factor limits are below.
Measure dissipation factor at 1 MHz
when the capacitance is 1 pF to 1000
pF, and at 1 kHz when the capacitance
is greater than 1000 pF. Dissipation
factor is equal to DF = 2 p fRC, where f
is the test frequency, R is the equivalent
series resistance, and C is the capaci-
tance. For other capacitance values,
see Figure 1.
Capacitance Dissipation Factor
100-1000 pF 0.00075 max at 1 MHz
1100-3300 pF 0.0014 max at 1 kHz
3600-9100 pF 0.0013 max at 1 kHz
10,000 pF 0.0012 max at 1 kHz
Quality Factor (Q) is the reciprocal of
dissipation factor.
Insulation Resistance for capacitanc-
es up to 10,000 pF is greater than 100
G. at 25 oC, greater then 10 G. at 125
oC, and greater than 5 G. at 150 oC. For
other capacitance values and tempera-
tures, see Figure 2.
Withstanding Voltage is two times
the rated voltage, and can be applied
up to 5 seconds without damage.
Temperature Coefficient and Capaci-
tance Drift measure the capacitors’
capacitance at 25 oC, -55 oC, 25 oC, 125 oC
(or 150 oC) and at 25 oC after stabilizing
at each temperature. The capaciance
will meet the limits of the Characteristic
table shown in Ordering Information.
Failure Rate: Type CMR capacitors have
specified failure rate levels ranging from
0.01% to 1.0% per 1000 hours. The fail-
ure rate level is established at 90% confi-
dence level and is referred to operation-
al life at full rated voltage at maximum
rated temperature.
High Voltage Stabilization: We sub-
ject capacitors with Failure Levels M, P,
and R to a burn-in at twice rated voltage,
at rated temperature, for a minimum of
48 hours. Capacitors that show dam-
age, arcing, breakdown, or low IR are
removed. We reject the lot if more then
8% of the capacitors fail.
Solderability: After an 8-hour steam
aging, coat leads with a rosin flux (R)
and immerse in molten 245 oC ±5 oC
60/40 tin/lead solder. Solder coverage
will be no less than 95% when examined
at 10X magnification.
Life Test: Subject the capacitors to
maximum operating temperature (+125
oC or +150 oC) with 1.5 times rated volt-
age applied for 10,000 hours. Take
readings and make visual observations
every 2000 hours.
There will be no visual damage and the
capacitors will meet the after-test limits
on the following page.
Resistance to Solvents: Subject the
capacitors to three cycles of 3 minute
immersion in solvent, 10 strokes with
bristle brush and, where applicable,
? minute in vapor, per MIL-STD-202,
Method 215. Repeat the three cycles for
three solvent mixtures: Isolpropyl alchol
mixture (Solvent 1), azeotrope mixture
(Solvent 3), and water/propylene-glycol
mixture (Solvent 4). The marking will
not rub off or smear and there will be no
visible damage to the capacitor body.
Refer to MIL-STD-202 for details.
Resistance to Soldering Heat: Capac-
itors will meet the requirements of MIL-
STD-202, Method 210 Test Condition G.
Immerse capacitor leads to within .250
inches (6.4 mm) of the body in molten
tin/lead solder (260 oC ±5 oC) for 10 ±2
seconds. Allow to cool. Capacitors will
meet the after-test limits on the follow-
ing page.
Marking of capacitors conforms to
method I of MIL-STD-1285, and includes
the type designation, “JAN,” brand,
trademark, source code, date code, rat-
ed voltage, capacitance, capacitance
tolerance, and the highest rated tem-
perature. Small capacitors are marked
with the letter “J”.
CDE Cornell Dubilier ? 1605 E. Rodney French Blvd. ? New Bedford, MA 02744 ? Ph: (508)996-8564 ? Fax: (508)996-3830 ? www.cde.com
相关PDF资料 |
PDF描述 |
|---|---|
| CR-1025/BN | BATTERY LITHIUM COIN 3V 10MM |
| CR-1220/HFN | BATTERY LITHIUM COIN 3V PC PINS |
| CR-123APA/1B | BATT 3V LITH CAMERA - RETAIL PKG |
| CR-1612/BN | BATTERY LITHIUM COIN 3V 16MM |
| CR-1616/F2N | BATTERY LITHIUM COIN 3V W/TAB |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CMR05F101JPDL | 制造商:CAP 功能描述:DM15X110J S7C6B |
| CMR05F101JPDM | 制造商:SEM 功能描述:DM15X110 SEMCO S7F8B 制造商:SEMCO 功能描述:CAPACITOR MILITARY MICA |
| CMR05F101JPDP | 功能描述:CMR MICA 制造商:cornell dubilier electronics (cde) 系列:* 零件状态:有效 标准包装:28 |
| CMR05F101JPDR | 制造商:JAN 功能描述:DM15X110 JAN SAN S7C6A |
| CMR05F111FODL | 制造商:Cornell Dubilier Electronics 功能描述:CAPACITOR MILITARY MICA |
发布紧急采购，3分钟左右您将得到回复。