参数资料
型号: CS4352-DZZ
厂商: Cirrus Logic Inc
文件页数: 5/20页
文件大小: 0K
描述: IC DAC STER 102DB 192KHZ 20TSSOP
标准包装: 74
位数: 24
数据接口: 串行
转换器数目: 2
电压电源: 模拟和数字
功率耗散(最大): 158mW
工作温度: -40°C ~ 105°C
安装类型: 表面贴装
封装/外壳: 20-TSSOP(0.173",4.40mm 宽)
供应商设备封装: 20-TSSOP
包装: 托盘
输出数目和类型: 2 电压,单极
采样率(每秒): 192k
配用: 598-1518-ND - BOARD EVAL FOR CS4352 DAC
DS684F2
13
CS4352
4.4
De-Emphasis Control
The device includes on-chip digital de-emphasis. Figure 6 shows the de-emphasis curve for Fs equal to
44.1 kHz. The frequency response of the de-emphasis curve scales with changes in sample rate, Fs. The
De-emphasis error will increase for sample rates other than 44.1 kHz
When pulled to VL, the DEM pin activates the 44.1 kHz de-emphasis filter. When pulled to GND, the DEM
pin turns off the de-emphasis filter.
Note:
De-emphasis is only available in Single-Speed Mode.
4.5
Recommended Power-Up Sequence
1.
Hold RST low until the power supplies and configuration pins are stable, and the master and left/right
clocks are locked to the appropriate frequencies, as discussed in Section 4.2. In this state, VQ will re-
main low and VBIAS will be connected to VA.
2.
Bring RST high. The device will remain in a low power state with VQ low and will initiate the power-up
sequence after approximately 512 LRCK cycles in Single-Speed Mode (1024 LRCK cycles in Double-
Speed Mode, and 2048 LRCK cycles in Quad-Speed Mode).
4.6
Grounding and Power Supply Arrangements
As with any high-resolution converter, the CS4352 requires careful attention to power supply and grounding
arrangements if its potential performance is to be realized. Figure 2 shows the recommended power ar-
rangements, with VA_H, VA, VD, and VL connected to clean supplies. If the ground planes are split between
digital ground and analog ground, the GND pins of the CS4352 should be connected to the analog ground
plane.
All signals, especially clocks, should be kept away from the VBIAS and VQ pins in order to avoid unwanted
coupling into the DAC.
4.6.1
Capacitor Placement
Decoupling capacitors should be placed as close to the DAC as possible, with the low-value ceramic ca-
pacitor being the closest. To further minimize impedance, these capacitors should be located on the same
layer as the DAC. If desired, all supply pins may be connected to the same supply, but a decoupling ca-
pacitor should still be placed on each supply pin.
Note:
All decoupling capacitors should be referenced to analog ground.
The CDB4352 evaluation board demonstrates the optimum layout and power supply arrangements.
Gain
dB
-10dB
0dB
Frequency
T2 = 15 s
T1=50 s
F1
F2
3.183 kHz
10.61 kHz
Figure 6. De-Emphasis Curve
相关PDF资料
PDF描述
CS4354-CSZ IC DAC 24BIT SRL 14SOIC
CS4360-KZZ IC DAC STER 6CH 102DB 28TSSOP
CS4361-CZZR IC DAC STER 6CH 105DB 20-TSSOP
CS4362-KQZ IC DAC 6CH 114DB 192KHZ 48LQFP
CS4362A-DQZ IC DAC 6CH 114DB 192KHZ 48-LQFP
相关代理商/技术参数
参数描述
CS4352-DZZR 功能描述:数模转换器- DAC IC 102dB 192kHz Str DAC w/Line Drivr RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube
CS4353 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:3.3 V Stereo Audio DAC with 2 VRMS Line Output
CS4353_09 制造商:CIRRUS 制造商全称:Cirrus Logic 功能描述:3.3 V Stereo Audio DAC with 2 VRMS Line Output
CS4353-CNZ 功能描述:数模转换器- DAC IC 3.3V Str DAC w/2Vrms line output RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube
CS4353-CNZR 功能描述:数模转换器- DAC IC 3.3V Str DAC w/2Vrms line output RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube