- 您现在的位置：买卖IC网 > PDF目录211266 > CQ2660-9R 2-OUTPUT 106 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | CQ2660-9R |
| 元件分类： | 电源模块 |
| 英文描述： | 2-OUTPUT 106 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | METAL, CASE Q01, MODULE |
| 文件页数： | 4/25页 |
| 文件大小： | 747K |
| 代理商： | CQ2660-9R |
Cassette Style
DC-DC Converters
Q Series
Edition 5/5.2000
12/25
Output Voltage Regulation of Double Output Modules
In symmetrical configuration the main output 1 is under nor-
mal conditions regulated to
Uo nom, independent of the out-
put currents. Note that if the load on output 2 is too small
(
<0.1 I
o nom), its voltage will rise, possibly activating the
overvoltage protection, which will then reduce the voltage
on both outputs.
Uo2 is dependent upon the load distribution: If each output
is loaded with at least 10% of
Io nom, the deviation of Uo2 re-
mains within
±5% of the value of U
o nom. The following fig-
ures explain the regulation with varying load distributions
up to the current limit. If
Io1 = Io2 or the two outputs are in
series-connection, the deviation of
Uo2 remains within
±1%
of the value of
Uo nom provided that the load is at least Iomin.
Uo1 + 1.0 V
Uo1
Uo1 — 1.0 V
Io2 [A]
2
34
5
Uo2 max = 28 V
0
6
Uo2 [V]
Io1 = 4.0 A
Io1 = 3.1 A
Io1 = 2.2 A
Io1 = 1.3 A
Io1 = 0.44 A
1
05113
Fig. 13
BQ...GQ 2660 output 2 voltage deviation vs. output 2 cur-
rent with different currents on output 1
Uo1 + 0.5 V
Uo1
Uo1 – 0.5 V
2
46
8
Uo2 max = 14.2 V
0
Io2 [A]
Uo2 [V]
Io1 = 7.2 A
Io1 = 5.6 A
Io1 = 4.0 A
Io1 = 2.4 A
Io1 = 0.8 A
10
05111
Fig. 11
BQ...GQ 2320 output 2 voltage deviation vs. output 2 cur-
rent with different currents on output 1
Uo1 + 0.5 V
Uo1
Uo1 – 0.5 V
2
46
8
Uo2 max = 18 V
0
Io2 [A]
Uo2 [V]
Io1 = 6.0 A
Io1 = 4.6 A
Io1 = 3.3 A
Io1 = 2.0 A
Io1 = 0.66 A
05112
Fig. 12
BQ...GQ 2540 output 2 voltage deviation vs. output 2 cur-
rent with different currents on output 1
Output Voltage Overshoot Protection
Negligible output voltage overshoot may occur if the mod-
ule is either hot plugged-in or disconnected, the input volt-
age is switched on or off, the module is switched with an in-
hibit signal, or after a reset of a short circuit and power fail-
ure.
Second Control Loop
A fully independent second control loop limits the output
voltage to approximately 1.25
U o nom (e.g. sense lines wi-
red incorrectly). It further protects the load in the unlikely
event of a malfunction of the main control circuit.
In double output modules output 1 is fully regulated with
overvoltage protection on output 2, through this second
control loop.
There is no specific built-in protection against externally
applied overvoltages.
Continuous Open-Circuit and Short-Circuit Proof
All outputs are fully protected against continuous open cir-
cuit, e.g. against no load condition (for the BQ...GQ 2000
characteristics refer to:
Output Voltage Regulation of Dou-
ble Output Modules) and all outputs are fully protected
against continuous short circuit condition by means of the
electronic current limitation on the primary side (see:
Out-
put Current Limitation).
Output current limitation
Single output units and series- or parallel-connected dou-
ble output units have a quasi rectangular constant current
limitation characteristic.
In double output units, the total current is limited, allowing
free choice of load distribution between the two outputs, up
to a total
Io1 + Io2
≤ I
o max (see: Output Voltage Regulation of
Double Output Modules). In overload (Io1 + Io2
> I
o max) both
output voltages are reduced simultaneously.
Independent outputs with symmetrical current loads both
have a rectangular current limitation characteristic.
Current distribution in overload is dependent upon the type
of overload. A short-circuit in one output will cause the full
current flow into that output whereas a resistive overload
results in more even distribution and in a reduced output
voltage.
1.0
0.95
0.5
0
Uo/Uo nom
Io
Io nom
Io max
Operation
at
reduced
temperature
only
Io L
05114
Fig. 14
Current limitation behaviour of a single or a double output
unit with series- or parallel-connected outputs
相关PDF资料 |
PDF描述 |
|---|---|
| CBM-0515SFE | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| CAT1026LI-42-G | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDIP8 |
| CAT1026ZD4I-42-T2 | 2-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| CTDD2210SF-2409-D1.5K-2 | 2-OUTPUT 2 W DC-DC REG PWR SUPPLY MODULE |
| CAT1027JI-45TE13 | 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PDSO8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CQ2660-9RG | 功能描述:DC/DC CONVERTER 5.1A 制造商:bel power solutions 系列:Melcher Q 零件状态:在售 类型:封闭式，保形涂层 电压 - 输入（最小值）:33.6V 电压 - 输入（最大值）:75V 输出数:2 电压 - 输出 1:24V 电压 - 输出 2:24V 电压 - 输出 3:- 电压 - 输出 4:- 电流 - 输出（最大值）:5.5A，5.5A 功率（W）:132W 应用:ITE（商业），铁路 工作温度:-40°C ~ 71°C 效率:90% 安装类型:底座安装 大小/尺寸:6.46" 长 x 4.37" 宽 x 0.78" 高（164.0mm x 111.0mm x 19.8mm） 认可:cCSAus，CE，NEMKO 标准包装:5 |
| CQ291E | 制造商:Emulation Technology Inc 功能描述:FLUX REMOVER, SYRINGE; Cleaner Type:Flux Remover; Dispensing Method:Syringe; Series:ChipQuik; Volume:10cc; Leaded Process Compatible:No; Peak Reflow Compatible (260 C):No ;RoHS Compliant: No |
| CQ291ENL | 制造商:Emulation Technology Inc 功能描述:FLUX, SYRINGE, 10CC; Flux Type:No Clean; Series:ChipQuik; Flux Applications:Soldering; Dispensing Method:Syringe; Volume:10cc |
| CQ2A16-10DC | 制造商:SMC 功能描述:Compact air cylinder single rod |
| CQ2A20-25DC | 制造商:SMC 功能描述:Compact air cylinder single rod |
发布紧急采购，3分钟左右您将得到回复。